Steel tooth bits series:
Soft formation tooth bits:
The soft formations tooth bits are used to drill low compressive strength, soft formations. Long projection
tooth lengths are used on high offset cones to provide the greatest penetrations rates possible. Wear
resistance hard facing is used to control tooth wear. On the softest bit types this hard facing completely
covers the bit teeth.
Medium hard formations tooth bits:
The medium hard formation tooth bits are used to drill high compressive strength, medium hard formations.
Shoot projection teeth with reduced crest length are used in this series of bit designs.
Durable hard facing is applied to reduce tooth wear.
1.Tighten the bits when screw on.
2.When the bit lower down to the bottom ,
Should give a soft pressure, slow drilling .After a drilling 0.2m-0.3m with appropriate pump, then give the conventional drilling.
3.Drilling could not be without water, if not fear the normal vibration sound or drill too slow, lift the drill to check without delay.
4.When drill jammed, withdraw first, should not to force the rig start.
5.Drill could not without water, to ensure that the bit will be too hot.
6.Use the bits in right order , big size first, then small one .
30*35*40cm 45kg