A damp proof course ( dpc ) is a physical barrier inserted into the fabric of a building to stop water passing from one place to another. This can be on a horizontal plane, stopping water rising up from the ground by being sucked up by the dry masonry above, or vertically to stop water passing from the outside of a building, though the masonry, to the inside. Dpc's have taken many forms through the ages and one of the earliest forms was to use a layer of slate in the construction. Slate is still used but the less expensive plastic version ( below right ) is now more widely used. Technical specification of dpc Water vapour permeability 0.28 gm2 day-1 Bs3177 Water vapour transmission 733 mnsg-1 Water absorption 0.22% Bs2782 : 430a Resistance to leakage at joints Pass Moat 27 : 5.2.1 Tensile strength of joint Unaged : 300 n Heat aged : 290 n Water soak : 257 n Moat 27 : 5.2.2/3/4 Cold flex temperature −60¡ãc Bs2782 : 320a Tensile strength L : 12.9 nmm-2 T : 11.2 nmm-2 Bs2782 : 320a Elongation at break L : 415% T : 582% Bs2782 : 320a Tear strength L : 122 nmm-1 T : 96 nmm-1 Bba method Low temperature flexibility L :
Coun 2.00.25dtex Tenacit 11.5cn/dtex Elongation 7.5% Molulus 0.1-0.4% 28020 cn/dtex Hot water solubility(90 Packing p.P. Bag, 180kg net 12.96t / 20fcl container
Density¡êo2790-3070 kg/m3 Compressive strengtho1000-3000 kg/cm2 Modulus of elasticityo1.3-1.5x106 kg/cm3 Water absorptiono0.13 % Shore hardnesso> hs 70 Specific gravityo2.6 Wooden packaged, as customer demands
Sinoplank is an engineered wood product designed specifically for use as a scaffold plank. Product: laminated veneer lumber scaffold planks Application: for use as scaffold platforms or decks Material: structural laminated veneer lumber (lvl) Standards: osha (standards & regulations 29-cfr) 1926 subpart l, appendix a, bs 2482 specification for timber scaffold boards, as1577-1993 scaffold planks appendix a and appendix b Core: pine core and face Adhesive: phenolic adhesive for exterior use Section size: 38mm/42mm thick and 225mm/230mm wide Moisture content: maximum 16% moisture Lengths: 1.0 m to 6.0 m length range available End sealant: acrylic end sealant for moisture protection Approximate mass: 4.95 kg per lineal meter Edge branding: embossededge branding at customer request Finish: un-sanded faces, rounded edges, painted ends Proof testing: planks proof loaded and rigidity measured for verification of strength claims. Standard verification testing is regularly completed both in the mill and by the independent third party.
Sinoplank is an engineered wood product designed specifically for use as a scaffold plank. Product: laminated veneer lumber scaffold planks Application: for use as scaffold platforms or decks Material: structural laminated veneer lumber (lvl) Standards: osha (standards & regulations 29-cfr) 1926 subpart l, appendix a, bs 2482 specification for timber scaffold boards, as1577-1993 scaffold planks appendix a and appendix b Core: pine core and face Adhesive: phenolic adhesive for exterior use Section size: 38mm/42mm thick and 225mm/230mm wide Moisture content: maximum 16% moisture Lengths: 1.0 m to 6.0 m length range available End sealant: acrylic end sealant for moisture protection Approximate mass: 4.95 kg per lineal meter Edge branding: embossededge branding at customer request Finish: un-sanded faces, rounded edges, painted ends Proof testing: planks proof loaded and rigidity measured for verification of strength claims. Standard verification testing is regularly completed both in the mill and by the independent third party.
