Motion sensor, occupancy sensor, LED floodlight, LED sensor light, decorative sensor light, smart home, Z-wave, GSM alarm.
6-ch ISO RTD Input module * Support PT100, PT1000, Balco 500, NI604, NI1000 RTD types * Protocol MODBUS RTU, ASCII Command * Support isolated input channels * Fully photo-isolation 3750Vrms * Wide supply voltages (10_30V) * Built-in TVS/ESD protection * Burn-out auto detection
Water solenoid valve, open frame solenoid, tubular solenoid, keep solenoid, push-pull solenoid, rotary solenoid, solenoid, solenoids
Manual pulse generator (MPG), CNC operation panel, switch, IPC, servo motor for ATC system, encoder, spin window, smart meter, cam box controller for ATC, intelligent chuck position sensor.
Electric sensors.
This antenna system consists of two functional blocks, the LNA portion and the patch antenna. CONFIGURATION RF Cable - RF Coaxial Cable, 2.7± 0.2mm - Cable Length : 5M ± 5cm - RF Connector : SMA 180(M) / MCX 90 (M) GENERAL ENVIRONMENTAL CONDITIONS - Operation Temperature : -40 to + 85 - Storage Temperature : -40 to + 85 - Relative Humidity : 40% to 95% ELECTRICAL SPECIFICATIONS - Input Voltage : Min:2.5V Typ:3.0V Max:5.5V - Power Consumption : Typ: 10mA. Max: 15mA. @3.0V ANTENNA - Antenna Dimensions : 25 x 25 x 4 mm - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - GAIN : 1575.42MHZ : -3dBi Typ. @zenith 1602MHZ : -5dBi Typ. @zenith - Polaration : RHCP LNA and FILTER - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - Gain (without Cable) : 1575.42MHz:28 dB Min.30 dB Typ.( + 25 ± 5) 1602MHz:28 dB Min.30 dB Typ.( + 25 ± 5) - Noise Figure : 2.0 dB Typ. ( + 25 ± 5 ) / 2.6 dB Max. ( + 85 ) - Out Band Rejection : 1587.5 ±140MHz 15dB Min - Output Impedance : 50 - Output VSWR : 2.0 Max TOTAL SPECIFICATIONS (Through Antenna, LNA, Cable and Connector) - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - Gain : 1575.42MHZ: 27± 3dBi @zenith 1602MHZ: 29.5± 3dBi @zenith - Output Impedance : 50 - Output VSWR : 2.0 Max
This antenna system consists of two functional blocks, the LNA portion and the patch antenna. CONFIGURATION RF Cable - RF Coaxial Cable, 2.7± 0.2mm - Cable Length : 5M ± 5cm - RF Connector : SMA 180(M) / MCX 90 (M) GENERAL ENVIRONMENTAL CONDITIONS - Operation Temperature : -40to + 85 - Storage Temperature : -40 to + 80 - Relative Humidity : 40% to 95% ELECTRICAL SPECIFICATIONS - Input Voltage : Min:2.5V Typ:3.0V Max:5.5V - Power Consumption : Typ: 10mA. Max: 15mA. @3.0V ANTENNA - Antenna Dimensions : 25 x 25 x 4 mm - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - GAIN : 1575.42MHZ : -3dBi Typ. @zenith 1602MHZ : -5dBi Typ. @zenith - Polaration : RHCP LNA and FILTER - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - Gain (without Cable) : 1575.42MHz:28 dB Min.30 dB Typ.( + 25 ± 5) 1602MHz:28 dB Min.30 dB Typ.( + 25± 5) - Noise Figure : 2.0 dB Typ. ( + 25 ± 5) / 2.6 dB Max. ( + 85 ) - Out Band Rejection : 1587.5 ±140MHz 15dB Min - Output Impedance : 50 - Output VSWR : 2.0 Max TOTAL SPECIFICATIONS (Through Antenna, LNA, Cable and Connector) - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - Gain : 1575.42MHZ: 27± 3dBi @zenith 1602MHZ: 29.± 3dBi @zenith - Output Impedance : 50 - Output VSWR : 2.0 Max
