Ejx110A Ems4G-912En/ff1 Pressure Transmitter

Pressure Transmitter for Sandvik LH307/LH410

Notice 1. All the supplied products are provided with product certificates and instructions, including product number, technical parameters, wiring diagram,factory date, etc. Please check carefully to avoid misuse. 2. Installation should check whether the field interface is connected to the product according to the connection mode and thread type of the product.The mouth is the same. If it is a threaded interface, it should be tightened slowly and sealed carefully. Torque can not be added directly to the transmitter shell, but only on the six sides of the pressure interface. 3. The wiring should be strictly in accordance with the instructions of our company. 4.This product is a precise instrument. It is forbidden to disassemble, colide,fall,throw hard or punch the drainage hole with a sharp instrument. 5. The transmitter can work by electricity, but the preheating output is stable for 30 seconds. 6. If any abnormality is found in use, the power supply should be turned off, the use should be stopped, the inspection should be carried out, or contact our technical department direct. 7.When transporting and storing, the original packaging should be restored and stored in a cool, dry and ventilated warehouse. 8.The quality assurance period is 12 months. Intelligent Operation Method 1. LCD shows the output percentage or process pressure. Press the S key to select the display percentage or pressure.Press Z key to select pressure unit KPa or Mpa when displaying pressure. 2. Press S+Z key for 8 seconds, then release it at the same time, press Z key to set the zero value; Press the S key set the range. note: this function can only be triggered once an operation. 3. Adjustments to zeros or ranges may cause changes in the displayed options, i.e.The percentage being displayed becomes pressure or KPa becomes Mpa, etc. All these changes are shown only in the display, and have no effect on the internal parameters of the transmitter, pressure detection and current output. After adjusting the zero point and range, the S and Z keys can be used to select the desired percentage or pressure. 4. Zero-setting in field pressure-free state: 30 seconds after pressing S+Z key, the display shows zero time at the same time release the two keys, that is, zero. Simulated operation method 1.Zero-setting in pressure-free condition: The potentiometer with the word "zero" on the circuit board is adjusted to zero when it is displayed on the spot.(Note: Clockwise increase, counterclockwise decrease) 2.The potentiometer marked "range" on the circuit board can not be adjusted without standard pressure, so as to avoid the disorder of measurement range.

General Description The series of pressure transducers use imported high-quality pressure sensors and special integrated modules, through fine temperature, zero, full range, and non-linear compensation to achieve accurate measurement and transmission of pressure changes in liquid, gas, steam and other media. Technical Index Measuring medium: liquid, gas, steam Pressure range: -0.1MPA~0~60MPA Accuracy grade: ±0.2%FS, ±0.5%FS Stability: â?¤0.2%FS/year Temperature drift: â?¤0.02%FS/(range 0~70) Environment temperature: -20+85 Storage temperature: -20+85 Output signal: 4-20mA or 1-5VDC Supply voltage: 12-40VDC Allow overload: two times the quota voltage Explosiveproof grade: intrinsically safeia II C T6 flameproof dII C T6 Wetware material: 316 stainless steel and 1Gr18Ni9Ti Shell material: die casting alloy aluminum,surface epoxy spraying Pressure interface: M20X1.5 Weight: ordinary 0.75kg, with on-site instructions 1kg Structure Type x1 Connection x2x31 x4 The link mode and output signal of the compact tranmitter are as follows: Two-wire system: 1 Positive power supply 2 Negative power supply 3 Empty 4 Shell Three wire system: 1 positive power supply 2 Negative power supply (Negative sharing with signals) 3 Signal+ 4 Shell x5 The connection mode of aviation plug transmitter is as follows: Two-wire system(direct outlet type) 1 Red wire connection positive power supply 2 Black wire connection negative power supply Notice 1. All the supplied products are provided with product certificates and instructions, including product number, technical parameters, wiring diagram,factory date, etc. Please check carefully to avoid misuse. 2. Installation should check whether the field interface is connected to the product according to the connection mode and thread type of the product.The mouth is the same. If it is a threaded interface, it should be tightened slowly and sealed carefully. Torque can not be added directly to the transmitter shell, but only on the six sides of the pressure interface. 3. The wiring should be strictly in accordance with the instructions of our company. 4.This product is a precise instrument. It is forbidden to disassemble, colide,fall,throw hard or punch the drainage hole with a sharp instrument. 5. The transmitter can work by electricity, but the preheating output is stable for 30 seconds. 6. If any abnormality is found in use, the power supply should be turned off, the use should be stopped, the inspection should be carried out, or contact our technical department direct. 7.When transporting and storing, the original packaging should be restored and stored in a cool, dry and ventilated warehouse. 8.The quality assurance period is 12 months.

