We produce in our Izmir factory, in accordance with TSEK quality norms, depending on vehicle chassis capacity refuse collectors with capacities; 6+1, 7+1, 11+1.5, 13+1.5, 15+1.5, 18+1.5, 20+1.5 m3. The refuse box is hydraulicpressed and produced to be rear loaded, suitable for loading 150 - 400 - 800 liters containers with 35 seconds press time, 35 - 40 seconds discharge period and 1/3 - 1/6 press ratio.
The hydraulic material used in the production of refuse boxes is wholly imported and the operation system is completely automatic.
Minipacker consists of a body with a raised rear end forming loading hopper, a shovel sweeping the refuse inside the body which is mounted to the body with top hinges, an ejection / pressing plate moving on rails mounted inside the body and the hydraulic installation powered by the vehicle. Because of the loading hopper being in one piece with the body there will never be any dirty water leaking, and single shovel offers simple and reliable.
All the functions and the load distribution of the equipment are properly arranged to the technical specifications of the chassis on which it is mounted. The equipment is manufactured in serial production principals taking into account the legal regulations.
Tank is manufactured from 5 mm. thick sheet steel.
Front end is covered with 6 mm. thick convex and dished plate and welded to the body both inside-outside.
There are baffle plates made from 4 mm thick sheet steel and mounted inside the body on the reinforcing rings with brass bolts.
Tank is mounted on the sub frame at a 5% slope with flexible mounting elements.
At the rear, there is an acid resistant rubber gadget of 25-30 shore hardness placed in a full diameter machined steel housing to prevent leaking from the tailgate.
Our scavenger equipment has TSEK quality certificates. The tank capacity of the scavengers changes between 3000 - 15.000 litres according to the capacity of the truck chassis.
The vacuum system is provided by the use of a special type air-cooled, electric operating pump with sliding steel blades. The vacuum pump gets its motion from the P.T.O. Depending on the static conditions; the system can suck-in from meters dept and 18 meters distance.
Multi-functioncal vw mobile street food cart has its unique advantage,
It allows small entrepreneurs to solve the two difficult problems of location difficulties and rent expensive,the mobile shop decoration costs low,to reduce the responsibility of the entreprencurs,
The most attractive is that it can move at any time,where the customer,where the dining car goes,to solve a series of problems later.
Based on the serial number 10KA0976, your equipment is a SkyTrak 10000M ATLAS telehandler, also known as the All-Terrain Lifter Army System (ATLAS) with a 10,000 lb capacity. Here are the key specifications:
Lifting Capacity: 10,000 lbs (4,536 kg)
Maximum Lift Height: Approximately 27.5 ft (8.38 m) with the 10,000 lb carriage
Maximum Reach: Approximately 24 ft (7.4 m)
Dimensions:
Height: 102 inches (259 cm)
Width: 100 inches (254 cm)
Turning Radius: 13.5 ft (4.1 m)
Frame Tilt: 9 degrees each way
Hydraulic Reservoir Capacity: 55.6 gallons (214 liters)
Fuel Tank Capacity: 44 gallons (167 liters)
Boom: Telescopic 3-stage
Steering Modes: 2-wheel, 4-wheel, and crab steering
Fording Depth: Up to 36 inches (91 cm)
Transportability: Air transportable in C-130, C-141, C-5A, and C-17 aircraft
Multi-functioncal vw mobile street food cart has its unique advantage,
It allows small entrepreneurs to solve the two difficult problems of location difficulties and rent expensive,the mobile shop decoration costs low,to reduce the responsibility of the entreprencurs,
The most attractive is that it can move at any timewhere the customer,where the dining car goesâ??,to solve a series of problems later.
