ADSS Preformed Short Span Tension Clamp
Tension clamps are designed to hold conductors and strands evenly to prevent conductor deformation. This product is designed for bare and stranded conductors and is recommended for use with plastic sheathed conductors.
Preformed Tension Clamp
ADSS tension clamps are designed to hold conductors and strands evenly to prevent conductor deformation. This product is designed for bare and stranded conductors and is recommended for use with plastic sheathed conductors. At the same time, the tension clamp can withstand at least 95% of the rated breaking strength of conductors and strands, and is made of high-strength materials.
Composition: twisted wire, rubber insert, cast aluminum shell, right-angle shackle, U-shackle.
Purposes: supporting cableï¼?make the ADSS hang on the tower.
Features:
1. Component: preformed wire, rubber inserting, casting aluminum shell, right angle shackle, U shackle etc.
2. Usage: supporting,make ADSS cable hang on the pole and tower.
3. Features: a, stress on average, no concentration stress, protect cable better and increase the stiffness of cable in the mount point. b, good dynamic stress. It can provide enough grip strength(10%RTS) c, rubber inserting make abrasion low. d. excellent aluminum alloy improve the mechanical and resist-corrosion function, extend life.
Technical requirements: meet the DL / T 766-2003 ADSS with the preformed helical fittings technical requirements and test methods..
Product Introduction This Machine is suitable for producing different sizes ofpaper straws, such as 5mm; 6mm; 8mm, 10mm etc. 1. Adopted with PLC controller, main motor is equipped with variable frequency speed regulation, touch screen man-machine interface.Easy for parameters setting & operating. 2. Cutting section adopted with numerical multi-blades cutting system.Servo synchronous tracking cutting system makes it higher precisionand multi-blades cutting makes it higher efficiency 3. Machine body and main spare parts made by stainless steel instead of painting. Ensure the hygiene and environmental protection of the products. Technical Parameter Unwind width 410mm Unwind diameter Ф 500 mm max. Rewind diameter Ф 450 mm max. Slitting width 13.5 mm min. Speed 1-100m/min Unwind roll clamping by air expanding shaft Rewind rolls clamping by air expanding shaft Tension control Closed-loop tension control Meter counting Automatic Deviation rectifying by Photoelectric eye Voltage 220v 3PHS 60Hz Operating person 1 person Main Motor 2kw Blades on machine 30sets Our service 1.Oneyear guarantee time. 2.Present a setof wearingpartsinwoodencasebefore delivering the machinefor free. If parts(except wearing parts)are broken within guarantee timethey will bechangedfor free. (it is not caused by human factor) The client should pay for the cost following: 1.Visa fee 2.Air ticket 3.Diet 4.Accommodation 5.Labor fee:50 USD/day (within guarantee time) 100 USD/day (without guarantee time)
Supplier: Polymeric Composite Insulator / Cutout Fuse/lightning Arrestor, Transmission And Hardware (stay Set,overhead Line Steelwork ,preformed Fittings,strain Clamp ,suspension Clamp,eye Bolt ,pigtail Hook,connector Fittings,fasteners ,protective Fittings,anchor Rod,galvanized Ground Rod/earth Rod ,terminal Connector And Cable Lug,splicing Fittings) Abc Cable Fittings(insulation Piercing Connector,dead End Clamp,suspension Clamp,pg Clamp,anchor Bracket,pre Insulated Sleeve) Hot Dip Galvanized Steel Strand Wire /stay Wire Electrical Safety Tools(insulating Gloves,rubber Insulating Boots,Portable Earthing Whole Sets,Discharge Sticks ,fiberglass Operating Sticks, Safety Climbing Harness /belt,pole Climber,Safety Helmet,Wire Grip Tightener)
