Fi-O Wireless Burglar Alarm System

Product Description 1. Stand alarm volume: 88db at a distance of 10 cm 2.It is mainly suitable for some pilot stores with low risks of theft. It does not support clamp. There is no internal cable for the stand. 3.Safe zone limit:1.5 0.5M

Gsm wireless burglar alarm system Description: Gsm network protection, short message sending function. Diy, customize, easy-to-use And install! ats- is the updated advanced gsm prepaid module made by shenzhen Autosecu technology co., ltd.It features eleven different wireless protection zones, Two wired protection zones, partial disarmed, remote telephone control, remote Electricity control, etc. Compatible with cctv surveillance and centre monitoring system. Features: Wireless type, easy to install, without phone line. Remote control, convenient. Password protected Sms to enable arm/disarm, partial arm/disarm, siren High siren volume so to scare away intruders Sms and auto dial up three phone numbers, locale monitoring start on. Sms to recheck the gsm panel status, alarm report, zone name, arm/disarm status. Audible/mute siren programmed Panic help Ac power shutoff self-detected to avoid malice destroyed, automatically switch to Battery back-up Enable to setup alarm receiving central through gsm network. Specification: Protection zone: wire : wireless: Gsm band: egsm /dcs /pcs mhz Tx rx Egsm ~ mhz ~ mhz Dcs ~ mhz ~ mhz Pcs ~ mhz ~ mhz It can save six alarm telephone number and separately set sms function or telephone Alarm. Transmitting power consumption: w Led indicators: Low power protected time:< s Data responds time: < s (standard network) Working power voltage: ac ~ v - hz (optional) Panel power consumption: < w Battery back-up: dc v standby last > hours Working condition: temperature- f++ f¦ Humidity: - f++ f¦ Net weight:kg. Gross weight:kg. Panel size: mm·+l·¼f- mm·+w·¼f- mm·+h·¼ Standard package : one gsm module, one remote keyboard, two remote controllers, One pir, one door magnetic sensor., one siren output, one adaptor, speacker(ooptional), remoteelectric control(optional)

Technical Parameter: GSM frequency: 900/1800/850/1900MHz (standard) Working frequency of detectors: 315M & 433M (standard) Alarm mode: GSM SMS and voice dialing Alarm response time: Less than 8s (Normal GSM signal) The volume of siren: More than 110db Power requirements: AC 110-240V 50Hz or 60Hz output DC12V Working power consumption: less than 0.6W Standby battery: DC 8.4V/800MAH (lithium battery) Standby battery working time: more than 15 hours Operating temperature: -10 ~ 55 Humidity: Less than 95% non-condensing Dimension:180(L)*130(W)*32(H)mm. Dimension:180(L)*130(W)*32(H)mm Weight: 2.5kg/pcs.

Package Includes: One main unit One wireless door/window magnetic contact One wireless PIR sensor Two remote controllers One White siren One AC adapter One digital keypad One English user manual Main Features: 1. Bulit-in GSM 850/900/1800/1900MHz. 2. The alarm host with 2 relay outputs,one of the relays with linkage function. 3. Support remotely arm/disarm by phone key press/SMS. 4. With independent arm function. 5. Alarm by SMS & Voice,can start-up on-site monitoring. 5. Can configure two-way communication function. 6. Can define alarm guarding zones. 7. With weak GSM dignal reminder and GSM network failure remind function. 8. Wtih external power failure alarm function. 9. With backup lithium battery(built-in 800 mAh). 10. With 10 wireless aalrm zones,2 wired alarm zones,1 wireless fire alarm zone & 1 wireless SOS alarm zone. Technical Parameter: GSM frequency: 900/1800MHz (standard), 850/1900MHz (optional) Working frequency of detectors:3 15M & 433M (optional) Alarm mode: GSM SMS and voice dialing Alarm response time: Less than 8s (GSM in normality) The volume of siren: More than 110db Power requirements: AC 110-220V 50Hz or 60Hz Working power consumption: less than 0.6W Standby battery: DC 8.4V, 800MAH (Lithium battery) Standby battery working time: more than 15 hours Operating temperature: -10 ~ 55 Humidity: 20% to 95% (non-condensing) Dimension: 220(L)*147(W)*38(H)mm. Dimension: 220(L)*147(W)*38(H)mm Weight: 2.5kg/set.

Supplier: RF products, wireless receiver module, wireless transmitter module, car alarm & security system, remote controller

1. Built-in GSM industrial module, easy installation and configuration 2. 3 wired zones and 6 wireless zones, each zone can be set as the Bypassing, Burglary or Emergency zone 3. Remotely program the function of the control panel by SMS or phone 4. Can Arm,Disarm by SMS or phone 5. Edit the name of zone by SMS,when alarm,SMS report the alarm information. 6. Real-time, Delay, 24 hours, Bypass defense zones program 7. Short message reporting of AC power failure and power and phone lines fault 8. With the operation password,make sure the safty. 9. 8 seconds pre-recorded alarm message that will be played when alarming 10. 4 pre-set telephone numbers to dial and 4 pre-set telephone numbers to send SMS 11. Automatic switch of AC power and backup batteries. One set by one clore box, 20boxes by one carton.

Intelligent home security and safety system GSM Wireless Security Burglar/Intruder Alarm System Description: Our GSM burglarproof alarm system which have GSM network protection, short message sending function. DIY, Customize, easy-to-use and install! It is the updated advanced GSM prepaid module made by Shenzhen AnBoShi Electronic Technology CO., LTD. It features eleven different wireless protection zones, two wired protection zones, partial disarmed, remote telephone control, remote electricity control, etc. Compatible with CCTV surveillance and centre monitoring system. 1. Wireless type, easy to install, without phone line. 2. Remote control, convenient. 3. Password protected 4. SMS to enable arm/disarm, partial arm/disarm, siren 5. High siren volume so to scare away intruders 6. SMS and auto dial up three phone numbers, locale monitoring start on. 7. SMS to recheck the GSM panel status, alarm report, zone name, arm/disarm status. 8. Audible/mute siren programmed 9. Panic help 10. AC power shutoff self-detected to avoid malice destroyed, automatically switch to battery back-up 11. Enable to setup alarm receiving central through GSM network. Specification: 1. Protection zone: Wire: 2 Wireless: 8 2. GSM band: EGSM900/DCS 1800/PCS 1900MHZ TX RX EGSM 880~915MHz 925~960MHz DCS 1710~1785MHz 1805~1880MHz PCS 1850~1910MHz 1930~1990MHz It can save six alarm telephone number and separately set SMS function or telephone alarm. Transmitting power consumption: 1W 3. LED indicators: 8 4. Low power protected time:

Supplier: Analogue Intercom, Ip Intercom, Smarthome, Conventional Fire Alarm Systems, Adressable Fire Alarm Systems

The image alarm, mobile phone and computer receiving Function of product 1. Infrared sensor, the image monitoring and moving objects detection 2. MMS function, when the alarm system alert, it will send the pciture of the local to your cell phone and your e mail. 3. Remote control, gain voice and image information 4. Hiding alarm, guard accident 5. With IR night vision camera, it provides 24-hours monitoring that the image is clear enough 6. Built-in battery, still work during power failure 7. Disposes the extension, monitor area is expanded Suitable place: 1. Family 2. Factory, warehouse 3. Office, financial room, code office 4. Bank, middle and small scale market 5. Supermarket, retail sales... N.W:0.8KG G.W:1.5KG SIZE:20X20X12CM