Kosoo k-2 (gys) heat shrink tube Application KOSOO K-2 (GYS) is one of the KOSOO K-2 series of heat shrinkable tubing. It is a co-extruded, green and yellow striped, heat shrinkable tubing designed for use in earth sleeving. Features/Benefits Shrinkage ratio: 3:1 Flexible, high flame retardance Excellent physical, chemical and electrical properties, for highly reliable, general purpose tubing Operating Temperature Range Operating temperature range: -55+óGÇP¦Æ~135+óGÇP¦Æ Minimum shrink temperature: 70+óGÇP¦Æ PACKED IN ROLLS
Difference between three high efficiency solar vacuum tube (effective tubes, high cold tube, high temperature special efficiency tube)and ordinary tube: Absorption of heat membrane layer is difference between these two kind of tubes. (Absorption of heat membrane layer is the key part of vacuum tubes.) Absorption of heat membrane layer of three high efficiency solar vacuum tube is interference membrane, common tube is gradient membrane. The difference is mainly for interference membrane and the gradient membrane distinction. 1. Fundamental distinction: membrane layer structure is different, the principle of the absorption of sun's rays result in differently. gradient membrane, for multilayer, its absorbing layer is generally 9 layers. It to the sun's rays are layered absorption, and its absorb the light performance gradually become tall. Because the gradient structure, launch with increasing temperature rise than work, that temperature in 300 to 500 C than when launch greatly increased. The aluminum ions and absorbing layer in high temperature condition, lively nature greatly enhance the, and develop a drift. This happened in the internal structure of membrane layer caused confusion, coating began to aging. In the long run, the high temperature condition, membrane layer can fall off, thereby affecting the vacuum tube heat efficiency and life integrating. Interference membrane, its absorbing layer altogether 2 layer, among two layer membranes, because the metal content between the different and interfere ratio effect, make absorption ratio increase, launch ratio decrease. Plus effect of reduce emission from minus reverse layer, thus achieve more higher absorptance and reducing the role of launch ,greatly improved collection thermal efficiency. 2.Features: Absorptance of three high efficiency solar vacuum tube increased by 12%, and launch reduced by 30 to 40 percent, the super absorbing, heat loss less, warming faster. Efficient tube, the super absorbing, thermal efficiency is high, warming faster, in the same light conditions, can create more and higher temperature water than common tubes ; high cold tube, copper ions for the launch of aluminum ion mantua, so low 0.2 thermal loss rarely, in high cold environment can still work normally. hot water turn out as usual under- 30 C. high temperature special efficiency tube, because the membrane layer stainless steel ion high temperature resistant, fight air drying. Membrane layer under the condition of the 400 C, not attenuation, not aging, discoloration. In the same light conditions, ordinary tube heat absorption is lower than three high efficiency solar vacuum tube, can't even meet requirements that wash bath; In lower temperature, heat loss is bigger, collection hot effect is reduced, affect the normal use; Especially in the empty sun over 270 C, membrane layer began to aging, fall off, absorption rate drastically reduce, life shortens greatly. 3.Technology: high temperature special effects tube, high cold tube, efficient tube used respectively to three target, double target, single target magnetron sputtering craft; Ordinary tube typically use the single target magnetron sputtering technology. 