Catalyzed Oxygen Scavenger with polymers for
preventing pitting. Ideal for use with both hard and presoftened
make-up water.
Application
Can be injected directly into the boiler by means of a proportioning pump.
Advisable to gradually feed LC 102 by means of a chemical proportioning
pump into the storage section of the de-aerating heater as far ahead of
the boiler as possible to provide maximum effectiveness in high pressure
boiler operating from 100-600 psi. or where large amount of water is used.
Dosage
Initial : 3 quarts per 1,000 gallons or 3 : 4000
Maintenance: 1 quart for every 1,000 gallons of make-up water or 1 : 4000
Maintain 20-50 ppm (mg/l) in the boiler water. LC 102 can be used in
conjunction with other formula in our product line, but should not be used
in a boiler operating in excess of 600 psi.
Handling & Precaution
LC 102 is mildly acidic product and should be handled with care to prevent
personal injury. Wear protective clothing and eye protection. In case of
contact with skin, immediately flush with water. In case of contact with
eye, flush with water for 15 minutes and obtain immediate medical
attention.
Packaging
Available in pail of 20 lt.. Can also be custom packaged
LC 104 is an ideal single product boiler internal treatment, specially formulated by blending sludge conditioner & oxygen scavenger for dual function in packaged boiler systems. It can control not only calcium carbonate & calcium phosphate deposits but also calcium sulfate and barium sulfate. Highly concentrated alkaline product. Eliminates excessive precipitation of solids and reduces sludge accumulation. The oxygen scavenger prevents pitting corrosion in the boiler system. It is environmentally safe, non-hazardous and non-corrosive. Application Used in packaged boilers below 5 Tons/Hr. For use with make-up water hardness below 150 ppm and effectively disperses iron oxides as well as calcium phosphate and clay. Injected directly into the boiler by means of a proportioning pump. Dosage Initial : 2 quarts per 100 gallons or 1 : 200 ratio Maintenance: 1 quart for every 100 gallons of make-up water or 1 : 400 ratio Maintain 15-25 ppm (mg/l) of orthophosphate in the boiler waters with pH between 11.0 – 12.0. Maintain Conductivity below 3000 µmho/cm. Consult LifeChem Technical Services when Hardness is low or high. Handling & Precaution LC 104 is an alkaline product and should be handled with care to prevent personal injury. Wear protective clothing and eye protection. In case of contact with skin, immediately flush with water. In case of contact with eye, flush with water for 15 minutes and obtain immediate medical attention. Triple rinse used cans before reuse or disposal. Refer to MSDS for detailed information. Packaging Available in pail of 20 lt.. Can also be custom packaged.
Kinds: Fullerene C60; Fullerene C70 INCI Name: FULLERENES Molecular Formula: C60 Molecular Weight: 720.66 Appearance: Dark brown to black powder CAS NO.: 99685-96-8 Supplier: ZHENYIBIO Application: cosmetics and skin care products Fullerene has a high affinity for free radicals and an inhibitory effect on active oxygen, so it has a very good anti-oxidation effect. There are two types of fullerene raw materials currently used in cosmetics. One is water-soluble fullerenes. The fullerenes are dispersed into water-soluble cosmetic raw materials by using water-soluble polymer PVP, which is also an earlier application of fullerenes. Raw material; the other is oil-soluble fullerene, which is a fullerene raw material prepared by using vegetable squalane as a solvent. The effects of fullerene on the skin mainly include whitening, anti-wrinkle, inhibiting acne, and promoting hair growth, etc., mainly as follows: 1) Affinity to free radicals: Fullerenes are highly compatible with free radicals, which can minimize the effects of free radicals on the skin. 2) Scavenging active oxygen: Fullerene has a scavenging effect on active oxygen in the skin. Causes of skin stains: UV radiation causes the increase of active oxygen in the skin. Under the influence of active oxygen, the skin produces melanocyte stimulating hormone, interleukin and other substances, which in turn activates melanocytes and stimulates tyrosine in melanocytes The conversion of acid to melanin, and finally pigmentation, causes stains. Fullerene directly removes active oxygen, thereby avoiding the effect of active oxygen on the skin. 3) Shrink pores: Fullerene can improve the problem of enlarged pores. Large pores are caused by excessive secretion of sebaceous glands, and large pores caused by enlarged cuticles around the pores. Such skin conditions can easily lead to blackheads and acne. Fullerene can restore the bowl structure caused by sunken pores, and restore the skin condition. 4) Remove wrinkles: For wrinkles, fullerene can prevent their generation and improve wrinkles. Fullerene can reduce the activity of MMP-9 (collagen decomposing enzyme) in the skin, thereby avoiding the breakdown and loss of collagen (basement membrane) in the skin.
