LED traffic signs;speed limit sign;variable message signsvms;bus station signs;car park signs;VMS trailer;LED lane signals.
Equipment, led traffic signal light.
LED traffic light, traffic light, traffic signal light, traffic light controller.
LED traffic light.
LED traffic light, solar LED traffic light, led traffic signal, led traffic sign, traffic lights, traffic signal light.
Road stud, traffic sign.
Detailed Product Description DC 5 V Speed Limit GPRS or 3G Led Traffic Outdoor Signs with Brightness 10000 10% Nit ITEM DESCRIPTION Pixel configuration 1R1W Control Mode Single chip Panel size 900.5*600.5*69mm Brightness 10000 10% Nit Display angle H : 1 / V : 1 Visible distance Direct sun to the panel, beyond 100M LED Encapsulation Nichia DIP510 Working Voltage DC 5 V Waterproof level IP65 Working Consumption 30W Life Time 10years Environment Temperature -20ãC~ 60ãC Shell material aluminum LED Traffic Speed Limit Screen Function: 1. 30km/h, 50km/h, 70km/h can be showed. 2. Can show temperature/humidity and single LED dot check function. 3. Automatically adjust led display brightness: Night at 20, dark day at 180 and daylight at 250. 4. PC can communicate with LED display through serial port, if remote controller, need to connect RS232 port with wireless modern, and PC can communicate with LED display through 3G or GPRS. 5. White color frame and red color fame can show very simple change. DC 5 V Speed Limit GPRS or 3G Led Traffic Outdoor Signs with Brightness 10000 10% Nit LED Traffic Speed Limit Screen Communication Process: 1.PC send a command to LED display Through GPRS or 3G. 2.LED display execute this command. 3.LED display make a successful feedback(if no feedback within 10 minutes, then fail, please check internet) wooding or flighting cases
Detailed Product Description High Resolution Moving Road / Signage Led Traffic Signs for Outdoor Advertising 1. The visual requirements of signs set the viewing angle of the LEDs. Signs installed on highways, for example, require bright LEDs with a narrow beam width, but in cities with a requirement for short distance legibility a wide beam width LED is usually required. 2. Outdoor message signs must typically operate for over ten years in a harsh, corrosive, and exposed working environment. Dicolor LED traffic sign use new 15 and 30 degree viewing angle lamps. The maximum LED junction temperature limit of +130enables high temperature operation in bright sunlight conditions. The lamp epoxy uses UV inhibitors to reduce the effects of long term exposure to direct sunlight. 3. Applications for LED lamps in road equipment and signage include:Traffic management: Traffic signals, Pedestrian signals, Work zone warning lights, Variable message signs Commercial outdoor advertising: Signs, MarqueesSolar powered signs. 4. Dicolor-The only LED enterprise honored to pass EN12966 in China, LED Traffic Sign have been exported in Belgium, Netherlands, Turkey and other countries and regions. wooding or flighting cases
Detailed Product Description Automatically 1R1W Single Chip Adjust Outdoor Moving Led Traffic Signs Controlled by PC LED Traffic Speed Limit Screen Function: 1. 30km/h, 50km/h, 70km/h can be showed. 2. Can show temperature/humidity and single LED dot check function. 3. Automatically adjust led display brightness: Night at 20, dark day at 180 and daylight at 250. 4. PC can communicate with LED display through serial port, if remote controller, need to connect RS232 port with wireless modern, and PC can communicate with LED display through 3G or GPRS. 5. White color frame and red color fame can show very simple change. ITEM DESCRIPTION Pixel configuration 1R1W Control Mode Single chip Panel size 900.5*600.5*69mm Brightness 10000 À 10% Nit Display angle H : 15 / V : 15 Visible distance Direct sun to the panel, beyond 100M LED Encapsulation Nichia DIP510 Working Voltage DC 5 V Waterproof level IP65 Working Consumption 30W Life Time 10years Environment Temperature -20C~ 60C Shell material aluminum Automatically 1R1W Single Chip Adjust Outdoor Moving Led Traffic Signs Controlled by PC LED Traffic Speed Limit Screen Communication Process: 1.PC send a command to LED display Through GPRS or 3G. 2.LED display execute this command. 3.LED display make a successful feedback(if no feedback within 10 minutes, then fail, please check internet) WOODING OR FLIGHTING CASES