Compact structure, beautiful appearance Digital circuit High precision, high stability Strong anti-interference, good long-term stability Small volume, light weight, convenient installation and use Wide measuring range, can measure absolute pressure, gauge pressure Variety choice of processes and electrical connection Suitable for mass production, economic and reliable Measure range: -100KPa~0~10KPa~100Mpa Pressure type: gauge pressure, absolute pressure Power supply: 24VDC, 12VDC Output signal: 4-20mA, 1-5V, 0-5V Temperature compensation: -10~70 Working temperature: -20~85 Storage temperature: -40~125 Zero temperature drift: ±1.5%FS Sensitivity temperature drift: ±1.5%FS Overload: 150%FS Mechanical vibration: 20g(20-5000HZ) Accuracy: ± 0.5%FS ± 0.25%FS Response time: 1ms(Up to 90%FS) Load resistance: (U-15)/0.02Ω Material: Stainless steel case; internal 316L sensor Media compatible: Media compatible with 316L stainless steel Protection grade: IP65

PTX201 is suitable for measurement of liquid or gas pressure, even for difficult media such as contaminated water, steam and mild corrosive fluids. >All stainless steel construction >Excellent load cycle stability and shock resistance >4~20 mA, 2-wire output >Ranges up to 400 barg >DIN 43650 plug-in connector >Higher ranges on request >Integral LED or LCD display

PTX201 is suitable for measurement of liquid or gas pressure, even for difficult media such as contaminated water, steam and mild corrosive fluids. >All stainless steel construction >Excellent load cycle stability and shock resistance >4~20 mA, 2-wire output >Ranges up to 400 barg >DIN 43650 plug-in connector >Higher ranges on request >Integral LED or LCD display

Yamatake Pressure Transmitter A&S Transmitter Co., Ltd. provide all types of Azbil/Yamatake pressure transmitters: Yamatake Pressure Transmitter AT9000 Advanced Transmitter Model GTX Differential Pressure Transmitter/Pressure Transmitters AT9000 Advanced Transmitter SuperAce Yamatake Pressure Transmitter PREX3000 Yamatake Pressure Transmitters Yamatake differential pressure transmitter Yamatake Temperature Transmitter Yamatake level Transmitter Yamatake flow transmitter Yamatake wireless pressure transmitter Yamatake gauge pressure transmitter Yamatake steam pressure transmitter Yamatake pneumatic differential pressure transmitter Yamatake hydraulic pressure transducer Yamatake electronic pressure transmitter Yamatake high temperature pressure transmitter Yamatake low pressure transmitter Yamatake digital pressure transmitter Yamatake smart pressure transmitter Yamatake explosion proof pressure transmitter Yamatake static pressure transmitter Yamatake sanitary pressure transmitter Yamatake miniature pressure sensor Yamatake remote seal pressure transmitter Yamatake gauge pressure transmitters Examples of model we can offer: Yamatake Temperature Transmitter ATT60, Yamatake Temperature Transmitter ATT70, Yamatake Temperature Transmitter ATT 90, Yamatake Temperature Transmitter ATT9X,ect. More brands we offer: Honeywell pressure transmitter Rosemount pressure transmitter Dwyer pressure transmitter Foxboro pressure transmitter Emerson pressure transmitter Danfoss pressure transmitter Yokogawa pressure transmitter Yamatake pressure transmitter Fuji pressure transmitter Siemens pressure transmitter Dynisco pressure transmitter Hydac pressure transmitter ABB pressure transmitter E+H pressure transmitter Wika pressure transmitter Ashcroft pressure transmitter Murphy pressure transmitter Sitrans pressure transmitter Vega pressure transmitter Anderson pressure transmitter Keller pressure transmitter Modus pressure transmitter Noshok pressure transmitter Ametek pressure transmitter Druck pressure transmitter Taylor pressure transmitter Setra pressure transmitter Sensym pressure transmitter Jumo pressure transmitter DP pressure transmitter Fisher pressure transmitter Bourdon haenni pressure transmitter Huba pressure transmitter Gems pressure transmitter Trafag pressure transmitter Meas pressure transmitter

HYDAC pressure transmitter A&S Transmitter Co., Ltd. provide all types of HYDAC pressure transmitters: HYDAC pressure transmitter HDA 4100, HYDAC pressure transmitter HDA 4300, HYDAC pressure transmitter HDA 4400, HYDAC pressure transmitter HDA 4700, HYDAC pressure transmitter HDA 7400, HYDAC pressure transmitter HDA 8400, HYDAC pressure transmitter HDA 8700, HYDAC pressure transmitter HDA 4800, HYDAC pressure transmitter HDA 9300,etc. Except HYDAC Temperature Transmitter, other brands we can offer are listed as below: Honeywell pressure transmitter Rosemount pressure transmitter Dwyer pressure transmitter Foxboro pressure transmitter Emerson pressure transmitter Danfoss pressure transmitter Yokogawa pressure transmitter Yamatake pressure transmitter Fuji pressure transmitter Siemens pressure transmitter Dynisco pressure transmitter Hydac pressure transmitter ABB pressure transmitter E+H pressure transmitter Wika pressure transmitter Ashcroft pressure transmitter Murphy pressure transmitter Sitrans pressure transmitter Vega pressure transmitter Anderson pressure transmitter Keller pressure transmitter Modus pressure transmitter Noshok pressure transmitter Ametek pressure transmitter Druck pressure transmitter Taylor pressure transmitter Setra pressure transmitter Sensym pressure transmitter Jumo pressure transmitter DP pressure transmitter Fisher pressure transmitter Bourdon haenni pressure transmitter Huba pressure transmitter Gems pressure transmitter Trafag pressure transmitter Meas pressure transmitter