We have an extensive stock of surplus parts and 2nd source parts, largely for AMAT, Centura, Endura, HDP Ultima Plus, Novellus, LAM, Mattson, TEL Parts, IMP Parts, etc. This stock changes regularly as we gain excess items from our many equipment refurbishment projects
Ceramic heater are widely used in pre-heating of plastic sheets for vacuum forming & thermoforming, drying paints, lacquer & varnish curing, drying printing inks, drying textiles, activating adhesives, removing surface water from objects or moisture removal from fabric and paper, animal husbandry and rearing.The ceramic IR heaters are highly efficient.Ceramic infrared heater offers precise targeting and control with minimal peripheral heat. It is possible to apply heat only where and when it is required.
Only defects that cannot be refurbished are defects on the puck, like cracks and fractures of ceramic parts. There are heat wires inside the ceramic puck and if the puck is broken,it is very probable that heat wires are damaged, which cannot be repaired.
In case of all Mca e-chuck, Mca heater, ESC, ALN Heater, Magnet Assy products used in PVD manufacturing process, we offer a various services of refurbishment that are conducted by our own engineers and in-house. Or if customers ask, we provide new one.
The Ceramic Heater is ideal for spot heating or area heating of remote locations, farm buildings, shops, service areas, pump houses or other hard-to-heat spaces, providing both fuel efficiency of radiant heat and installation flexibility not recommended for car washes. This is a Millivolt Standing Pilot heater and does not require an external power or electricity to operate, so it's great for use during power outages. Requires Millivolt thermostat for SGM sold separately. May require the following second stage regulators prior to the heater based on gas supply pressure
MCA ESC is a key consumable part of the PVD equipment used in the deposition process in the semiconductor manufacturing process that should be replaced regularly due to high temperature/ high pressure conditions and quality problems because of impurities in the chamber.
AMAT MCA E-chuck Heater PVD process parts warranty : 3 months condition : Used like OEM-New (All refurbished) P/N 0010-01288 AMAT MCA E-chuck Heater PVD process parts
Mca heater, ceramic heater, magnet assy.
Magnet Assy is located behind target, activated electronic motion in the plasma that improved efficiency by improving the uniformity of the deposition. Cathode role of the target material (Ti, Al, W, Ta, Cu, etc.) to be deposited on a substrate, pulls the Arion in plasma.
- Magnet assemblies are made up of steel parts and a ceramic magnet, bonded together with epoxy. - Max pull is tested on a ½� thick and flat machined steel plate. But the actual pull should be much smaller if your steel is thinner, rough, rusty, coated or not very flat. For any critical applications, three-time safety factor is strongly recommended. - Besides standard models listed bellow, we can make assemblies based on custom designs. - Applications include magnetic holding, lifting, antenna mounting, positioning, retrieving and more.
Magnet Assy is located on the Target in deposition processing (PVD process) in pre-processing of the semiconductor wafer chips manufacturing. Place the substrate(wafer)on the surface of the MCA E-chuck. Its role is to create the thin film off the Target in a plasma vaccum with its magnetic force. It has a significant role of the wafer thin film creating
