Pop Screen is an interactive cell broadcast system use solely for marketing promotion in a non-intrusive way and it\'s an exclusive by product of Telkomsel Mobile Advertising. Pop Screen itself is a light weight application (~5kb) that has been injected into all Telkomsel RUIM/SIM card post May 2009 and since March 2010 has a total accumulative subscribers of 35million. Telkomsel Pop Screen requires no-keywords, no-shortcode (premium or otherwise) and no-url are needed to access any contents or advertisements contain therein. Basically Pop Screen is very easy to use and setup.
. Frequency range: DC to 6 GHz DC to 12 GHz. . Rate Power: 2W . Attenuation: 1~40dB . Impedance : 50 ohms . Connector: SMA/N . SWR:
Features: 1. 16satellite IF+ 1 Terrestrial inputs 2. Versions for 16 subscriber outputs 3. Built in Amplifiers circuit to compensate cable loss Sheet metal housing. Specifications: Model MS1716E No.of Inputs 16Sat.ú¼1Terr. No.of Outputs 16 Frequency Satellite: (MHz) 950-2150 Terrestrial: (MHz) 47-862(OEM:5-862) Sat.Loss (dB) 3 Terr.Gain (dB) 0 Switching Isolation (dB) 28 Isolation(Sat.)(out-out) (dB) 30 Isolation(Terr.)(out-out) (dB) 25 Rejection (dB) 28 Return Loss In (dB) 10 Out (dB) 8 Output Level Sat.(IMD3-35dB)(Tap) (dBuv) 100 Output Level Terr.(IMD3-60dB)(Tap) (dBuv) 82 Power Supply (Vac/Hz) 90í½260/47í½63 Max.Current Pass to LNB (mA) 1000.
Goip_4 gsm gateway is the gsm network and the voip network connecting seamlessly new productss. Mobile phone sim cards will be installed in goip, users of gsm phones can be registered to voip softswitch system. Goip users can be achieved through the gsm network on the car alight. Goip built-in sip and h.323, configuration flexibility. Sip can be thoroughly used when electricity came display numbers. Goip is pbx vendors, system integrators and provider of choice for both gsm productss
M.S. Cable trays of all types i.E ladder type , etc Any size
Fiber Optic media converter can transform the transmission media of Ethernet signal from CAT5 to optical fiber. It can extend the transmission distance to several kilometers or hundred kilometers. Using media converter is a economical solution to achieve long distance transmission base on current status. SC,FC,ST fiber ports available. Expand aple poly ephylene, carton.
Bare fiber adapters provide a simple and effective way to use un-terminated fibers with commercial Receptacles. Simply strip and cleave your fiber and insert in to the Bare Fiber Adapter. Broken fibers are easily removed with piano wire, allowing hundreds of insertions. They are recommended for power meter hook-ups, temporary system repairs or wherever a quick fiber connection is required. SC, FC and ST bare fiber adapters with stable qualities that use high quality Ceramic Ferrules and precise Fiber connector housing parts, they are used to quickly and easily terminate the fiber to the equipment. PE bag and carton.
Engaging in tower manufacturing for more than a decade, our company has longtime experience in the design, manufacture and installment of steel tower mast structure. Main products include all kinds of iron towers and similar steel structures widely used in the fields like power transmission, substations, telecommunication, microwave-communication, radio/tv broadcasting, mapping, watchtower etc.
Engaging in tower manufacturing for more than a decade, our company has longtime experience in the design, manufacture and installment of steel tower mast structure. Main products include all kinds of iron towers and similar steel structures widely used in the fields like power transmission, substations, telecommunication, microwave-communication, radio/tv broadcasting, mapping, watchtower etc.
Pneumatic telescopic masts Pneumatic telescopic mast is a latest innovation, forming part of an integral communication of systems. These masts are light weight and meant for quick erection, ranging from 5 to 25meters height. Pneumatic masts are extended by using low pressure air. The accessories supplied either from a compressor, in case of smaller masts, from a foot pump.
Telecom towers.
