Sln Ratchet Tie Down

Digital Trainer is intended for elementary as well as advance training of Digital electronics and for bread board digital circuits, AND, OR, NOT, NAND, NOR, XOR, Three State Buffer, RS Latch, JK Flip Flop, Monostable Multibrator. and UP/ DOWN Counter. Practical experience on this board carries great educative value for R & D labs, Science and Engineering Students. Specifications: 01. Breadboard : Solderless Bread board with 1680 inter connected Tie Points 02. Pulse Switches : 2 No?s. Bounce free push buttons 03. Logic Switches : 8 logic level Switches in Dip type . 04. Power Supply : Fixed: +5V at 750 mA 5. Power Sockets : Logic Probe Power Supply Sockets 06. Logic Input : 8 LED buffered logic level indicators 07. Variable Clock : Fine adjustment of clock frequency. Clock range selection L : 10 ? 40 Hz, H : 1K ? 20K Hz. 08. Jacks : 2mm to BNC Socket 2 No. 2mm to 4mm Socket 2 No.

Supplier: Pressed sheet metal components, assemblies and machined components, Metal Fittings for Harness and Fall Arresters, Cargo Lashing/Tie Down/Ratchet Lashings

Supplier: Shackles, turnbuckles, thimbles, wire, rope grips, hooks and links, pulley blocks, alloy fitting, load binders, eyebolts and nuts, chains, webbing slings, ratchet tie downs, ropes, hoists, steel wire ropes

CHARACTERISTICS 1. The vacuum arc extinguishing chamber uses longitudinal magnetic field arc extinguishing technology, which has the characteristics of long electric life and high reliability. 2. The imported silicone rubber/epoxy resin for outdoor use and the present APG vacuum injection technology are adopted. 3. Anti-ultraviolet, moistureproof, anti-corrosion, with the advantages of preventing surface discharge, good hydrophobicity and high mechanical strength. 4. Using simple and reliable spring operating mechanism, it has the advantages of small size and light weight. 5. high voltage vacuum circuit breaker can be equipped with isolation switch and three-phase linkage. It has visible breaks when the isolation switch is switched off. It also has anti-mistake interlock between the isolation switch and the circuit breaker body. It can be equipped with arrester strut insulators. Operational sequence When operating the disconnector, the first step is to confirm that the circuit breaker should be in the open state. Use the insulated tie rod hook to fasten the closing pull ring or the opening pull ring of the operating handle of the isolation closure, pull down slightly, drive the spindle to rotate, open or close the isolation switch. When the spindle rotates the dead point position of the compression spring, a certain tension is maintained so that the blade can be reliably closed or opened to a safe isolation position.

Supplier: Metal products including wrought iron components, railheads, gate bushes/collars, baskets, spheres, scrolls, balusters, bars, gate panels, rosettes, leaves, flowers, post caps and bases, agricultural machinery parts, harrow discs, loader tines, rigging hardware, steel wire rope, shackles, clips, eyebolt, eyenut, hooks, loadbinders, ratchet tie down, webbing slings, forging parts, casting parts
Services: Export

A demister, or also known as mist eliminator, is a high efficiency separation device often fitted to vapor liquid separator vessels to enhance the removal of liquid droplets entrained in a gas or vapor stream. Demisters may be a mesh type coalescer, vane pack or other structure intended to aggregate the mist into droplets that are heavy enough to separate from the vapor stream. Mist eliminators/ demisters are fabricated from knitted materials with interlocking asymmetrical loops of metal or plastic with typical diameters being 0.1 – 0.3mm. Special applications for wire diameter 0.35mm to 0.024mm, tube width 1/4" to 42" diameter. 2.DEMISTER Materials: Stainless Steel wire: 200, 300 and 400 series-AISI201?202?301?302?304?304L?321?316?316L,410S, etc. Copper wire, Aluminium wire, Nickle wire, Titanium wire, Inconel, Monel, Hastelloy wire... Plain Steel, Galvanized Steel... Polypropylene, Polyethylene, PVC, Teflon(PTFE), Nylon, etc. Stainless steel wire with cotton thread, fiber glass, etc. 3.FIXING METHODS&GRID The demister should be horizontally fixed and supported. At the bottom or both the top and the bottom, a support grid which is welded with FB 25X3t, RB6Ø of the same material as that of the demister pad at proper intervals (APP150mm), is used. For fixing the grid and the pad, RB6Ø or 1.6Ø tie wire is used. 4.DEMISTER FEATURES (Mesh Pad type) 1).It shows 99% efficiency under general conditions and velocity (1~3m/sec or higher). 2). Over 98% open area is guaranteed under any conditions so pressure drop caused by the use of the demister can be disregarded (0.1”~1.0 W/G). 3). It can be made of any material suitable for the given temperature and corrosion-resistance. 4). It is possible to install by use of M/H so it is easy to handle. 5). There is no restriction in the conditions, place, and size for use. It is install-able on the existing systems. 6). Self-cleaning is possible. It is semi-permanent so it is economical. 5.USE OF DEMISTER 1).Vacuum Tower - The treatment quantity by the demister goes up by 35%. The quality of oil gas is improved. 2). Absorber - Some gasoline plants use a glycol absorber (Demister mounted) so the installation cost is being repaid within a month. 3). Knockout Drums and Separators - If Demister is used, ?inch drum is sufficient. 4). Gas Separator Vessels - Hydrocarbon in gases is collected so gas of 1/0.1 billion purity is produced out. 5). Evaporator - Product loss goes down and purity is remarkably improved. 6). Scrubber - In the field of caustic soda, the demister is used to prevent air pollution. 7). Distillation Column - If Demister is used, the cost for distillation goes up, the quantity of treatment increases by 20%, and purity is remarkably improved. 8). Dust Collectors - The dust collector of a wet type has excellent collection capacity.g is possible. It is semi-permanent so it is economical.

Supplier: Lifting & Hoisting Equipment, Webbing And Round Sling, Ratchet Tie Down And Lashing Equipment, Chain & Chain Sling, Wire Rope And Wire Rope Sling, Material Handling, Rigging Hardware & Marine Hardware Grade 80 Alloy Chain Accessories Turnbuckle, Shackle, Wire Rope Clips, Load Binder, Eye Bolt And Nuts, Thimble, Hook, Quick Link, Snap Hooks, Block, Anchor, Wire Rope, Stainless Steel Products

Supplier: Lifting and hoisting equipment, webbing and round sling, ratchet tie, chain and chain sling, wire rope and wire rope sling