Steel coils Packed on wooden pallets
CRGO Hi All,
CRGO scrap from South Korea. Monthly 200MT available.
CRGO - 0.30 Regular and 0.30 Jumbo materials available. For rates and pictures please contact
CRGO eletricl steel in the form of coils, sheets, leftovers, end rolls, oily/fresh offcuts. The material having thickness og 0.23mm, 0.27mm, 0.30mm consisting of grade M3, 23ZDKH, M4, 27ZDKH, M0H, M5. Container load basis
we offer china origin secondary crgo coils Thickness:0.23~0.3mm Width:900~1000mm
Steel coils We are looking for suppliars of second grade steel products, if you have any of second grade flat/long/round steels products.Used machinery parts, ferrous/non ferrous.
Core steel plate Specification for core steel plate 1.0Scope 1.1 this specification covers the grain oriented electrical steels are iron-silicon alloys that provide Low core loss and high permeability needed for more efficient and economical electrical Transformers. Cold rolled grain oriented (crgo) grades of electrical steel are typically used For transformer cores and large generators. 2.0Application 2.1 the cgro is used regularly for cores in transformers. 3.0Standard 3.1 this specification is prepared by taking guidance from bs 601:1973 4.0Material 4.1 cold rolled grain oriented (crgo) grade m5, moh, zdkh as per bs 601:1973 and Equivalent to jis c 2553 5.0Properties 5.1 specifications and typical electrical and magnetic properties (see appendix 1) 6.0Dimension and tolerance 6.1 dimension : as per the purchase order with the tolerance as given table below Tolerance on width Nominal width (mm) OverUp to and includingTolerance (mm) 0150+ 0 0.3 150500+ 0 0.5 001000+ 0 1.5 Tolerance on length Nominal width (mm) OverUp to and includingTolerance (mm) 02000- 0 + 1.5 2000>2000- 0 + 2.0 Tolerance on length The tolerance on the mean thickness, measured by contact micrometer, for any coil shall be + 0.03 mm from the nominal thickness. Tolerance on edge burr The tolerance on edge burr not to exceed 0.05mm. Tolerance on edge camber Edge camber is the lateral departure of the edge of the strip from a straight line forming a chord, refer figure a: Tolerance on edge camber of strip in coil shall not exceed 2 m in 2000 mm and shall be measured against a straight edge using a 2000 mm length cut from a coil. 7.0References (1) bs 601: 1973, steel sheet and strip magnetic circuits of electrical apparatus. As provided above
