Find Verified Thermic Fluid Heater Suppliers, Manufacturers and Wholesalers

Gas and oil burner spares

Gas train for boilers and heaters

High pressure boiler capacity 500 kgs to 6000 kgs for fatty splitting

HRU for boilers and heaters

Serpentine coil thermic fluid heater capacity 1000000 kcal to 12000000 kcal

Single coil thermic fluid heater capacity uoto 5000000 kcal

Thermic fluid circulation pumps

Thermic fluid steam generator capacity upto 10 tph and 65 kgs pressure

This is basically A heat transfer equipment to heat air prior to entering in the furnace with a primary object to increase thermal efficiency of hot flue gases are passed through the tubes and air outside the tubes. The heat of the boiler flue gas is recovered in APH to increase the air temperature & the thermal efficiency is increased. Another advantage is that the flue gas is sent to chimney stack at lower temperature allowing simplified design of ducting & flue gas stack. It also allow controls the temperature of flue gas leaving the stack to meet emissions regulation / pollution control.
Salient Features:
Easy installation
Low maintenance cost
Robust construction
Compact
High efficiency

3-PASS FULLY WET BACK STEAM BOILER
Thermal-Max Steam Boiler
Smoke tube type system boiler with three pass fully wet back design, suitable for cal / agro waste / oil / gas fuel.
Salient Features:
Factory-assembled horizontal package boiler.
Less site work & quick commissioning
Suitable for coal, wood & briquetted fuel.
Manual firing - less complexity.
Large integral furnace - minimum heat loss.
High turn-down ration.
End to end visibility of tubes.
Easy access for inspection & cleaning.
Quick and easy ash removal.
Low excess air burners, imported / indigenous.
Capacity:Oil Fired - 500 kg./hr. to 8000 kg./hr.
Solid Fuel Fired - 500 kg./hr. to 6000 kg./hr.
Pressure:10 kg./cm2 to 35kg./cm2

Fully Automatioc Coil Type Boiler
Fully automatic, instant steam generating range of boilers designed for safe and reliable operations. Easy to install and commission, these time-tested boilers require very little maintenance. It features a specially designed furnace and combustion system to burn difficult heavy oils and offers fuel flexibility between light and heavy oils to help respond to fluctuating fuel prices.
Salient Features:
High Efficiency.
Large Steam & Water Volumes.
Less Maintenance
Unique patented membrane design
Built-in heat recovery device
Membrane design allows large tube diameter for coil enabling better steam dryness, less frequent de-scaling, longer coil life and minimum downtime
Unique economiser - optimiser design ensures maximum heat recovery without possibility of feed water pump failure due to boiling/ vapour causing cavitations and pump failure
Unique circulation burner design prevents leakage and eliminates fire hazard
Ceramic wool refractory allows fast cooling of top plate and easy maintenance
Easy access to all parts requiring maintenance.
Capacity:500 kg./hr. to 850 kg./hr.
Pressure:10 kg/cm2 to 20kg/cm2
Fuel:Coal / Wood / Lignite / Petcock

Our steam pressure reducing station are pre-fabricated manufactured ready to install units for steam system management. The pre-assembled steam pressure reducing stations are individually sized to meet end-user's specific needs. lnlet and outlet piping & valve are sized as per best engineering practices. Each unit is custom engineered and designed to meet specific system requirements.

All upstream & down stream pipe work & fittings are adequately sized to ensure that only the required pressure drop occurs across the control valve itself.