Ejector pin is the of the injection molding world. They apply a force to eject a part from the mold, and in some cases can leave marks. We are to design and position pins to minimize their effect on your parts. You can apply this product to release elasticity from bottom. And the features of the product are that it can adjust to required eject height in advance and it is easy to install.
product information
Material
SKD61
Inner Hardness
HRC43
HRC52
Surface Hardness
HV1000
HRC52
Heat Treatment
Nitrided
Vacuumed
Attentions given by positioning component supplier who wholesales high quality positioning component:
Remember the following points as you position multiple components:
All the components are positioned together without any relative movement between one another.
You can define constraints for multiple components in the same manner as you do for a single component.
You can add one or more components for positioning even as the Position tool is active. The added component immediately gets the transformation that the other components are sharing.
If you have selected 2 or more components for positioning, you cannot deselect any of them until they are positioned.
You can move and reposition multiple components as one unit using the handles of the dragger. While dragging a linear handle, you can snap the components to a geometric reference and constrain them.
If you add one or more components to a positioned multiple-component set, any constraints that were applied earlier while positioning the components are clear.
Material Hardness Heat Treatment