18''- 22 base-square groove 1. For casement window 2. Made in ss 304, ss 201 3. Square groove, two- pivots pointed, straight arm or curve- surfaced arm 4. Biggest open angle 90 5. After 50, 000 times opening tests 6. Specification: 4 arms, length 18 base width 22mm, arm thickness 3.0mm. 100 pieces per box, export cardboard packing
20''- 22 base-square groove 1. For casement window 2. Made in ss 304, ss 201 3. Square groove, two- pivots pointed, straight arm or curvesurfaced arm 4. Biggest open angle 65 5. After 50, 000 times opening tests 6. Specification:5arms, length 20 base width 22mm, arm thickness 3.0mm. 100 pieces per box, export cardboard packing
20''- 22 base-square groove 1. For awning window 2. Made in ss 304, ss 201 3. Square groove, two- pivots pointed, straight arm or curve-surfaced arm 4. Biggest open angle 30 5. After 50, 000 times opening tests 6. Specification: 6 arms, length 20 , base width 22mm, arm thickness 3.0mm 100 pieces per box, export cardboard packing
26''- 22 base-square groove 1.For awning window 2. Made in ss 304, ss 201 3. Square groove, two-pivots pointed, straight arm or curve-surfaced arm 4. Biggest open angle 25 5. After 50, 000 times opening tests 6. Specification: 7 arms, length 26 , base width 22mm, arm thickness 3.0mm 100 pieces per box. Export cardboard packing
20''-20 base- round groove 1. For awning window 2. Made in ss 304, ss 201 3. Roundgroove, one- pivot pointed, straight arm or curve-surfaced arm 4. Biggest open angle 25 5. After 50, 000 times opening tests 6. Specification: 6 arms, length 20, base width 20mm, arm thickness 3.0mm 100 pieces per box, export cardboard packing
Description Aluminum tile, also called corrugated aluminum, is one of the most popular construction material.To a certain extent it could replace stainless steel because its property of lightness and anti-corrosion. Specification: MaterialAlloy aluminum TypeSeries 1 series 9 TemperAll temper Thickness0.1mm 2.0mm Surface treatmentSpray coating/roll coating ColorNaturall/gold¡ Characteristic & advantages Very light and easy to assemble Inexpensive and cost saving Good property of antirust Good effect of heat insulation & sound insulation Moist-proof, fire-proof & dust proof Usage: The roof and wall of workshop or warehouse Temporary house, simply building, dormitory Cleansing house & office Packing Protective film, wood pallet, standard export pacakage Protective film, wood pallet, standard export pacakage
- produced by advanced technology and equipment using high-purity gypsum as the raw material, auko regular gypsum board bears flat surface, accurate dimensions and assured quality. - the imported high-quality covering paper has high strength and good adhesive property with plaster core, thus guaranteeing the strength of plasterboard and laying a firm foundation for applying plaster putty or direct decoration. - light weight and high strength, strong nail-pull resistance, good flatness, low water content, low expansion rate, good durability, favorable processability and easy cutting. - tapered edge offers easiness for jointing and the surface of joint is smooth and not easy to crack. - it can adjust indoor humidity to a certain extent and has passed green building material certification for its healthy and environmental property. Packing in containers
Moisture resistance gypsum board, covered with green paper, is moisture resistant lightweight plasterboard. It can be directly used in indoor environment with a relative humidity of over 95%, such as partition and ceiling in washroom, kitchen, basement, it can also be used as base board for applying ceramic tiles, metal sheets, plastic sheets, etc.(it can also be used as lining board of ceramic tiles, metal sheets, plastic sheets, etc.). Standard carton(can add bubble and hard paper for protect products)
The regular paper-faced gypsum board : Technology parameter Main physical propertiesMain thickness specifications mm Standard requirements (gb/t9775-1999) Fracture load(n)Vertical9.5 360 12.0 500 Lateral9.5 140 12.0 180 Weight per unit area(kg/©o) 9.5 9.5 12.0 12.0 9.5120024007.0 1002882.01 12120024009.0 80230.42.08 9.5120030007.0 1003602.52 12120030009.0 802882.59. Standard carton(can add bubble and hard paper for protect products)
Auko materail factory mainly supply the light steel keel for the ceilings and drywall partition also with the accessories.Our products are featured with light-weight, long lifetime, high durability, rust resistance, easy cut apart, convenience installation, environment friendly, save labor costs and so on.They are popular used in domestic and all over the world for its excellent quality and reasonable price. -feature :1.Good strength2.Gauterization resistant3.Water / fire resistant4.Easy to install -usage :1.The keel used for saspension ceiling2.Widely used in condole suports building decoration materials-remarks:length can be provided by customers'request.
