Plastic mould
1.The mould use the ice water to cool and recycle, which can promote the efficiency of moulding
2.To make pc.Pet helmet lens needs strong experience, especially for the polishing of mould lens surface
3.The mould cavity of pc.Pet helmet lens mould is made of the imported s136 materials and treaded by chrome plating. To assure the polishing and wear resistance of products
4.The moulding runner should pour via sides of trapezoid shape to avoid cool materials, with 95kgs pressure , 245f¦ temperature and 20s for moulding time
5.The time for finishing mould is 60 days and the price is rmb 38, 000
Accumulator mould
1.Because of low cost, big capacity and cheap price, the pb-acid accumulator used widely, but if used in a wrong way, its life would be reduced too much . There are many factors which can affect the life of accumulator, but to charge the battery in a correct way can increase the life of accumulator. According to the research, the process of charging the battery has big influence on its life but the process of discharging the battery has little influence on its life, that is to say, the accumulator become bad is not because of normal usage but because of charging. Therefore , a good accumulator has played big role in the life for battery.
2.The accumulator contains 3 sets. The accumulator mould cavity is made of sweden 2738 materials to assure its polishing and wear resistance
3.The point gate of mould runner , with 100kgs pressure ·+210f¦ temperature and time of 55s.
Industrial dust collector mould
1.The basic requirement of dust collector has strong suction, strong percolate ability and permanence.
2.The mould contains 10 sets, thereinto, industrial dust collector mould is made of the imported 718h materials and to assure of its polishing and wear resistancef·the dust collector suction should coordinate and be effective to reduce noise.
3.The product use recycled flowing water to assure high efficiency of mouldf·
4.Side pin gate of the mould runner with s shape to pour the ends to avoid cool materials, with 75 kgs pressure, 195f¦ temperature and time for 45s.
5.The time for finishing mould is 45 days and the price is rmb 220, 000
Electric kettle mould
1 two sides glide plates of electric kettle mould were designed to pull thick stick , which is a high efficiency in the production
2·½the product use recycled flowing water to assure high efficiency of mould.
3·½to make electric kettle mould need a strong experience, especially the scale of withdraw in moulding.
4.The mould runner with vertical gate, within 95kgs pressure, 195f¦ temperature and time for 45 seconds.
5.The time for finishing mould is 30 days and the price is rmb 160, 000
Exercise tools
1.The cavity mould of exercise tools for golf and baseball is made of imported 718 materials to assure of its polishing and wear resistance. The mould of the exercise tools for golf and baseball should coordinate and be with high degree of accuracy for serving a ball.
2.The product use recycled flowing water to assure high efficiency of mould.
3.Side gate of the mould channel with s shape to pour the ends to avoid cool materials, with 75 kgs pressure, 195f¦ temperature and time for 45 seconds.
4.It would take 60 days to finish the mould, and price of it is rmb220, 000.
