Pultrusion mold
Pultrusion die for continous molding of fibre - grp. Die is maintained at different heat zones using precesion pid controller.
Pultrusion machine
This machine is suitable for producing g.R.P. (glass reinforced plastic) sections in different shapes & sizes like angle sections, 'c' channels, hollow rectangular and circular-tube sections, solid rods etc.
Specifications :
Pulling capacity : 2000kgf to 10000 kgf.
Pulling speed : 0.08 mtr/min. To 2.1 mtr/min.
Die clamping bed : 1000 mm x 1100 mm
Carriage size : 600 x600 to 1000x800 mm.
Grippers : 2 or 3 nos / carriages.
Carriage movement : by hydraulic power.
Clamping force by pneumatic system
Electrical power required : 2.0 to 7.5 kw for hydraulic power pack
Heating requirement (depending up on size of mould)
Compressed air required : approx- 10-12 cfm, & 5 -6 kg/sq.Cm pressure.
Accessories :
Glass roving (creel) stands, roving guides, perform guides, resin impregnation bath, resin pressure injection system, glass mat roll feeding station, automatic section cutter, section conveying roller table, glass mat slitter & pultrusion mold
Automatic section cutter
Common cutting length for all sections in diff. Grippers
Consisting of electrodopised diamond cutting blade of dia. 400 mm,
Pneumatic clamping of section while cutting
Pneumatically traveling table & cutter arm.
Plc controlled panel for control and synchronization with machine,
Electrical req. 1.5 kw.
Compressed air req. 6-8 cfm at 50 pai. Maxi.
