General Description

The series of pressure transducers use imported high-quality pressure sensors and special integrated modules, through fine temperature, zero, full range, and non-linear compensation to achieve accurate measurement and transmission of pressure changes in liquid, gas, steam and other media.
Technical Index

Measuring medium: liquid, gas, steam

Pressure range: -0.1MPA~0~60MPA

Accuracy grade: ±0.2%FS, ±0.5%FS

Stability: â?¤0.2%FS/year

Temperature drift: â?¤0.02%FS/(range 0~70)

Environment temperature: -20+85

Storage temperature: -20+85

Output signal: 4-20mA or 1-5VDC

Supply voltage: 12-40VDC

Allow overload: two times the quota voltage

Explosiveproof grade: intrinsically safeia II C T6 flameproof dII C T6

Wetware material: 316 stainless steel and 1Gr18Ni9Ti

Shell material: die casting alloy aluminum,surface epoxy spraying

Pressure interface: M20X1.5

Weight: ordinary 0.75kg, with on-site instructions 1kg
Structure Type

x1
Connection

x2x31
x4

The link mode and output signal of the compact tranmitter are as follows:

Two-wire system:

1 Positive power supply

2 Negative power supply

3 Empty

4 Shell

Three wire system:

1 positive power supply

2 Negative power supply (Negative sharing with signals)

3 Signal+

4 Shell
x5

The connection mode of aviation plug transmitter is as follows:

Two-wire system(direct outlet type)

1 Red wire connection positive power supply

2 Black wire connection negative power supply
Notice

1. All the supplied products are provided with product certificates and instructions, including product number, technical parameters, wiring diagram,factory date, etc. Please check carefully to avoid misuse.

2. Installation should check whether the field interface is connected to the product according to the connection mode and thread type of the product.The mouth is the same. If it is a threaded interface, it should be tightened slowly and sealed carefully. Torque can not be added directly to the transmitter shell, but only on the six sides of the pressure interface.

3. The wiring should be strictly in accordance with the instructions of our company.

4.This product is a precise instrument. It is forbidden to disassemble, colide,fall,throw hard or punch the drainage hole with a sharp instrument.

5. The transmitter can work by electricity, but the preheating output is stable for 30 seconds.

6. If any abnormality is found in use, the power supply should be turned off, the use should be stopped, the inspection should be carried out, or contact our technical department direct.

7.When transporting and storing, the original packaging should be restored and stored in a cool, dry and ventilated warehouse.

8.The quality assurance period is 12 months.