Description CA-003W Waterproof Agent is a high-grade liquid additive that gives the dual benefits of providing significant improvement in workability along with reduced water absorption. The addition of CA-003W to a mortar mixture enhances the plasticity of the mixture by creating a â??ball-bearingâ?? effect. At the same time, the microscopic capillaries are rendered discontinuous, thereby impeding the flow of liquid through them, and finally reducing the permeability of the mortar. CA-003W contains special polymers that reduce formation of shrinkage cracks. The improved cohesion provides lower rebound loss supplemented by a greater coverage. The increase in coverage can be up to 20 %. This makes significant cement savings possible. The spreading and smoothening is also made much easier. The efficiency of labor is increased, and plastering can be done in a single operation. CA-003W provides the mortar with efficient,reliable and durable damp proofing against acute rains, ground water moisture as well as environmental humidity. Thus the use of CA-003W provides significant benefits, while keeping plastering economical.
DESCRIPTION ITSEAL is truly developed for sealing window frames with highly durable and flexible properties to withstand severe weathering and extreme temperatures. It seals small gap that normal sealant cannot reach and penetrate. It provides a truly watertight seal deep into minute joint and gap. FEATURES * ITSEAL is the only waterproof sealer that is completely watertight. * It is highly water repellent that no water can get through it during storm. * It adheres well on aluminum and glass * Once dried, ITSEAL is flexible and accommodate joint movement due to vibration. * Mill finish aluminum, oil or wet surfaces can also be well-sealed. VOC CONTENT Type of Regulated Adhesive under the Air Pollution Control (Volatile Organic Compounds) Regulation of Hong Kong: Architectural Sealant VOC Content (Ready to use): 248g/Ltr. SURFACE PREPARATION For maximum adhesion, the adhesive surface must be free of dust, release agent, oil and grease. Wipe surface with solvent is recommended. Solvent are obtainable from ITLS-SB. This information in this catalogue is provided to the best of our knowledge from results gathered both internal and external credited laboratories. However, we have no control over site applications, site conditions and workmanship of the applicator. We therefore will not accept any liability, either directly or indirectly arising from the misuse of these products or when the product is used not in accordance with any advice, specification, and recommendation of information given by us, The user is responsible for checking the suitability of these products for its intended use. APPLICATION ITSEAL can be used with hand operated or air operated grease pump. Other simple extruding device can also be used but it has to be solvent resistance. LIMITATION * Not suitable large gap wider than 5 mm wide and deep. For deeper joint fill to half of it, let it dry overnight and fill it up the next day. * Not suitable for use as expansion joint. COLOUR AND PACKING 26 kg / pail Grey/Black/Bronze/White SAFETY INFORMATION * ITSEAL is flammable. Please keep away from sources of ignition during application. * Avoid breathing in solvent by wearing solvent vapor respiratory mask in badly ventilated area or confined space. * Avoid contact with skin and eyes. If swallowed please contact doctor immediately. * ITSEAL meets the requirement of RoHS regulation of European Union and it does not contain eight heavy metals which were restricted by ASTM F963 or EN71 part3. * Please read the Material Safety Data Sheet in regards to flammability and health and hazard. SHIPPING/STORAGE INFORMATION ITSEAL must be stored in a cool place under 25°C and away from direct sunlight. The shelve life is 12 months if stored in accordance to the recommendation. Dangerous Goods Information: Cement Adhesive, Class 3, UN1133 PG III.
T bars ceiling grid, ceiling tiles (calcium silicate ceiling tiles, gypsum ceiling tiles, mineral fiber ceiling tiles, metal ceiling tiles), partition frame, partition boards (calcium silicate boards & fiber cement boards, gypsum boards), fiberglass wool insulation / rock wool insulation, all purpose joint compound/ skim coat compound, flooring series (spc, wpc etc.).