Jmy501 series rf module includs:jmy501a, jmy501c, jmy501d, jmy501e, jmy501g, jmy501h, jmy501m. Each model has its own characteristics. Model: jmy501h 1.Introduction Jmy501h is a rfid read/write module with an uart and iic serial port. The module supports iso/iec14443a&b and iso/iec15693 contactless cards. The module has various functions. User operates the module via simple commands. The module has excellent performance and stability. The antenna is separated from the module. 2.Characteristics Pcd model:nxp cl rc632 Working frequency: 13.56mhz Card supported:mifare 1k/4k, fm11rf08, ultra light, desfire, mifare prox, sr176, sri512, sri1k, sri2k, sri4k, srix4k, t=cl smart cards(both iso14443a & iso14443b) , ti tagit, i.Code sli, st lri and other iso15693 tags Anti collision ability:full function anti collision; be able to process multi-cards; be able to set operate single card only Auto detecting card:supported, default off Eeprom:512 bytes Power supply:dc 5v Interface:iic & uart (selected by sps pin, recommend to use iic) Communication rate:iic:400kbps, uart:19.2kbps/115.2kbps Max. Command length:254 bytes Interface level:3.3v(ttl level; 5v tolerance) Power consumption: 70ma Operating distance:100mm(depending on card and antenna design) Dimension:42mm¡Á21mm¡Á8mm Package:dip32 Weight:about 15g Isp:supported Operating temperature: -77 ~ +185¡ãF Storage temperature: -104 ~ +257¡ãF Rohs:supported 3.Antenna We supply the antennas. There are three models: tx500, tx501 and tx502. The antenna customization is welcomed. Outer package: carton (size: 48*32*24mm) Weight: 100g Terms of delivery: dhl, tnt Delivery time: 5 working days after receive payment.
JMY501 series are RFID reader/writer module with UART and IIC serial ports. JMY501 has various functions and supports multi ISO/IEC standard of contactless card; the cards from different suppliers. The RF protocol is complex. But the designer combined some frequent used command of RF card and then user could operate the cards with full function by sending simple command to the module through IIC or UART interface. The impedance between RF module and antenna was tuned by impedance analyzer. And then the module has excellent performance and stability. The module and antenna is separate design. 4 wires are linked the antenna and module. Normally the wire should be less than 200mm, or it will affect the module's performance and stability. Qualifications: PCD: NXP RC500, RC531, RC632, RC400; FM1722 Working frequency: 13.56MHz RF standard: ISO14443A, ISO14443B, ISO15693 Operating distance: 100mm(depending on card and antenna design) Anti collision ability: Full function anti collision; be able to process multi-cards simultaneously; be able to set operate single card only Auto detecting card: Supported, default OFF EEPROM: 512Bytes Interface: IIC & UART (selected by SPS pin, recommend to use IIC) Communication rate: IIC--400Kbps, UART--19200bps/115200bps Max.command length: 511 Bytes Interface level: 3.3V (TTL level; 5V tolerance) Power supply: DC5V Power consumption: 70mA Dimension: 42mm¡Á21mm¡Á8mm Package: DIP32 Weight: about 15g Operating temperature: -77 ~ +185¡ãF Storage temperature: -104 ~ +257¡ãF ISP: Supported RoHS: Compliant 30 pcs per box, box size: 16cm*12cm*5cm.
JMY680 series are RFID reader/writer module with IIC or UART serial ports. JMY680 has various functions and supports multi ISO/IEC standard of contactless IC card; the cards from different suppliers. The designer combined some frequent used command of RF IC card and then user could operate the cards with full function by sending simple command to the module through IIC or UART interface. The module and antenna are integrated design. And the impedance between RF module and antenna was tuned by impedance analyzer. So the module has excellent performance and stability. Qualifications: PCD: NXP RC500, RC531, RC400, RC632 Working frequency: 13.56MHz RF standard: ISO14443A, ISO14443B, ISO15693 Operating distance: 80mm(depending on card and antenna design) Anti collision ability: Full function anti collision; be able to process multi-cards simultaneously; be able to set operate single card only Auto detecting card: Supported, default ON SAM card slot: 1 slot, 9600bps /38400bps EEPROM: 512 Bytes PPSS set: Supported Interface: IIC, UART, RS232C or USB to RS232C Bridge(select when place order) Communication rate: IIC--400Kbps; UART--19.2Kbps/115.2Kbps Max.command length: 511 Bytes Interface level: 3.3V (TTL level; 5V tolerance) Power supply: 5.0V Power consumption: 150mA Dimension: 70mm¡Á50mm¡Á16.5mm Weight: about 120g Operating temperature: -77 ~ +185¡ãF Storage temperature: -104 ~ +257¡ãF ISP: Supported RoHS: Compliant 10 pcs per box, box size 16*12*5cm.
