1)surge protector with usb charging output: 5v/2.1a
2) max 175j surge protection /6000amps peak current to protect your sensitive devices
3) 7colors
4) saa certification
5) usb charging port perfectly allow to charge iphone/ipod and other digital prducts
We supply all kind of materials and accessories pertaining to earthing and lighting protection-class a.B, c and d.
It includes-copper strips, copper tapes, clamps, wires etc
We also supply a new kind of maintenance free earthing and lighting prevention equipment.
Telecom PTC Thermistor Description
This series of ceramic PTC (positive temperature coefficient ) thermistors help provide protection against power cross, power induction surges and lighting surge defined in ITU, Telcordia, UL. Available in chip, radial-leaded coated and non-coated, SMD, twin vertical surface mount configuration. PTC thermistor overcurrent protector provides reversible, self-resetting protection against over-currents of telecommunication line protector units, improve the reliability of custom premises and network equipment.
Ceramic PTC thermistors can be found providing re-settable line protection at the exchange, monitoring hot spots and protecting ringers, battery feeds, transformers and relay circuits. Also used extensively to protect the mobile phone's battery pack against overcharging in land-based and radio mobile communications.
Advanced developments in telecom equipment in recent years have radically altered the protection requirements of both exchange and subscriber equipment. The PTC thermistor must protect the telephone line circuit against overcurrent, which may be caused by the following examples:
Surges due to lighting strikes on or near to the line plant.
Short-term induction of alternating voltage from adjactent power lines or railway systems, usually caused when these lines or systems develop faults
Direct contact between telephone lines and power lines.
To provide good protection under such conditions, a PTC thermistor is connected in series with each line, usually as secondary protection; However, even with primary line protection (usually a gas discharge tube), the PTC thermistor must fulfill severe requirements.
Surge pulses of upto 2KV can occur and in order to withstand short term power induction, the PTC thermistor must withstand high voltages. If the line has primary protection, a 220V to 300V PTC thermistor is adequate. Without primary protection, 600V PTC device is necessary. We can manufacture a series of PTC thermistor fulfilling both requirements.
Typical Application of PTC Thermistor in Telecommunication Protection
Central Office Switching Equipment (C.O), analog and digital line cards, T1/E1 equipment, xDSL modems and splitters, multiplexers, CSU/DSU, servers.
Primary Protection Modules, MDF (main distribution frame) modules, network interface devices (NIC).
Custom Premises Equipment, also known as subscriber terminal equipment (T.E.), IT equipment: Modem, phone sets, fax machines, phone wall outlet (plugs), alarm systems, answering machine, PBX systems, ADSL Splitters, internet appliance, POS terminals.
Access Network hardware, LAN WAN equipment, Powered Ethernet systems, VoIP (voice over IP equipment), Set-top box (S.B), etc.
Telecom PTC Thermistor Features
Compliant with ITU-T K20 K21 K45
Basic level lightning surges (10/700ª¦s)
Basic level power Induction (600V,1A,0.2S)
Power contact criteria A/B (230V,15min.)
Suitable for continuous connection to main voltage 110/230 VAC in tripped (high ohmic) condition.
Low voltage electric power under 600v AC for apartments or residences are
Generally used without tvss (transient voltage surge suppressor). These dangerous conditions cause unexpected troubles, breakdown & failure to electric and/or electronic circuits and parts by variety of electric shocks in combination waves with over-voltage and over-current. Actually, damage by surge or transient due to lightings or switching power is increasing continuously.
GNS Koreas TVSS(SPD) keeps all sorts of electrical/electronic devices, every kind of facility and equipment & life safely from the dangerous electric power quality caused by induced lighting, transient or surge incoming to electric facilities or equipments.
800_080
BT P B80 385 RM
Main Features:
* Small volume, high discharge capacity
* Reliable protection thanks to double control disconnector
* Quick response
* Low voltage protection level and with double terminals connection
* Green window will change when fault occur, also in the same time provide remote alarm terminal
* Core components are from international well known supplier
Application:
This product is designed to protect low voltage devices from surge damage, used in power supply system such as power distribution-room, distribution-cabinet and other important power supply system. Widely used to protect mobile communication station, telecommunication centre, civil aviation, finance, and so on.
Specifications:
Technical data
Rated voltage
(max. continuous voltage) Uc 385V
Nominal discharge
current(8/20) In 35kA
Max. discharge current Imax 80kA
Voltage protection level
at 20kA Up í_1.8kV
Response time tA í_25ns
Operating
temperature range -40íµí¡+80íµ
Cross-sectional area 1.5mm2~25mm2(solid)/35mm2(flexible)
Mounting on 35mm DIN rail
Test standards GB 18802.1-2002; IEC 61643-1:1998-02
Applications:
Designed for monitor device not to be spoiled by lightning over-voltage, induced over-voltage and static discharge.