Idm ch-480net Brief introduction Idm ch-480net pdh multiplexer transmits 16 e1 and two 100mbps ethernet networks over one or two fiber channels. The optical interface supports simple als function, code of e1 interface is hdb3 which meets all the international standards. It also has perfect monitoring and alarm function, high degree of integration, low power consumption and stable performance. Both desktop type and integrated type are available. 220vac/-48vdc power supply alternative. It can be widely used in the mobile base stations, remote module of the switch and ddn private network and etc. Features 1.Provide standard 16e1 transmission and two 100m ethernet. 2.Ethernet ports support vlan and flow control. 3.155mbps speed rate of the optical interface and transmission distance more than 50km. 4.Support e1 loopback of cot (central office terminal) and rt (remote terminal), easy to test and manage. 5.Optical interfaces with 1+1 channel protection.(either one fails, the other will back it up) 6.Nms interface optional (rs232/ethernet). Specifications Power supply 220vac/-48vdc Consumption: 40w¦10% Optical interface Rate 155mbps¦50ppm Wavelength 1310nm/1550nm Physical connector Fc/sc Sensitivity Better than -36dbm E1 interface Channels 16 Rate 2.048mbps¦50ppm Comply with Itu-t g.703 Code Hdb3 Impedance 75 unbalanced and 120 balanced Ethernet interface Rate 100mbps, 10m/100m auto-negotiation Comply with Ieee802.3, 10/100base-tx Duplex Full/half auto-negotiation Operating environment Temperature: 0¦c~40¦c Humidity: 90% (non- coagulation) Dimensions 440mm+230mm+45mm (width + depth + height)
63e1 sdh/mstp multiplexer Brief introduction Idm mstp155-63 is wide narrow-band integrated optical fiber transmission equipment base on sdh/mstp technology, it can directly connected to the remote pdh multiplexer, optical modem and multi-service optical terminal and so on, integration of sdh transmission unit, e1 crossing unit and integrated service accessing unit, to adapt to various network topology can be set as a multi-service access, sdh transmission, pdh optical access functions of the small mstp equipment. Powerful network management functions, it can configure, failure and data statistics, real-time monitoring of network performance. Features 1.Two stm-1 optical interface, provide 1 +1 channel protection. 2.Provide 2mm connector, up to support 63 e1. 3.2-channel n íß 64k (n = 0 ~ 31) of the v.35/v.11 channel. 4.Provide e1, ethernet, v.35 and voice service optional. 5.Provide 4-channel ethernet physical isolation, to achieve n íß 2.048mbps bandwidth. 6.Support point-to-point, chain-shaped and ring network. 7.Comply with the itu-t g.813 standards and fully meet the timing accuracy. 8.Powerful network management features, online real-time monitoring. 9.Standard 19-inch 1u chassis structure, easy to install. Specifications Optical interface Rate: 155mbpsía4.6ppm Fiber mode: single/multi-mode Consumption: -15 ~ -8dbm Wavelength: 1310nm/1550nm Physical connector: fc/sc Sensitivity: better than -32dbm
We are offering a telecom towers & accessories that are designed and manufactured by our experienced engineers. In order to protect the highly sensitive telecom equipments, we design enclosures and shelters. These are perfect to place for bts equipments, amplifiers, power interface units, smps power supplies/chargers, batteries, mw racks and tools. We design these telecom towers & accessories keeping in mind the heat generation by the enclosed equipment and environment temperature variations. To minimize the use of air conditioners and generator, we advanced passive phase changing material. This also ensures low running cost and fault free long life of the equipment. We are offering intelligent power interface units that are designed for a/c voltage fluctuations in remote and rural areas. To provide exact cooling, we also provide cooling sections such as pelletier coolers, vortex coolers, passive cooling systems, dc powered air-conditioning systems and exacts fans. As energy saving in a vital concern for telecom operators around the world, our passive cooling technology in its shelters designed using phase change material (pcm) is known for saving energy. Panel construction: The prefer panels with polyurethane foam (puf) insulation are available in thicknesses of 20 to 150mm Multiple choices for panel interlocking are available Designed to ensure a completely moisture free environment Additional reinforcement are provided on request Shelter roof: Side sloping roof with reducing thickness Water tight sealing Extra wide flashing on roof fridge to avoid any air and water ingress Additional roof /secondary roof on demand
SIP (RFC3261/2543) 1FXS Gateway Ethernet x1 PC Scan/configuration tools Web configuration /auto]provisioning PC Scan/configuration tools Voice response setup G.711/G.729ab/G.723.1. 1carton/10pcs / 5Kg / 32*16*12cm.
SPC-10/100/1000M Series Media Converter can be used in the telecommunication IP MAN broadband optical network solution for its steady performance and powerful function.It convert 1000bps Ethernet copper port to optical port,up to 80km distandce on single-mode fiber without any relay device.It support auto-sending 10/100/1000Mbp half/full duplex topology,and MDI/MDI-X auto recognize. Selectable SC, FC, ST optical port makes the networks more flexible and feasible for the possibility of cost reduction. Package: carton Size:22X16X8cm.
1) Label strip and label holder. 2) Impact Design. 3)Material: ABS or PC. 4)Support RJ45 Data/Voice Module. 5)Color: White/Client Define. 6)single port 7)86mm*86mm.
1) Label strip and label holder. 2) Impact Design. 3)Material: ABS or PC. 4) Support RJ45 Data/Voice Module. 5) Color:White 6) Dual port 7)86mm*86mm.
1) French type 2)Dimension:45mmX45mm 3)Single port Material: ABS or PC.
1)French type 2)Dimension: 45mmX45mm 3)Dual ports 4)Material:ABS or PC.