Optical mark reader(omr scanner) is a high-tech data input device . Nanhao omr can be widely used in education examinations, signing up, subject choice, data statistics and evaluation in fields such as vote, transportation, human resources, fiscal taxation and finance and so on. Main application fields: Standard examinations in colleges, high schools and elementary schools, educational evaluations, analysis of student achievement , students' status management and so on. Specifications: Model: Omr43fs Reading mode: Single-face and read one time Feeding mode: Automatic Speed: 8000pcs/hour (based on a4) Form size: 130mmíß50mm-300mmíß210mm Form weight: 70-150g/m2 Track spacing: 5.08mm Marking tools: No.2 or softer pencils, carbon pens Mark shapes: Rectangles, ovals and circles Error rate: ín1íß10-7 Mark choice: Single choice, multiple choice and bcd code Format: 26 kinds, each has 255 commands at most Interface: Rs232, usb Host: Pc, laptop Weight: 8kg Operating system: Win2000, win2003, win xp Power supply: Ac100-240v, 50-60hz Dimensions: 560mmíß170mmíß400mm Operating condition: Temperature 0-40ípc, humidityín90%, no erosive gas Carton boxes
2d barcode reader Encode products information, such as name, original, period of validity to 2d graphics, and printing by special material, so the 2d graphics can not be seen, stick the lable that contain the invisible 2d graphics onto your products.If your product is fraud by another company, use the invisible 2d barcode reader, it will help you distinguish which products is yours easily. The product contains three petents Portable design
Product Name : 2gb Micro SD Product Description 2GB Micro SD TF card
Product Name : 16GB Micro SD TF Product Description 16 GB micro SD Tf card
Micro SD card Product Description 512MB ~ 8 GB micro SD card
4gb memory card with 1 year warranty and water proof In blister packing or loose avaliable
This tag is uhf frequency(include 860~868mhz and 902~928mhz), it can support iso18000-6c(epc gen2) protocol to read and write, the read range depends on the reader.It made by pu material, the size is 68*80*2mm. We also can provide oem service, such as print on the tags according customer's specific requirement. Package:100pcs/packet Weight:1.5kg/packet
This tag is uhf frequency(include 860~868mhz and 902~928mhz), it can support iso18000-6c(epc gen2) protcol to read and write, the read range can up to 10~12m if use our uhf long range reader at the normal environment. The size is 110mm*45mm*0.3mm, we also can help customer customize different size according customer's specific requirement. It made by self-adhesive paper, can be fixed on the car windshield directly, mainly used for vehicle management in parking application. Package:200pcs/box.500 or 1000pcs as one roll
4-Channel Fixed UHF RFID Reader Outstanding UHF RFID Performance AUTOID UF3 is a 4-Channel UHF reader with built-in lmpinj R2000 engine. It integrates RS232, TCP/IP and other protocol interfaces and various specifications of antennas can be matched. Combined with proprietary and efficient signal processing algorithms, it achieves fast tags reading and can be widely used in logistics, asset management, smart stores, smart cities,etc. Support ISO18000-6C/6B Class1 Gen2 Protocol Output Power Adjustable from 5dBm to 30dBm 4 TNC Antenna Interfaces Support EPC & TID Anti-collision Modes Automatic Mode, Interactive Mode, Trigger Mode, etc. PoE Power Supply(Optional) Multiple Communication Protocols: RS232/485, Wiegand (CAN, TCP/IP, WIFI Optional), etc. Support 3 GPIO outputs.
Mifare reader SDK KIT Frequency:13.56MHz Transponder:Mifare Classic 1K, 4K; MIFARE Ultralight Power Requirements:5V DC Current: ï¼?100mA Output interface:RS232 Reading distance:0-5cm Power provided:Key board Data Baud rate:9600(bit/sec) Storage Temp.-10°C-85°C Size:140*100*30mm Nominal Weight:0.25kg
A smart card is a card that is embedded with either a microprocessor and a memory chip or only a memory chip with non-programmable logic . The ic card can add, delete, and otherwise manipulate information on the card, while a memory-chip card (for example, pre-paid phone cards) can only undertake a pre-defined operation. Smart cards, unlike magnetic stripe cards, can carry all necessary functions and information on the card. Therefore, they do not require access to remote databases At the time of the transaction. Today, there are three categories of smart cards, all of which are evolving rapidly into new markets and applications: integrated circuit (ic) microprocessor cards, integrated circuit (ic) memory cards, optical memory cards
Pura Smart Technology (PST) is a business unit of Pura Group known for its Smart Card products and technology. Our vision is to be the leading company for Smart Card products and Radio Frequency Identification (RFID) products in Southeast Asia.