This antenna system consists of two functional blocks, the LNA portion and the patch antenna. CONFIGURATION RF Cable - RF Coaxial Cable, 2.7± 0.2mm - Cable Length : 5M ± 5cm - RF Connector : SMA 180(M) / MCX 90 (M) GENERAL ENVIRONMENTAL CONDITIONS - Operation Temperature : -40 to + 85 - Storage Temperature : -40 to + 85 - Relative Humidity : 40% to 95% ELECTRICAL SPECIFICATIONS - Input Voltage : Min:2.5V Typ:3.0V Max:5.5V - Power Consumption : Typ: 10mA. Max: 15mA. @3.0V ANTENNA - Antenna Dimensions : 25 x 25 x 4 mm - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - GAIN : 1575.42MHZ : -3dBi Typ. @zenith 1602MHZ : -5dBi Typ. @zenith - Polaration : RHCP LNA and FILTER - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - Gain (without Cable) : 1575.42MHz:28 dB Min.30 dB Typ.( + 25 ± 5) 1602MHz:28 dB Min.30 dB Typ.( + 25 ± 5) - Noise Figure : 2.0 dB Typ. ( + 25 ± 5) / 2.6 dB Max. ( + 85 ) - Out Band Rejection : 1587.5 ±140MHz 15dB Min - Output Impedance : 50 - Output VSWR : 2.0 Max TOTAL SPECIFICATIONS (Through Antenna, LNA, Cable and Connector) - Frequency Range : 1575.42 ± 10 MHz. / 1602 ± 8MHz - Gain : 1575.42MHZ: 27± 3dBi @zenith 1602MHZ: 29.5± 3dBi @zenith - Output Impedance : 50 - Output VSWR : 2.0 Max
Main Technical Specification - Frequency Range (MHz) : 434 - Bandwidth (MHz) : ±3 - VSWR : 2.0 - Gain(dBi) : 1.80 - Max Input power (W) : 50 - Input Impedance () : 50 - Polarization Type : Vertical - Antenna Length(mm) : 88mm(90) / 108mm (180) - Connector Type : SMA
1 Description:WSS007 Dual Band Antenna with RP-SMA(M) 2 Model No.:WSS007 3 Antenna Profile:197 mm 4 Color:Black 5 Electrical Characteristic Operating Frequency:2.4~2.5GHz/ 5GHz/ Dual Band Antenna Type:Dipole Polarization Type:Linear Type of Radiation:Toroidal Peak Gain:2.0 dBi Typical Impedance:50 Ohm nominal VWSR:2.0:1 Max 6 Mechanical Characteristics Action:Swivel Type Lead Length:Customization Connector:RP-SMA(M) Core:N/A 7 Raw Material Coaxial Cable:RG-178 Housing:TPU Hinge:PC+ALLOY PE bag or Customization
1 Description WSS002 Dual Band Antenna with RP-SMA(M) 2 Model No.:WSS002 3 Antenna Profile:108.5 mm 4 Color:Black 5 Electrical Characteristic Operating Frequency:2.4~2.5GHz/ 5GHz/ Dual Band Antenna Type:Dipole Polarization Type:Linear Type of Radiation:Toroidal Peak Gain:2.0 dBi Typical Impedance:50 Ohm nominal VWSR:2.0:1 Max 6 Mechanical Characteristics Action:Swivel Type Lead Length:RP-SMA(M) Core:N/A 7 Raw Material Coaxial Cable:RG-178 Housing:TPU Hinge:PC+ALLOY PE bag or customization
Vcxo: 3225, 5032, 7050, half, full Tcxo & vctcxo: Smd:11.4*9.6, 7050, 5032, 3225 Through-hole:1812, 2013, 1313 Ocxo: 5151, 3939, 3627, 2525, 2020, 2013 Rtc module: Sop-14
Specifications Operating environment (Receiver Unit) • Operating temperature range -20 deg to 80 deg C • Storage temperature range -20 deg to 85 deg C • Operating humidity 100% • Vibration 3.5mm 10 Hz in X,Y and Z direction. Power (Receiver Unit) • Power Required 12V DC (MiniDC jack) or Battery DC 3V • Battery Life: Approx. 6 Months • Battery type AAA 1.5V (x2). Dimensions Monitor (Receiver Unit) • Weight 60 g • Size L 63mm * W 42.5mm* D 20mm • LCD View size L 33.5mm * W 28.2mm. System (Receiver Unit) • System frequency at 433 MHz • Sensor pressure range 0-60 psi • Sensor pressure sensitivity ± 1.5 psi • Sensor temperature sensitivity ±2 deg C • Low power consumption in sensor • Transmission length: up to 10M (Can vary between vehicle's). Emissions (Receiver Unit / Sensors) • FCC Comply with part 15,Class B • CE • C Tick. Operating environment (Sensors) • Operating temperature range -40 deg to 125 deg C • Operating humidity 100% • Shock >1000G from 1.5m height • Vibration 10mm 5-200 Hz in X,Y and Z direction Power (Sensors) • Sensor is equipped with battery - CR1632 (3V) • Battery Life - Approx. 1 Year. Dimensions Sensor (Sensors) • Weight - 10g±1 g • Size - Diameter 18.5mm / Height 20mm.