4, appearance: A, Mouth of tube, here membrane layer above 800 C high temperature condition sealing off part is inevitable. As high temperature special effects tube has high temperature resistant, only 1 cm long without membrane layer in mouth of tube, while others without membrane layer for without high temperature resistant, tube membrane layer falls off the length is about 2.5 cm B, Inner tube color: with macroscopic observation, high-temperature tubes and high cold tube for internal color is kermesinus (for membrane layers bottom is copper); the bottom And efficient tube and ordinary tube are white (for membrane layer bottom is aluminum). Anyhow, interference membrane is the new breakthrough basis of gradient on membrane technology ,it is the great innovation in coating technology progress and become current global, interference coating of the most advanced coating technology. But also to the vacuum coating technology bring epoch-making change. Especially with the high temperature effects made interference membrane, can also be used for cooling tube, dry, seawater desalination, opened up the update for vacuum tubes wider application fields. Solar collector tube introduction Feature: 1 Quality warranty :15 years Quickly thermal collecting efficiency. It works fine under cold weather and area. Three kind of solar collector: Common :evacuated collector tubes. High-efficiency: Three-target evacuated collector tubes: blue and black-golden High-efficiency: Three-target evacuated collector tubes: purple-golden (purple and golden) Solar evacuated collector tubes technical data: Dimension: 47: 58 Material of tubes: 3.3 high borosilicate: 3.3 high borosilicate Glass expansion ratio: 3.3¡¾0.1X10-6 k-1: 3.3¡¾0.1X10-6 k-1 Outer diameter of tubes: 47¡¾0.7: 58¡¾0.7 Inner diameter of tubes: 37¡¾0.7: 48¡¾0.7 Thickness of glass: 1.6¡¾0.15: 1.6¡¾0.15 Transmittance: 0.89: 0.89 Selective coating: SS-CU-AL-N/AL: SS-CU-AL-N/AL Adsorptivity: 0.86(AM1.5): 0.86(AM1.5) Emissivity: 0.080(80¡¾5): 0.080(80¡¾5) Vacuum degree: 5.0 X 10-3Pa: 5.0 X 10-3Pa Collecting performance under sunshine: 190m2/kw: 190m2/kw Hailstone resistance: 25mm: 25mm Start up fast and collect solar energy fully Unique super pure copper surface,allowing reflection and minimal heat loss. High level vacuum ensure operation under cold weather. Long time warranty to 15 years. 10pcs/Carton. Applications: superior heat resisting products and crafts. 15-20KG/Carton.
VACUETTE Venous Blood Collection Tube Plasma Tube K2 EDTA / Separator Gel Additive 13 X 100 mm 5 mL White / Yellow Ring Pull Cap Polyethylene Terephthalate (PET) Tube UOM: 1200/CS Product Number: 456058P Manufacturer: Greiner
Venous Blood Collection Tube K2 EDTA Additive 13 X 75 mm 4 mL Lavender / Black Ring Pull Cap Polyethylene Terephthalate (PET) Tube UOM: 1200/CS Product Number: 454209 Manufacturer: Greiner
Heat shrink tube kosso k-2(3x) Shrinkage ratio: 3:1 Flexible, high flame retardance Excellent physical, chemical and electrical properties Resistance to abrasion and fluids Operating temperature range Operating temperature range: -55p+G-ªG+GG¦fP+T-ª+GG¦ß~135p+G-ªG+GG¦fP+T-ª+GG¦ß Minimum shrink temperature: 70p+G-ªG+GG¦fP+T-ª+GG¦ß Minimum full recovery temperature: 110p+G-ªG+GG¦fP+T-ª+GG¦ß Packed in roll
Kosoo k-2 (z) heat shrink tube Features/benefits Shrinkage ratio: 2:1 Flexible, high flame retardance Low shrink temperature Good thermal stability Excellent physical, chemical and electrical properties Complied with en71 part 3, en1122, epa3050b, epa3052 european environmental standards Free of pcbs, pcps, pbbs, pbbos, pbbes, pbdes, which are classified as environmentally hazardous substances, conform to european rohs environmental standards Operating temperature range Operating temperature range: -55póGÇPµÆ~135póGÇPµÆ Minimum shrink temperature: 70póGÇPµÆ Minimum full recovery temperature: 110póGÇPµÆ Packed in rolls
Vacuum blood collection tubes, blood collection needles, urine collection cup, stool collection cup, culture media, blood culture bottle, stain series.OEM
Vacuum Blood Collection Tubes.
Vacuum Blood Collection Tube..
Vacuum blood collection tube; EDTA tube;heparin tube;seperation gel tube.
Diagnostic chemical reagents for malaria, tuberculoses, HIV, aids, vacuum blood sample test tube.
Disposable vacuum blood collection tube and other disposable medical supplies.
