Kb 208 can be used to remove stains from hard surfaces Including metallic and non-metallic surfaces like glass, ceramic, Melamine, etc. The key to an effective cleaning depend on proper Dilution & soaking time. It’s food-grade quality allows its use in Places where cleaned surfaces may have direct contact with food. Kb 208 is designed specially for use in places where the use of Acidic products are not recommended. It’s strong disinfectant Function kills most common microbes & disease causing bacteria. Application Kb 208 must be diluted with water for soaking, dipping etc. May also be used by Brushing & scrapping. Dilution depend on soak time, for faster action use lower Dilution ratio that is higher concentration. May be diluted up to 500 times or more. It Has disinfectant function. Dosage Add about 100 gm/100 ml of kb 208 to about 100 lt. Of water or as required for Soaking and dipping. Use higher concentration for faster action and tougher stains. Agitation gives better result. Re-use solution until turbidity is high. Required to Repeat the process if necessary. When the cleaning process is complete, flush with Clean water. Use concentrated product for manual cleaning Handling & precaution This product is alkaline and should be handled with care to prevent personal injury. Avoid prolonged skin contact and breathing of the fumes. Refer to material safety Data sheet for more specific procedures and directions. Discoloration may Result when contact with colored clothing. Packaging Available in pail of 20 lt.. Can also be custom packaged.
Lc 120 is a product which effectively prevents scale and Corrosion in cooling towers having very soft waters which Are more corrosive, have a rysnar index over 7 and Calcium 25 – 75 ppm in the make-up water. It is an Excellent dispersant for calcium phosphate, iron oxides And clay. This product is used where heavy metals and Zinc is not allowed in effluent waters. Lc 120 is a Hydroxy-phosphonoacetic acid with polymers and copolymers To control scaling. It also has inorganic Phosphate and sodium tolytriazole to prevent corrosion And pitting of all metal surfaces. Application Injected directly into the circulating pipe upstream from the condenser. Cycles of concentration will vary from 5 – 20 as a probable upper limit. For Higher limits consult our laboratory. Dosage Feed lc 120 from a chemical mix tank or directly from the drum by means Of a proportioning pump at the rate of 0.5 pound / 1, 000 gallons of make-up Water. Adjust the dosage to maintain 5 – 10 ppm of orthophosphate in the Circulating water. A ph of 8.0 – 8.5 must be maintained. Handling & precaution Protective clothing and eye protection should be worn. In case of skin Contact, immediately flush thoroughly with plenty of clean water. In case of Eye contact, flush with copious of amounts of water for 15 minutes and Obtain immediate medical attention. Packaging Available in pail of 20 lt.. Can also be custom packaged .
Lc 240 is a highly alkaline concentrated product designed For neutralizing the metal surfaces that is susceptible to Corrosion. Lc 240 consists of a blend of soluble carbonate, Hydroxide and corrosion inhibitors. It is designed to control Corrosion and neutralize any acid left from “acid cleaning” Processes. It contains no chromate or heavy metals. It is Food grade, user & machine friendly and environmentally Safe. Neutralized mixtures can safely be disposed into Sewers. [ p – powder / l – liquid ] Application Can be added directly into the liquid volume to give a 1% to 5% solution or add till Ph value is between 6 - 8, which then may be used for neutralization & protection. For offline storing purposes a 0.5% solution may be quite effective. The surface to Be neutralized or get protection must receive a minimum of 5-10 minute contact Time. Dosage Dosage is calculated depending on the circulating or storing volume and the time Of contact. A diluted solution of 0.5% up to 5% is recommended. Use concentrated Solution for less contact time & higher initial conditions, where as a 0.5% solution May be used for storing. Ensure ph value between 6 – 8 before disposal. Handling & precaution This product is quite alkaline and should be handled with care to prevent personal Injury. Protective clothing and eye protection should be provided and worn. In case Of skin contact, immediately flush thoroughly with plenty of clean water. In case of Eye contact, flush with copious of amounts of water for 15 minutes and obtain Immediate medical attention. Packaging Available in pail of 20 lt. Can also be custom packaged.