Video camera
E1, pdh, sdh, spdh
Digital hard disk video cassette recorder
Industrial control
Features:
Multi. Protection circuits, gas-tube+ tvs technology
Dual protection in common module and different module
Tvs array technology, low capacitance
Multi-strike capability
Specifications:
Type d12bf d12bf-4d12bf-16
Electrical specifications
Impedance75++
Max operating voltage12v
Nominal discharge current (8/20++s)3ka
Max. Discharge current (8/20++s)5ka
Protection level (3ka 8/20++s)
Line to line40v
Line to pe160v
Adapt transmission rate100mbps
Insertion lossf 0.5db
Response time f 5ns
Mechanical specifications
Connectorbnc female to malebnc female to female
Number of protection ports1416
Diamension (mm)82.7*25*25130*73*25 481*84*47
Working environments
Operating temperature minimum-40
Operating temperature maximum85
Operating humidity95%
Applications:
Designed for monitor device not to be spoiled by lightning over-voltage, induced over-voltage and static discharge.
Video camera
E1, pdh, sdh, spdh
Digital hard disk video cassette recorder
Industrial control
Features:
Multi. Protection circuits, gas-tube+ tvs technology
Dual protection in common module and different module
Tvs array technology, low capacitance
Multi-strike capability
Specifications:
TypeD12bfD12bf-4D12bf-16
Electrical specifications
Impedance75+
Max operating voltage12v
Nominal discharge current (8/20s)3ka
Max. Discharge current (8/20s)5ka
Protection level (3ka 8/20s)Line to line40v
Line to pe160v
Adapt transmission rate100mbps
Insertion loss_0.5db
Response time _5ns
Mechanical specifications
ConnectorBnc female to maleBnc female to female
Number of protection ports1416
Specification:
Square : 22mm
Voltage : 130v ac (rms)
IN : 7.5ka
Imax : 15ka
Application : specially used for power strip or socket
Features:
With built-in thermal cutoff (thermally protected)
Two types : square and round type
Used for power strip
Different size : 8 to 34mm
Peak current (8/20) : 3 to 40ka (maximum)
Certificates : 1449 3rd, T & UUML.
Applications:
Designed for Ethernet device not to be spoiled by lightning over-voltage, induced over-voltage and static discharge.
CAT6, CAT5e and CAT5 compatible
10/100/1000 Base-T Gigabit Ethernet protection
LAN, FDDI, CDDI, ATM
PDH, SDH, SPDH
Industrial control
Features:
Multi. Protection circuits, Gas-Tube+ TVS technology
Dual protection in Common module and different module
TVS array technology, low capacitance
Multi-Strike Capability
Specifications:
TypeD05J4D05J8HD12Y4D36Y2
Electrical Specifications
Max operating voltage5V5V12V36V
Nominal discharge current (8/20»s)3kA2kA3kA3kA
Max. discharge Current (8/20»s)5kA3kA5kA5kA
Protection level (3kA 8/20»s)Line to line25V25V40V60V
Line to PE160V
Adapt transmission rate100Mbps1000Mbps10Mbps10Mbps
Insertion Loss_0.5dB
Response time _5ns
Mechanical Specifications
ConnectorRJ45
Protection Lines 1,2 & 3,61,2,3,4,5,6,7,84 lines2 lines
Form Size(mm)83 * 25 * 25 90 * 14 * 63
Working environments
Operating Temperature Minimum-40
Operating Temperature Maximum85
Operating Humidity95%
Item Material laminated
Usage/Application hospital
Products in the Kit yes
Nature of Suit Disposable
Material PPE
Size S,M,L,XL,XXL etc.
Disposability Disposable
Pattern Plain
Packaging Type Poly Bag
Usage/Aplication Protection From Covid-19
Brand Protectmed
Color White
We are offering Disposable PPE KIT to our Clients We are leading manufacturers Disposable Product
Material PP Non Woven
Disposability Disposable
Size S,M,L,XL,XXL
Pattern Plain
GSM 45 GSM
Brand Protectmed
Wash Care Machine Wash
Color White
Packaging Type Poly Bag
We are offering Disposable PPE KIT to our Clients We are leading manufacturers Disposable Product
Minimum Order Quantity 100 Piece
Item Material laminated
Brand protectmed
Products in the Kit yes
Nature of Suit Disposable
Usage / Application Hospital, Personal Protection
Gender Unisex
Disposability Disposable
Country of Origin Made in India
We are offering Disposable Coverall Suit to our Clients We are leading manufacturers Disposable Product
Supplier From
Hong Kong,
South Korea (Republic Of Korea)
Russia and non russia oil and gas (kazakhstan, qatar, netherlands) oil and gas products such as en590 10ppm, d6, jet fuel a1 & 54, lng, lco, ago, d2, espo, pet coke, sulphur, urea 46 granular/prilled and others,
in addtion, nitrile gloves, face mask, covid testing kits, and other ppe products to overseas including the usa & europe & other countries..
Hospital and horeca group disposable / consumable products, personal protections, mask n91 95 , nonwoven gowns, coveralls & medical towels, patient bibs, medical papers & converting roll services.