EPGT tube stands on EDTAK2 with Gel Tube. It is coated with lithium heparin and inside the tube a barrier Gel presented at the bottom. Product Feature they are normally made of glass and plastic. In addition, the plastic tube includes PET, PP and PS. Product Specification/Models 1ml 13í-75mm VP10041S 2ml VP20031S 3ml VP30031S 4ml 13í-100mm VP40042S 5ml VP50032S 6ml VP60032S 8ml 16í-100mm VP80043S 9ml VP90043S Application. Through centrifugation, the separation gel can form a barrier between plasma and blood cell and totally separate them. Clinical specimen obtained is suitable for analysis of virus capacity and molecular diagnostics of undiluted plasms. Other Information We are professional manufactory dealing especially with the export of blood collection kits. We are in a position to accept orders according to the customer's samples. 100pcs/tray 1200pcs/carton
Product feature They are normally made of glass and plastic. In addition, the plastic tube includes pet , pp and ps. Product specification/models 3ml 13íß75mm vp30011s 4ml vp40011s 5ml vp50011s 3ml 13íß100mmvp30012s 4ml vp40012s 5ml vp50012s 6ml vp60012s 8ml 16íß100mmvp80013s 9ml vp90013s Application It is used for collecting blood specimen for biochemistry and immunology tests, especially fast in blood coagulation. Other information We are professional manufactory dealing especially with the export of blood collection kits. We are in a position to accept orders according to the customer's samples. 100pcs/tray 1200pcs/carton
Ssgt tube stands on clot activator with gel tube. It is coated with clot activator and inside the tube a barrier gel presented at the bottom. Product feature They are normally made of glass and plastic. In addition, the plastic tube includes pet, pp and ps. Product specification/models 3ml 13íß75mm vp30021s 3.5ml vp35021s 3ml 13íß100mm vp30022s 4ml vp40022s 5ml vp50022s 7ml 16íß100mm vp70023s 8ml vp80023s Application It is used for clinical biochemistry and immunology. The obvious characteristic of ssgt tube is used to obtain high-quality plasma specimen for medical laboratories. Other information We are professional manufactory dealing especially with the export of blood collection kits. We are in a position to accept orders according to the customer's samples. 100pcs/tray 1200pcs/carton
Product specification/models Infant blood collection tube: 8*45mm Color: red, yellow, lavender, green, black, gray, blue. Application It's used for children's blood collection Other information We are professional manufactory dealing especially with the export of blood collection kits. We are in a position to accept orders according to the customer's samples. 100pcs/tray 1200pcs/carton
Vacuum blood collecting tubes, tipes for pipette, centrifuge tube, petri dish, cuvette cup, sample cup, medical instrument, pipette, box shelf, measuring cup.
3 ply disposable surgical face mask, n95 face mask, ffp2 and ffp3 face masks, coveralls, gowns, hand sanitisers, disinfectant, infusion set, blood transfusion set, feeding tubes, drainage catheters, trans radial tr band, femoral pressure assistted band, ventilator.
Insulin pen needles, vacuum blood collection tubes, syringes, test tubes.
Products description: vacuum plain blood collection tube non-additive blood tube 1.Material:PET/glass tube 2.Specification:13*75mm,13*100mm,16*100mm 3.Volume:Volume:2ml-10ml 4.Additive: Non-additive 5.Certificate:CE & ISO 13485 certificate approved 6.Packing:Customized production as requested. Normal carton size as follows: 100pcs/foam tray,1200pcs/carton 13x75mm: 515*360*183mm/1200pcs 13*100mm: 515*360*233mm/1200pcs 16*100mm:580*390*233mm/1200pc 7.Certificate:CE & ISO13485 certificate approved 8.Tray material: Foam 9. Cap color:red 10.Delivery time:15-25 days depend on order size 11.Label and logo printing: as requested 12.Shelf time: PET-18 months, glass-24months 13.Storage: No direct sunlight at room temperature You are warmly welcome to visit our company and we expect highly to win-win cooperation with you! Now contact me: Felix Ma