Product Name: Tetrahydrocurcuminoids Other Names: THC INCI Name: Tetrahydrocurcumin Appearance: White powder Specification: 95% Molecular Formula: C21H24O6 Molecular Weight: 372.2 CAS No.: 36062-04-1 EINECS No.: 609-201-3 Supplier: ZHENYIBIO Tetrahydrocurcumin is a natural functional whitening material that can inhibit the generation of oxygen free radicals and scavenge free radicals in the finished product.Tetrahydrocurcumin powder has obvious antioxidant effects,such as anti-aging,repairing the skin,diminishing stains,removing spots,etc.Curcumin tetrahydrocurcumin has the same function as vitamin P and can increase vitamin C.Tetrahydrocurcumin (thc) for skin whitening effect.
INCI Name: FERULIC ACID Molecular Formula: C10H10O4 Molecular Weight: 194.18 Appearance: slightly yellow powder Purity: 98% CAS NO.: 1135-24-6 EINECS No.: 214-490-0 Application: cosmetics and skin care products Supplier: ZHENYIBIO Ferulic acid used in the skin care industry is mainly based on the whitening and antioxidant effects of ferulic acid. Ferulic acid can inhibit or reduce the proliferation activity of melanocytes.A 0.1-0.5% ferulic acid solution can make melanocytes,The quantity is reduced from 117�±23/mm2 to 39�±7/mm2;ferulic acid can also inhibit the activity of tyrosinase.A ferulic acid solution with a concentration of 5mmol/L can inhibit tyrosinase activity as high as 86 %. Even if the concentration of ferulic acid solution is only 0.5mmol/L,its inhibition rate of tyrosinase activity can reach about 35%.Ferulic acid also has the ability to scavenge oxygen free radicals and good anti-oxidation.Ferulic acid has sun protection ability.Ferulic acid can effectively absorb ultraviolet rays in the wavelength range of 290-330nm to prevent or reduce the damage of this wavelength of ultraviolet rays to the skin. Main Function: 1. Ferulic acid can protect skin against sun The chemical black name of ferulic acid is 4-hydroxy 3-methoxycinnamic acid. Among them, the commonly used sunscreen is "Ethylhexyl Methoxycinnamate (OMC)". Therefore, both of the cinnamic acid family, ferulic acid also has the effect of absorbing ultraviolet rays and sunscreen. It is also recognized as one of the sunscreens in Japan. 2. Ferulic acid can resist oxidation Ultraviolet rays will create a variety of free radicals with electrons on our skin, which will cause a series of cell damage and make the skin age down.This is photo-aging.Compared with general sunscreens, ferulic acid can also resist oxidation and eliminate free radicals. 3. Ferulic acid can be anti-inflammatory On the one hand, ferulic acid can cut off the key link in the inhibition of inflammation, such as affecting the metabolism of arachidonic acid, inhibiting the synthesis of prostaglandin PEG2, and can also calm the immune system and reduce the activation of mast cells, which can play an anti-inflammatory and anti-allergic effect. 4. Ferulic acid can whitening skin Tyrosinase is the most critical enzyme needed by melanocytes to produce melanin.Ferulic acid can inhibit the production and activity of tyrosinase,so as to achieve the whitening effect of reducing the production of melanin.
