Use scope: bottom load /unload,the connector can be downward or side direction,with QCDC(G12 G17)
Used for : crude oil , residual oil and so on.
Design pressure: 0.08below 0MPa to 2.5MPa
Design temperature: 50 below 0f80
Multi-functioncal vw mobile street food cart has its unique advantage,
It allows small entrepreneurs to solve the two difficult problems of location difficulties and rent expensive,the mobile shop decoration costs low,to reduce the responsibility of the entreprencurs,
The most attractive is that it can move at any time,where the customer,where the dining car goes,to solve a series of problems later.
Multi-functioncal vw mobile street food cart has its unique advantage,
It allows small entrepreneurs to solve the two difficult problems of location difficulties and rent expensive,the mobile shop decoration costs low,to reduce the responsibility of the entreprencurs,
The most attractive is that it can move at any timewhere the customer,where the dining car goesâ??,to solve a series of problems later.
Based on the serial number 10KA0976, your equipment is a SkyTrak 10000M ATLAS telehandler, also known as the All-Terrain Lifter Army System (ATLAS) with a 10,000 lb capacity. Here are the key specifications:
Lifting Capacity: 10,000 lbs (4,536 kg)
Maximum Lift Height: Approximately 27.5 ft (8.38 m) with the 10,000 lb carriage
Maximum Reach: Approximately 24 ft (7.4 m)
Dimensions:
Height: 102 inches (259 cm)
Width: 100 inches (254 cm)
Turning Radius: 13.5 ft (4.1 m)
Frame Tilt: 9 degrees each way
Hydraulic Reservoir Capacity: 55.6 gallons (214 liters)
Fuel Tank Capacity: 44 gallons (167 liters)
Boom: Telescopic 3-stage
Steering Modes: 2-wheel, 4-wheel, and crab steering
Fording Depth: Up to 36 inches (91 cm)
Transportability: Air transportable in C-130, C-141, C-5A, and C-17 aircraft
Stock No - 2504111327JAC
Reg Year/Month - 1988/10
Mileage - 30,000km
Engine Size - 2,400cc
Transmission - MT
Drive Type -
Steering - Right Hand
Engine Model -
Model Code - N-LH85
Chassis No - LH850002***
Fuel - Diesel
Color - Red
Seats - 6
Maximum Carry -
Status - In-Stock
Stock No - 2411211006SRV
Reg Year/Month - 0000
Mileage -
Engine Size -
Transmission - MT
Drive Type -
Steering - Right Hand
Engine Model -
Model Code - FD151A
Chassis No - 762***
Fuel - Diesel
Color - White
Seats - 1
Maximum Carry -
Status -
Overall dimension 10660x2496x3950 mm
Driving type 6x4 km/h
Maximum speed 90
Cap space for 2 person
Displacement 9726 ml
Tank capacity 10 m3
Main water cannon max rang 65 m no wind , single water cannon status
Auxiliary water cannon max rang 5 m one water cannon (optional), no wind status
Features:
1. Water cannon
2. Spray system around
3. Self-extinguishing system
4. Centralized control system
5. Alarm light alarm
6, Hydraulic cleaning shovel
7. Publicity broadcasting system
8, Auto special automatic fire extinguishing system
9,Optional configuration: Accept customization
Truck, bus, car spare parts, cotton, canvas, jute, non woven, paper bags, two/three wheeler spare parts., used/ new laptops.Sourcing of automotive spare parts.
We are glad to propose 500 MT of stain less steel mill scale.
Mill scale is formed on the outer surfaces during by the hot rolling lamination of stainless-steel products.
At a visual inspection the material is a hard brittle sand and is mainly composed of iron oxides, mostly ferric, and is bluish black in colour, but it also contains considerable alloying elements such as chromium and nickel.
The recovery ratio after melting in furnace for the most valuable alloy elements is:
- Ni: 3.5 - 4.5%
- Cr: 6-8%
From the chemical and physical analysis performed on the scrap, and according to the European environmental rules, the material has been classified as a special non dangerous waste, listed in green list. In particular the mill scale can be classified as follows:
Waste code: 10 02 10
The material is stored on cemented flooring, and it can be loaded loose in tipper trucks or containers.
Chemical analysis of the material is available on request.
The Incinerated scrap or E46, is the by-product derived from the reprocessing of incinerated domestic waste.
After the combustion process, the furnace output (IBA Incinerator bottom ash) is firstly washed, magnetically separated and screened to separate any no ferrous material.
At a visual inspection, the material is fragmentized, with iron and steel parts, resulting partly cut or in shredded form.
The stock appears heterogeneous and contains all kind of cut or dismantled steel parts such as sheets, bars, frames, wires, bolts and other iron/steel household residues.
The incinerated scrap is eventually oxidized, due to the thermal and cooling treatments, that the material has been submitted to. The burnt scrap also contains minor slag parts, ash and iron oxide, due to the recovery process.
Such components are inherent and adhere to the scrap surface. The total impurities, can be sorted, but not fully removed.
The consignment does not contain any type of arms, ammunition, mines, shells, cartridges, radioactive contaminated, or any other explosive material in any form either used or otherwise.
The collected stock, is stored in open air, on cemented flooring. It can be loaded loose in 20â?? heavy duty container.
Please feel free to contact us for further details.