The NV9 USB+ is the next generation banknote validator, boasting enhanced sensing technology and a high acceptance rate for multi-currency. NV9 USB+ is a versatile banknote validator with cashbox and bezel options to suit all applications. The unit can be mounted horizontally or vertically and exceptional field reliability make the NV9 USB+ a truly global product
IVF-RH101 reader elf is a portable mini reader that can link with ios, android, wp etc, Intelligent system platform through 3.5mm headphone jack to use. It has the characteristic of plug-and-play, light and small size, low power consumption, built-in rechargeable battery, etc, and is easy to carry, truly make mobile identify tag at any time, anywhere, as you wishes. It¡¯s applicable to anti-counterfeiting terminal device, etc parameter specification: 1).Support high frequency (HF) label agreement 2).Support ios, android, wp, etc Intelligent system platform 3). Material: ABS + PC engineering plastic 4). Weight: 12 g 5). Battery capacity: 130 ma 6). charge modeMicro USB 5V/0.5A 7). operating ambient temperature: -20~60 8). indicator light condition: Normal work: green light for long Abnormal equipment: light not on Low electricity quantity: green light flashing(Slow flash: low power alarm; Flash: stop using low electricity) Charging: red light for long charge complete: green light for long 9) Communication interface: 3.5mm audio interface (Ordinary headphone jack) Size: 39mm*30mm*11mm
With the Livetrack reader, the solution allows you to print a receipt of the animal id, without using a handheld and third party software to print. The unique print function on the reader itself is an industry first. Saving costs to the user, since there is no need to purchase a portable handheld; and software in order to print out a receipt. The Livetrack reader now has the print function built into the reader, along with our rugged mobile thermal printer; it is the perfect and cost effective way for Inspectors and large animal Veterinarians to read Animal EID tags, and then simply print the receipt of the Animal EIDÆs delivered or picked up, for the export or import of livestock. With the Livetrack printer function on the reader, and our new mobile thermal printer, you can quickly print a receipt with all the import information needed. The perfect solution for Inspectors, large animal Veterinarians, transports and cattlemen who transport their own cattle. 10 pieces pere master box. dem weight 63.00 Lbs.
RFID for File Tracking - RFID Based File Tracking System - RFID Integration For the File Tracking - RFID Technology for Document Tracking Document is most valuable for any company, they are Intellectual property. If a company having huge amount of files or documents then it is very important to manage those document otherwise Time consumption for searching a file will increase. If document is misplaced then there will be no surety that document is misplaced or it is missing. Tracking path of file movement is also very difficult Inventory of files will be very difficult job. Also check-In / Check-Out tracking will also be the headache for such organizations. Why RFID is required for File Tracking: Radio Frequency Identification (RFID) is playing a vital role in File Tracking and increasing efficiency of organization by automating the whole File Tracking System. RFID based File Tracking is a Complete System That Take Care of : Inventory of Files in an Organization Giving Check-In/Check-Out history of each document so that you can know the path and order of file movement from one employee to other or one department to other. If file moves from IT department to Finance Department then you can get which person has released the file and which person is having the file from how much time with only one click. Inventory will give you the list of Missing and Misplaced Documents. Component of RFID based File Tracking System: RFID Desktop Readers RFID Fixed Readers Self Check-In / Check-Out Kiosk RFID Handheld Readers RFID Tags Controllers Sirens Files Client Server Applications: Window Application Web Application - Handheld Application Functioning of RFID File Tracking System - Tagging: Tagging is the process of mapping of registered file with unique tagid, corresponding Location and its department. Inventory: Handheld reader reads and save the record of all the files coming in its range. It gives the list of misplaced and missing files. Check-In/Check-Out: Files can be check in and check out by self check in / checkout station. Searching File: Any File can be search by handheld reader by putting its file number. As the file come in range of handheld reader it start beeping. MIS Reporting: MIS Report can be generated from the web application anytime and anywhere in the scope of network. Administrator Setting: Administrator setting can be applied on files such as File cannot check in. Real Time Tracking: By this functionality file can tracked in real time by fixed readers installed at various places inside the campus. Anti-Theft Gate: Anti-Theft gate will take care no file can be taken out without check-In otherwise it will start a Siren for theft alert.