LC 101 is used in steam boiler systems where water is zeolite softened or in natural waters very low in hardness. This treatment will prevent scale formation from residual hardness in addition to conditioning sludge. LC 101 is a balanced blend of polymers which are mildly alkaline scale and corrosion inhibitors in addition to sodium sulfite for added pitting and corrosion protection. If 20 to 30 ppm (mg/l) of sulfite cannot be maintained with a normal dosage of LC 101, add LC 102 to hold this recommended level. Application: Easily fed to the boiler as a slug dosage or by chemical proportioning pump directly in to the boiler. It can also be injected into the feedwater tank. Formula LC 101 contains no heavy metals. Dosage: Initial dosage is one (1) quart per 1,000 gallons and one (1) quart thereafter for every 800 gallons of make-up water. Maintain 20-30 ppm (mg/l) of orthophosphate in the boiler water. Handling & Precaution: Wear protective clothing and eye protection should be provided and worn. In case of skin contact, immediately flush thoroughly with plenty of clean water. In case of eye contact, flush with copious of amounts of water for 15 minutes and obtain immediate medical attention. Packaging: Available in pail of 20 lt.. Can also be custom packaged.
Kb 236 is a special blend of mineral acids, Corrosion inhibitors, emulsifiers & dispersing Agents. Effectively removes rust, scale and soil From metal and other hard surfaces. Application May be sprayed or brushed on surfaces. Clean surface free from Rust, soil and dirt. Apply kb 236. Allow to stand for 5 - 15 minutes, Then wipe off or flush with water. Dry surface can be repainted if Desired for longer protection. Dosage For cleaning surfaces, dilute one part of kb 236 with up to 10 Parts of water depending on the thickness of scales, soil & dirt. Allow to stand. Brushing may be required. Flush with water until all Scale are removed Handling & precaution Acidic product. Irritating to eyes and skin. After contact with skin Wash immediately with plenty of water. In case of eye contact Irrigate thoroughly with water for at least 15 minutes. Seek medical Advice Packaging Available in pail of 20 lt.. Can also be custom packaged.
Lc 214 is a special blend of penetrants, chlorinated Solvents, surfactants and emulsifiers designed to easily And quickly strip paint and varnish from metals, concrete, Brick, wood and most hard surfaces. The deep penetrating action of lc 214 soften though Paint and removes it without scraping. Lc 214 is homogeneous which adheres to vertical and Inverted surfaces and activate paint coating quickly. Application Brush, wipe or apply a heavy coat of lc 214 on the area to be Treated. For the reaction to be completed, allow lc 214 to Remain until old paint bubbles or wrinkles. Flush with water or Remove with scrapper. More than one application may be Required for areas of very heavy paint build-up. Dosage One ( 1 ) liter of lc 214 can be used over an area of 3 – 5 m2 . Handling & precaution Avoid contact with skin. In case of contact, wash affected areas With water. Packaging Available in pail of 20 lt.. Can also be custom packaged.
Lc 272 is a water based concentrated degreaser to Penetrate, emulsify and disperse oil, grease, dirt, soot, Grime and other types of soils from a variety of hard Surfaces. Safe for all types of metal surfaces. Specially designed for use in ovens, grills, chimneys, exitways, Smoke escapes, air vents & other such places Where thick deposits of oil/grease with soot / carbon is Common. Application Allow soaking time for effectiveness. Apply a thin layer by spraying or Brushing, then leave for soaking. Brush and scrap gently to remove any hard Soils if required then flush with water. Dosage Dilute with ratio of 1 : 5 with water depending on the dirt thickness. Use Concentrated product or lower dilution for tougher stains. Dilute upto 50 times For regular cleaning work. Handling & precaution Avoid spills on eyes. Should avoid unnecessary contact with skin. Can Irritate when exposed for a longer period. Harmful if swallowed. Packaging Available in pail of 20 lt.. Can also be custom packaged.