High Pressure Boiler Oxygen Scavengers Boiler Scale & Corrosion Inhibitor Sludge Conditioners Alkalinity Builders Boiler Phosphate Treatment Chemicals Steam Condensate Line Treatment Chemicals Fuel Additives & Anti-Foams Cooling Water Scale & Corrosion Inhibitors Cooling Water Biocides & Biodispersants Reverse Osmosis & Nano-Filteration Membrane Scale and Fouling Cleaners Reverse Osmosis Antiscalants & Antifoulants Reverse Osmosis Bicides Reverse Osmosis Corrosion Inhibitors Closed System Corrosion Inhibitors Closed System Biocides Descaling Chemicals
Astaxanthin is a carotenoid compound naturally found in marine organisms and is often used as an ingredient in health care products and cosmetics. Astaxanthin is a red fat-soluble carotenoid with a molecular formula of C40H52O4 and a molecular weight of 596.84. It exists in various marine organisms, including large yellow croaker, salmon, river shrimp, lobster, etc., and can also be extracted from certain microorganisms. Astaxanthin has high antioxidant properties and has a strong scavenging effect on free radicals, ROS (reactive oxygen species) and monocytes. Antioxidant effect: Astaxanthin is a powerful antioxidant that can reduce the production of free radicals and reduce the damage to cells caused by oxidative stress, helping to prevent various diseases and slow down the aging process. Cardiovascular protection: Astaxanthin can reduce cholesterol accumulation and oxidative damage, which is helpful in preventing atherosclerosis, hypertension and other cardiovascular diseases. Enhance immunity: The antioxidant properties of astaxanthin can enhance the function of the immune system, improve the body's immunity, and help prevent infections and diseases. Improve skin: Astaxanthin can improve skin elasticity and gloss by reducing the production of free radicals and stimulating collagen production, which is helpful in preventing skin aging and wrinkles. Relieve eye problems: Because astaxanthin can penetrate the tissue of the eye, it has a certain effect in protecting and relieving eye problems, such as reducing eye fatigue and improving vision.
Carbohydrazide based Oxygen scavenger for all type of boiler Price of product ( USD price or FOB price) : Contact Anglo Gulf FZCO sales representatives Product Origin : UAE Key Specifications/Special Features : pH : 5-6 Sp.Gvty: 1.0-1.2 Minimum Order Size and Packgaing details : MOQ: 1 ton Packaging: Jerry Cans/Drums
Oxygen scavenger for all type of boiler Price of product ( USD price or FOB price) : Contact Anglo Gulf FZCO sales representatives Product Origin : UAE Key Specifications/Special Features : pH : >10 Sp.Gvty: 1.0-1.2 Minimum Order Size and Packgaing details : MOQ: 1 ton Packaging: Jerry Cans/Drums
Water Treatment DEHA is used in Water Treatment Chemical Formulations for controlling corrosion in boiler very effectively due to its property of oxygen scavenge scores over conventional hydrazine hydrate since it is far less toxic and meets the standard for disposal of blow offs without any difficulty giving good protection against corrosion at the same time. Polymerization DEHA's powerful free radical scavenging ability coupled with its moderate volatility and relatively low order of acute toxicity makes it an ideal "po Polymer "/ vapour phase inhibitor for olefins or styrene monomer storage & recovery system. Because of its capability of inhibiting polymerlzatlot the gas phase, DEHA is finding use as an in-process inhibitor for the production of styrene, divinylbenzene, butadiene, isoprene and other monorr containing a reactive double bond. â?¢ Photographic Chemicals DEHA has reducing property, so it is used as an auxiliary chemical photographic developer for instant colour photos. Also, DEHA is effective in stabilization of image and in the prevention of discolouration. Decolourisation Phenol and Phenolic antioxidants can be decolourised with DEHA. Inhibitors DEHA also can be used as a colour stabiliser of monoalkyl phenol. Silicon Rubber DEHA can be used as a raw material for the hardener of the Silicon Sealant and coating agent. Storage Can be stored and handled in equipment made of stainless steel of Type SS304 or SS316 or steel lined with glass, polypropylene or polyethylene Storage in mild steel equipment or containers is not recommended. DEHA drums should be stored in a cool and well ventillated area, away from sources of ignition. Forms two layers for concerntration from 33 to 87 wt %. Packing 25 kg, 180 kg net wt. in HMHDPE carbouys & drums . Health &Safety DEHA is irritating to skin,eyes and the mucous membrane. In case of contact,affected area to be washed with plenty of water for atleast 15 minutes. In case of inhaltion,victim should be moved to fresh air and oxygen should be administered. In case of ingestion,victim should be made to consume copious quantity of milk and water. Medical advice should be sought at once. Personal protective equipment should always be used while handling.
