Features: Safer than normal lifting magnets by pretesting lifting safety. In some complicated situations it is difficult to estimate the actual lifting value with enough safety coefficient and consequently you are not sure if the lifting operation is safe or not, then you can take the following steps to get a safer lifting operation. 1. Place the lifting magnet at the load. 2. Turn the handle counterclockwise to the vertical position. 3. Insert the tip of the screw driver shipped with the lifting magnet into a small hole at the yellow cover to hold the handle in the position. 4. Lift the lifting magnet and the load 2¡±-3¡± from the floor. 5. If the load can be lifted, place the load back onto the floor. 6. Take off the screw driver and turn the handle to ON position. The handle is locked by the slide pin. 7. Lift the load again. This time the safety coefficient is 2 at least.
We have strong sintered AlNiCo permanent magnet production scale, can produce the performance of Alnico2-8 grades. And annual output nearly 800 tons. AlNiCo magnet is suitable for producing complex, light, thin, and small products, and is widely used in instrumentation, communications, magnetoelectric switches, and various sensors. AlNiCo products are mainly used in automotive parts, instrumentation, electroacoustics, motors, nuclear power, teaching, aerospace and other fields. It has the characteristics of low temperature coefficient, high temperature resistance, humidity resistance, not easy to oxidize and good working stability.
Description : The most powerful magnets commercially available Manufactured by a powder metallurgical process involving the sintering of powder compacts under vacuum Grinding and slicing possible Very reactive with moisture and oxygen A variety of Coatings can applied depending on the environment of the application Applications : various types of electric motors, engineering equipment, medical equipment, audio apparatus and household appliances
Description : Plastic-bonded magnets are particle composites with permanent-magnet powder embedded in a plastic binder. Hard ferrite (HF), various SmCo and NdFeB powders and, to a very little extent, AINiCo alloys are used as magnetic powder. For embedding the magnetic particles, thermoplastic binders as, for instance, polyamide (PA) or polyphenyl sulfide (PPS) and duroplasts like epoxy resins are used. Depending on the material composition and production process, isotropic and anisotropic magnets with differing magnetic and mechanical specifications are available. Since not only the type of magnet or plastic material, but the filling and alignment degree, too, determine the composite`s properties, the outcome is widely varying magnetic parameters and an outstanding variety in types and shapes.
Halbach array is a special arrangement of permanent magnets that augments the magnetic field on one side of the array while cancelling the field to near zero on the other side.[1] This is achieved by having a spatially rotating pattern of magnetisation. The rotating pattern of permanent magnets (on the front face; on the left, up, right, down) can be continued indefinitely and have the same effect. The effect of this arrangement is roughly similar to many horseshoe magnets placed adjacent to each other, with similar poles touching.
Payment: t/t, l/c Delivery: 25 days after order confirmation Package: standard package or as you required. We provide customised products for you.