Induction Motor B3-Foot Mounted
Induction Motor (SP-B)
Induction Motor (single Phase)
15 HP WATER FILLED MOTOR 50 HZ-V380-415 ....
10 HP WATER FILLED MOTOR 50 HZ-V 380-415......
7.5 HP water filled motor 50 HZ- V380-415 SUBMERSIBLE MOTORS...
Performance Power 0.75kW Application Limits 1. Maximum liquid temperature +35 �°C 2. 200 m immersions limit 3. Starts/ hour 24 at regular intervals 4. Minimum flow rate for motor cooling 8 cm/s 5. Continuous service S1 Electric Motor 1. 2 pole electric motor, 50 Hz (n~ 2900 rpm) 2. Voltage: * Single phase 210- 220- 230 V 3. Insulation: class F 4. Protection: IP 68 Construction and Safety Standards 1. Oil filled rewindable motors (non-toxic oil use with food) 2. Jacket: AISI 304 stainless steel 3. Shaft: AISI 304 stainless steel 4. Dimensions of the flange connection in compliance with NEMA standards. 5. Chamber: Cast Iron 6. Complete with power cable of the following length: a. Single phase: 0.55- 1.1 kW = 4x1.5 mm / 1.5 mt. 1.5- 2.2 kW = 4x1.5 mm / 2.5 mt. 3.0 kW = 4x2.5 mm / 3.0 mt. b. Three phase: 0.75- 1.5 kW = 4x1.5 mm / 1.5 mt. 2.2- 4.0 kW = 4x1.5 mm / 2.5 mt. 5.5- 7.5 kW = 4x2.5 mm / 3.0 mt. Available on request 1. Other voltages or 60 Hz. frequency 2. Brass Top Bearing Cover
V6 Submersible Motor (Nema Standard)
Housing and casing for oil electric submersible pump ,motor ,protector and sepetator Application It uses coll rolling process and formed in one step,inner hole precision /-0.05mm, degree of finish Ra0.8~1.6, section wallthickness deviation 0.2mm, ovality within 0.05mm,straightness 0.2mm/m, The cold-rolled housing can be directly assembled and used without honing, which greatly saves the processing cost and improves the working efficiency. Characteristics Suitable for electric submersible motor ,pump ,protector and seperator with different geological conditions Types of ESP systems 375series,456series,562series,540series according to clients' drawing Material ASTM A335 T9/P9,45#steel,ASTM A335 P5,TP304,TP316,316L,L80 etc.according to clients' requirements Technical Performance Tensile strength>=560Mpa Yield strength>=525MPa Elongation>=10% Circular degree of inner hole