Kinds of gypsum boardRegular gypsum board;fireproof gypsum board; moisture proof gypsum board;sound insulation gypsum board OthersWe manufacture and sell indoor decorative materials including gypsum board, pvc gypsum board, calcium silicate board and light gauge steel Convenient ConstructionThe paper-faced plaster board of auko building material can be constructed easily by nailing , cutting and planing.Now it already becomes the first selection of the gypsum board market. Raw materialNatural high purity gypsum powder, fiber, high quality additive Production capacity6000, 0000square meter/square meters per year CertificationIso9001 sgs Packaging detail:Standard carton(can add bubble and hard paper for protect products) Trade termsFob cfr cif Method of paymentL/c t/t PriceFob$1.8 -$2.5/ per square meter Minimum order1x20ft full container PortLianyun harbour The delivery periodWithin 15 days after receipting buyer's t/t deposit or l/c.
Specifications: Products name:paper-faced gypsum board Material :gypsum board Size : Length :1800mm , 2400mm , 2440mm, 2700mm, 3000mm Width:1200mm 1220mm Thickness: 8, 8.5 9 9.5 10 12 13 mm Advantages: Surface smoothness and easy cleaning2.Strong color guarantees 10 years for indoor use3.Flexible suspension system make each ceiling tiles easy install and disconnect4.Easy to match lamps or other ceiling parts 5.Environmentally friendly products( low pollution) 6.High quality, reasonable price and good customer service Recommend applying in these places below: 1.Public buildings:hospitalschoolrestaurantair portbus station and so on 2.Commercial buildings:office, store, plaza, etc.3. Civil using The minimum order: only one container(20¡¯) ! My dear friends , whichever gypsum board you choose, the minimum order is only 1*20¡¯ and different items are welcome! Raw material Natural high purity gypsum powder, fiber, high quality additive Production capacity 6000, 0000square meters per year Certification Iso9001 sgs Packaging detail: Container Trade terms Fob cfr cif Method of payment L/c t/t Minimum order 1x20ft full container
Auko keeps using high technology and high purity gypsum as raw material, keeps using the international advanced production technology and equipment, which ensure the quality of gypsum board.High quality original wood pulp paper surface, high strength, and good adhesive properties of gypsum core is the virtue of our product, and we can ensure the strength of gypsum board.What's more, our products can better to apply decorative gypsum putty or direct provides a good base. Feature: (1)well decorative function: the quality of products has smooth surface, exact size as the high purity gypsum and advanced production technology and equipments , it has a well decoration effect. (2)environmentally friendly products: less pollution than other building materials. (3)multi-function: shock resistance, fireproof , sound insulation, impact resistance. (4)high quality, reasonable price and good customer service. 9.5mm*1200mm*2400mm 7.0kg square meter 12mm*1200mm*2400mm 9.0kg/square meter 9.5mm*1200mm*3000mm 7.0kg/square meter 12mm*3000mm*1200mm 9.0kg/square meter
Lijie exterior wall cladding is consist of 100% exterior phenolic resin compact grade laminate and metal frame structure, which is widely used in the outside building facades and easy to set up, low maintenance cost . Applications: Hotel wall facade, office building, airport, station, school building, public occasion. Features: 1.Resistant to water , moisture, 2.Resistant to fire, heat and cigarette burns, 3.Anti-graffito, anti-bacterial, anti-static 4.No toxic, no deform , no fades 5. Extremely durable, easy to clean, install, maintain 6.Rich in colors and surface finish. Standard wooden pallets & cartons
Our products are as follows: T/S: 1670 /1770 / 1860 / 2000 Mpa Structure£º1x7, Standard: ASTM A416, BS5896, GB/T5224,JIS G3536, AS/NZS 4672 Nominal Dia.: 9.53/9.5, 12.7, 15.2, 15.24, 15.7, 17.8, 18.9, 21.6mm Type: Plain, Spiral Ribs, PE Coated (unbonded), Epoxy Resin Coated. Packing: Shaftless and Moisture-proof. Each coil is strapped by steel bands with two wooden pallet on the bottom (fuming /steaming) and fully wrapped in anti-rust paper&p.p woven sheet.