Detailed Product Description Long Life White Color Fame 1R1W Single Chip Led Traffic Display Sign 900.5 * 600.5 * 69mm ITEM DESCRIPTION Pixel configuration 1R1W Control Mode Single chip Panel size 900.5*600.5*69mm Brightness 10000 10% Nit Display angle H : 15 / V : 15 Visible distance Direct sun to the panel, beyond 100M LED Encapsulation Nichia DIP510 Working Voltage DC 5 V Waterproof level IP65 Working Consumption 30W Life Time 10years Environment Temperature -20C~ 60C Shell material aluminum LED Traffic Speed Limit Screen Function: 1. 30km/h, 50km/h, 70km/h can be showed. 2. Can show temperature/humidity and single LED dot check function. 3. Automatically adjust led display brightness: Night at 20, dark day at 180 and daylight at 250. 4. PC can communicate with LED display through serial port, if remote controller, need to connect RS232 port with wireless modern, and PC can communicate with LED display through 3G or GPRS. 5. White color frame and red color fame can show very simple change. Long Life White Color Fame 1R1W Single Chip Led Traffic Display Sign 900.5 * 600.5 * 69mm LED Traffic Speed Limit Screen Communication Process: 1.PC send a command to LED display Through GPRS or 3G. 2.LED display execute this command. 3.LED display make a successful feedback(if no feedback within 10 minutes, then fail, please check internet) Long Life White Color Fame 1R1W Single Chip Led Traffic Display Sign 900.5 * 600.5 * 69mm wooding or flighting cases
Feather Ultimate optical performance ¡§C exceeding the highest optical classes according to EN 12966 Conformity to EN 12966 : more than 100 class-combinations of different color , luminosity , contrast , beam width , pixel pitch , LEDs ,forward current , etc. have been tested and certified by SGS/INTRON. Cutting edge performance ¡§C Anti-aliasing for picture smoothing , Optical System , Optimized Pixel Density , True Type Fonts ,Display Luminance Intensity Regulation , Current Source Monitoring Technology , Surface Mount LEDs ¡§C provide extraordinary advantages over standard LED signs in situations where motorists have only a brief period of time to absorb and react to information. Any application , any size , any interface , and any housing execution ( front & rear access , walk-in ) ¡§C over 150 different modules available Connectable to any existing system ¡§C certified and proven compliance with most widely use protocols (NTCIP , TCP/IP ,PROFIBUS , XML-OPC , etc. ) ,customization to any user protocol ( numerous examples of implemented projects ) 100% customizable dimensions and pixel pitches. Customizable as any other application-tailored display(size , pitch , optical proterties , consumption , service access , redundancy requirements , set of standardized accessories ) VMS Application Generally speaking, VMS is used to communicate in real-time with motorists. VMS messages must address current conditions on the roadway by being dynamic, accurate, timely and understandable. When there are multiple requests to post VMS messages simultaneously, messages will be prioritized in the following order of importance: 1. Incident Management/Public Safety 2. Congestion Management/Motorist Guidance 3. Construction/Maintenance Activity 4. Special Events 5. Environmental 6. Law Enforcement Message 7. Public Service Campaign VMS Small Knowledge: When using text, care should be taken that the text can be read at a sufficient distance. One rule of thumb is that the minimum reading distance (in metres) is about 5 to 6 times the letter height (in cm). For example: a 36-cm high letter can be read at a distance of about 200 m from the sign. When planning to install new VMS, authorities should know that the European VMS standard (EN 12966) is obligatory for all fixed VMS signs used in traffic applications. This is not yet the case for temporary or mobile VMS because the Construction Products Directive (CPD) is only valid for products that are in permanent use. An informative appendix of the European VMS standard (EN 12966) provides guidance in choosing the correct combination of the various items mentioned above.
