There Are 3 Types of Wood: - Rubber Wooden - Ash Wooden - Oak Wooden
APPLICATION OF SK-HB K-SILICATE MORTAR : * K-SILICATE is used for jointing Acid Resisting brick in construction of vessels in suited for construction of fume chambers and stacks handling hot, dry Acid fumes and vapors. It is also used for jointing chemical resisting stoneware pipes. K-SILICATE cement is good bedding material for Acid â?? Resisting bricks and tiles. The concrete surface needed protection should be dryed, clean and rough. The bricks or tiles will be set with K-SILICATE cement over concrete surface applied with a suitable an impermeable interliner. When Bedding and Jointing Materials are the same. On the treated surface bricks or tiles are bedded to a thickness of about 6 mm and tamp gently with a wooden piece till the paste squeezes out of joints. The paste that is squeezed out of the joint should be removed by trowel with good finishing. After the mortar of the joint is dryed treat the joints with 20% Hydrochloric Acid Solution by means of brush. A.R.lining should be always in contact with Acid and not with water. Concrete subtract like Floor, Wall, tanks and similar surface should be protected with a membrane of Bitrok Mastic or compound steel tanks should be protected with rubber or PVC subjected to chemical conditions and temperature of chemical media. The Brick lining is recommended over the protective layer of Bitrok Mastic. When Bedding and Jointing Materials are Different. Spread the silicate type mortar about 6 to 8 mm thick on the back of the tile or brick. Press the tile on the bed leaving required space for joints between tiles for bricks. After the bedding mortar is set, fill Mp the joints with specified cement.PRODUCT DATA SHEET FOR SK-HB ( K-SILICATE) MORTAR A general purpose cement for acid conditions Resistant to High & medium concentrations of most of the common organic and inorganic acids except Hydroflouric acid. Recommended where the concentration of the acid is high suitable for high temperature. Unsuited to aqueous solutions, alkaline conditions. PREPARATIONS OF MORTAR : * Measure 1 part by weight of K-SILICATE solution into a suitable mixing pan. * Add slowly and gradually 3 parts by weight K-SILICATE mortar and mix thoroughly to form a smooth mortar. * In hot season very large batches of mortar will become stiff quite rapidly therefore small batches, not exceeding 4 to 8 kgs. Will be prepared. * The cement mortar will be used before it starts setting.
- The cutting board is made of natural rubber wood material. It has characteristics of hard, thick, beautiful color. - Specifications: Origin: Vietnam Material: Rubber Wood Color: Bright Brown Size: Customized Shape: Customized Feature: Eco-firendly, non-toxic, flexible, light weight Packing: In carton box
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair
The Lounge Chair we provide are made of quality materials and are comfortable to use. The material used is wood or synthetic rattan. You can order according to the model and color you want.
METHOD OF APPICATION: * Mastic compound application consist of two coats of. Primer ,Primer and followed by Mastic compound in recommended thickness, ranging from min. 12mm to 25mm in one or two layers to achieve desired thickness without any pin hole and crack. 1). Surface preparation and application of Primer: Refer application method of Primer. 2). After doing necessary surface preparation and application of primer coating, area to be installed with Mastic compound should be divided in to equal no. bays. To maintain even thickness required, place wooden or aluminum batten. Mastic compound is then broken in small pieces and put it in heating pan. While heating, keep material moving to avoid burning. It is heated until it comes in a uniform consistency and then applied on the surface and works it with wooden float, to achieve uniform thickness and smooth surface free from any pinholes. CHEMICAL RESISTANCE PROPERTIES: * Mastic compound has good resistance to weak, diluted acids, alkalis salts etc. It is not recommended to use against strong acids, oxidizing acid solvents, oil and fats STORAGE & PACKING: * Keep Mastic compound away from direct sunlight, heat solvents etc. Under this condition, its shelf life is unlimited. It is supplied in cake form and approx. wt. is 10 kgs. HEALTH & SAFETY: * Handle melted Mastic compound compound very carefully . Avoid contact with skin. It is advisable to wear protective wears at the time of use of Mastic compound and all other our products. This information, given in good faith, is based on results gained from experience and tests. However, all recommendations or suggestions are made without guarantee since the conditions of use are beyond our control.
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
-Origin: Vietnam -Material: rubber wood and rattan -Size: 460mm x 500mm x H810mm -Packing: 2pcs/set -Type: single rattan chair -Model number: Kathy
