Hydraulic Oil Pump
Rated pressure:10000psi
Flow rate at 1500rpm:0.64L/min
Inlet port:1/2 FNPT
Outlet port: 1/4FNPT
This pump is a plunger pump, it needs to be driven by a motor and recommend using electric motor. It requires very little power, so solar energy can be used as an energy source for its motor. These pumps are used on wellhead control panel systems, Power packs on high-torque service tools. The pump application medium is hydraulic oil and it needs to be installed at a lower position than the tank. Before staring the pump, you must vent the air in the pump chamber.
Pilot operated valve
Body Material: 316SS
Ports: 1/4 FNPT
3 way normal closed
The NC valves are normally closed, block and bleed valves. Controlled by a pressure signal applied to a small integral pilot pistion that actuates the valve.
The NO valves� are normally opened, block and bleed valves. Controlled by a pressure signal applied to a small integral pilot pistion that actuates the valve.
Quick Exhaust Valve
Work pressure: 10000psi
Ports: 1/2 FNPT
Media: hydraulic
The quick exhaust valve is designed to rapidly bleed the control pressure from an actuator or other device. It is typically used on safety valves, control valves, or other devices that must respon quickly when the control signals are removed. It is easy to install and maintain. No special tools are needed for repair and assembly.
Ball Valve
Work pressure: 15000psi
Ports: MF4
Type: 2 way
Relief valve
Material: 316SS
Metal seat
Set pressure range: 30000-45000psi
Orifice: 2.4mm
AHP03 series single drive single acting
MAX.OUT PRESSURE: 8800PSI
DISPLACEMENT VOLUME/CYCLE: 1.0ML
MAX.FLOW RATE:0.64L/MIN
INLET PORT:3/8 FNPT
OUTLET PORT:1/4 FNPT