Power Consumption: Full Ball ¡¨¹ 5w Working Voltage: 85-265vac-50/60hz , 12v/24vdc; Wave Length (nm): Red:625¡¨¤5;green:505¡¨¤5 Led Q¡¡¥ty: Red-61 Pcs;green - 61 Pcs Housing Material: Pc, Uv Resistant Life Span: >100, 000 Hours. Delivery Time: Samples Within 5days, Lot Of Order Within 15days. Certificates: Ce, Chinese Gb14887-2003 Standards, Ip65. Warranty Time: 2 Years 65*33*24cm 1pcs/carton Gw:5.5kg Nw:4kg K=k Carton
Power Consumption: Red Full Ball ¡¨¹10w Working Voltage: 80-280vac-50/60hz , 12v/24vdc; Wavelength (nm): Amber Color:590¡¨¤5 Led Q¡¡¥ty: Amber Ball- 100pcs Certifications: Ce, Chinese Gb14887-2003 Standards, Ip65 Housing Material: Uv Resistance Pc Warranty: 24 Months Power Consumption: Red Full Ball ¡¨¹10w Working Voltage: 80-280vac-50/60hz , 12v/24vdc; Wavelength (nm): Amber Color:590¡¨¤5 Led Q¡¡¥ty: Amber Ball- 100pcs Certifications: Ce, Chinese Gb14887-2003 Standards, Ip65 Housing Material: Uv Resistance Pc Warranty: 24 Months 525*410*380mm 1 Pc/carton Box
1. Amazing convenient dual light sources of signal light and torch in one body designed. 2. 3 colors signal light-----61 super-bright led signal light provides the red, green and white railway hand signal with visible distance over 300 meters during the day time and over 3, 000 meters at night. 3.17 led torch-----17 super-bright 10mm white led torch provides about 16 hours constant torch illumination with brightness readable at 20 meters away. 4. The large capacity of 9, 000mah rechargeable ni-mh battery adopted for matching of total 78 led. 5. Why high quality this product is, it makes up a lot of advanced technique and highly cost parts: Smart programmed cpu is applied which controls all the functions and makes light long time works properly. Smart 6-stage pulse charge technology applied which guaranteed the battery life over to 6 years Battery charging, and fully charged led indicate; fine current charges automatically keeping. Battery over charge, over discharge auto protected and charging time limited Low power led indicates and reminds you the light need to be charged asap. High cost of low temperature imported parts applied in the circuit. Permanent power makes brightness of the signal and torch unchanged all the time. 3 colored signal switch button shows the corresponding signal and signals shifting easily and promptly. Light shell made of bayer pc material and anti-drop structure designed. Removable high bright light-reflect belt provided for safer during the work. 12 v car charge available, and the car charge cable provided. Safe works under extreme temperature conditions between -40c ~ +50c. Real water-proof charge socket designed with ip degree 67 designed. 12pcs/case, color packing each.
300mm led traffic signal light Shape:300mm (12¡±) High brightness LEDs with integrated optics Moisture and dust tight seal(IP54) Total Harmonic Distortion
12inch led traffic light Shape:300mm (12¡±) High brightness LEDs with integrated optics Moisture and dust tight seal(IP54) Total Harmonic Distortion
Brightness: 4,000cd/¬O Apply diameter: 300mm, 12 inches LED quantity (R, Y, and G): 180, 180, and 156 pieces. Automatically adjustable light Large viewing angle Multilayer sealed, water and dust proof Special optical system Long lifespan Low power consumption Well-distributed chroma produced according to Chinese GB14887-2003 standards and related international standards. Diameter 300 mm.
Solar road stud Model no. Rs-702 Dimensions :132*122*20 (mm) Net weight 520(g) /500(g) Solar max. Output 0.35w Charge ability 118ma/hour Storage device type 1600mah ni-mh battery Type 8mm high intensity emitting diode Emission color yellow/white /red/blue/green Quantity 2pcs leds/1 side or 4pcs leds/2 sides Output-per led 11000mcd Leds Power current 14ma/hour Lighting way flash, steady, cascading effect Lighting time 50 hours after a standard luminous intensity day, 300 hours if battery charged fully Visibility (approx) 500m Operating temperature -25 to +75 degree c Main body upper part transparent polycarbonate Lower part die-cast aluminium alloy
Solar traffic warning light Model no. Rs-704 Diameter of transparent lens(mm) 190(mm) Net weight 770(g) Solar max. Output 0.3w*2 Charge ability 102ma/hour*2 Storage device type 1.2v/4000mah ni-mh battery Type super bright mini led, 10times brighter than normal type Emission color yellow/red Quantity 1pcs led/1 side or 2pcs leds/2 sides Output-per led 11000mcd Leds Power current 12ma/hour*2 Lighting way flash, 60times/minute Lighting time 200 hours after a standard luminous intensity day, 600 hours if battery charged fully Visibility (approx) 1000m Operating temperature -25 to +75 degree c Main body upper part transparent abs Lower part yellow or red abs with mounting kit
Solar guardrail light Model no. Rs-703 Dimensions 250*120*40 (mm) Net weight 340(g) Solar max. Output 0.45w Charge ability 100ma/hour Storage device type 1600mah ni-mh battery Type super mini high intensity emitting diode Emission color yellow/white/red/blue/green Quantity 3pcs leds /1 side Output-per led 11000mcd Leds Power current 12ma/hour Lighting way flash, steady, cascading effect Lighting time 50 hours after a standard luminous intensity day, 150 hours if battery charged fully Visibility (approx) 500m Operating temperature -25 to +75 degree c Main body upper part transparent polycarbonate Lower part iron panel with antirust paint