Kb 217 is a special water based carpet cleaner to Penetrate, emulsify and disperse oil, grease, dirt and stains on Fibers of synthetic carpets. Ideal for cleaning synthetic carpets Normally used on floors of office buildings, hotels, hospitals & Other public places. This formulation does no have any adverse Effect on painted surfaces including walls, wood and also metals Like stainless steel, aluminum, copper and brass. The room is Filled with a refreshing fragrance from kb 217 after the cleaning Work. Application Use diluted kb 217 ( 1 : 5 up to 1 : 20 with clean water ) with standard carpet Cleaning equipment like mopping machine & wet vacuum cleaner. Apply & spread The solution of kb 217 to the carpet surface and allow a soaking time of 2 – 10 Minutes before scrubbing rinsing & final mopping. The wet carpet should be Properly mopped with standard equipment & procedure until dry. Always make a test patch to confirm color fastness & soaking Time. Kb 217 can also be filled in directly into the detergent container provided with Certain carpet cleaning equipment which has a facility for it. Dosage Dilute with water depending on the cleaning work & stain. Can be diluted up to 20 Times. Direct applications of the undiluted product may be required on highly Stained areas Handling & precaution Avoid spills on eyes. Should avoid prolonged unnecessary contact with skin. May Irritate when exposed for a longer period on certain sensitive skin. Harmful if Swallowed. Keep away from children. Keep container capped in a cool dry place Packaging Available in pail of 20 lt.. Can also be custom packaged.
Lc 252 is designed to be used for “passivating” open & Closed loop systems to prevent corrosion. It is a liquid blend Of nitrite and other corrosion preventives which protects not Only steel surfaces but also copper and other metal as well. The high concentration makes it a cost effective nitrite based Passivating agent with the added advantage of being multimetal Compatibility and thus do not require separation of Non-ferrous parts from a system during passivation. Application Normally injected into the system that is previously filled with standard industrial Grade water and circulated continuously under required pressure for about 1-2 Hours with hourly monitoring of the nitrite concention. A higher temperature help to Accelerate the passivating process and therefore reduce operation time. An Appropriate temperature suitable to the system and available resources is choosen Between 35 – 950c Dosage Initial : 1 : 400 is suitable in most cases of passivation processes operating at Optimum temperature between 50 – 700c. Depending on the quality of water used Some adjustment in the amount may be required to maintain the ph of the solution. An increase in concentration of lc 252 is necessary in badly soiled systems. Additional amount of lc 252 may be required to be added during the circulation for The passivation process in order to maintain the required control parameters while Monitoring. Handling & precaution Avoid contact with acid, ammonium salts and activated carbon. No respiratory Protection. Is required, however, maintain adequate ventilation. Use rubber gloves And safety goggles when handling. Packaging Available in pail of 20 lt.. Can also be custom packaged.
Avocado seed powder, handicraft, customized helm, shoes, it equipment.
Ornamen And Industrial Stainless Steel Tube Pipe Dan Hollow.
Nickel Hydroxide .
Aluminum Ingot And Zinc Ingot .
Wood nails, wire rod.
Cotton safety gloves and WD cutting disc for metal.
Coal , iron ore, silica sand.Trading and supplier
Packaging Terms - according to each individual buyer's needs Harvest Capacity is at 10 - 20 tonnes each month
Name of product : Fresh Pineapples Grade : Grade A ( other grades are also available upon request) Specification : 1 fruit weights 900 grams - 1.2 kgs
Available, high grade quality Robusta Coffee Beans originating from Sumatera, Indonesia. Packaging can be done like in the picture. One bag contains 1 KG of coffee beans.
Ready to be exported : 150 tonnes of frozen shrimps From our cold storage located in Jakarta, Indonesia. For further details, please contact us, thank you.