Connector: A type, mini and micro type Cable: micro coaxial cable AWG40 Version: 1.4 version Length: 0.8m to 2.5m Support: 4K ,3D and high speed
Antenna Size¡G 90.8mm(Dia) ¡Ñ 109mm(H)This series of Iridium antennas is specifically designed to provide excellent coverage in the 1610 to 1630 MHz range.
1. Detachable battery pack 2. Dual independent battery gauge 3. LCD display 4. Internal charger 5. Backup controls on the control box 6. Compatible with Bestcare Performance or Legacy actuators
The fall down detection alarm system designed to use in the industrial and commercial areas, to ensure safety for employees working in high-risk facility, working alone, security guard, elder or disabled. The Worker Emergency Alarm System is a combination of personal alarm and fall down detector. When wireless Man-Down Transmitter detects the horizontal position, it is trigger alarm signal. The Wireless Fall Down Alarm Detector will beep for 30 seconds to warn the wearer to avoid false alarms before sending the warning signal to control center and to other wearers in the group. The wearable alarm detector has tilt detection, no motions detection. The Lone Worker Alarm can also be activated manually by pressing an SOS button. The Fall Down Detection Alarm System includes wireless fall down detector, Base Receiver with LED Display and alarm signal repeater. The Wireless Alarm Signal Repeater can extend the alarm signal about 800 meters. (true-line-of-site range). The repeater helps to build lone worker security system for the indoor and outdoor application. One Base Receiver can work with 15 pcs personal alarm detector.
HD-721 Video Upcaling Rotary Controller is a high quality and high performance image upscaling rotary switch, use the high speed image processor chip. This product is main function is that can supports HDMI, DP, Mobile MHL and VGA signal input and switch any one of the input signals to HDMI output. This product supports video and audio synchronous switch of different signal formats, and setting the image 90 degree, 180 degree and 270 degree rotation. Multi-control mode: users can control the device via chassis button, IR remote, RS232 control to operate it. **Support scaled synchronizing mobile phone vertical video signal of to vertical high resolution displayer. **Support PC, DVD players and other HDMI, VIDEO, VGA, DP output signal 90,180,270 degrees of rotation. **Input signal support 1 VGA, 2x DP( DisplayPort ), 4x HDMI signals, including 3 x HDMI signal compatible MHL signal. **Output including 1x HDMI and 1x stereo audio signal, support switching the sound and video signal synchronous.
CSC-5500 Multi Input Scaler has Composite Video, Component Video, PC (VGA), and HDMI inputs and can switch and scale the signal to HDMI or VGA with audio outputs. It supports HDMI output resolutions up to 1080p/ WUXGA and Analog Digital Conversion (ADC) and Digital Analog Conversion (DAC) allowing a wide range of AV signals to be displayed on a HDMI or VGA display. Further, the On-screen Display (OSD), IR remote, RS-232, IP and on-panel controls make this product very versatile.
The aws series water leak alarm equipped with led and siren to inform you when any leakage occurred. Features: Equipped with "detecting line broken" and "leakage"alarm led indicators Adjustable sensitivity level Detecting loop provides effiecient protection by warning alarm Stand alone or can be connected to security system Length of detecting line is adjustable upon request Easy installation for flexible applications Can be applied to various areas, such as computer room, server room, data center, factories, offices and etc. Approx. 50x80x100(mm), 400g
