Specifications Operating environment (Receiver Unit) • Operating temperature range -20 deg to 80 deg C • Storage temperature range -20 deg to 85 deg C • Operating humidity 100% • Vibration 3.5mm 10 Hz in X,Y and Z direction. Power (Receiver Unit) • Power Required 12V DC (MiniDC jack) or Battery DC 3V • Battery Life: Approx. 6 Months • Battery type AAA 1.5V (x2). Dimensions Monitor (Receiver Unit) • Weight 60 g • Size L 63mm * W 42.5mm* D 20mm • LCD View size L 33.5mm * W 28.2mm. System (Receiver Unit) • System frequency at 433 MHz • Sensor pressure range 0-60 psi • Sensor pressure sensitivity ± 1.5 psi • Sensor temperature sensitivity ±2 deg C • Low power consumption in sensor • Transmission length: up to 10M (Can vary between vehicle's). Emissions (Receiver Unit / Sensors) • FCC Comply with part 15,Class B • CE • C Tick. Operating environment (Sensors) • Operating temperature range -40 deg to 125 deg C • Operating humidity 100% • Shock >1000G from 1.5m height • Vibration 10mm 5-200 Hz in X,Y and Z direction Power (Sensors) • Sensor is equipped with battery - CR1632 (3V) • Battery Life - Approx. 1 Year. Dimensions Sensor (Sensors) • Weight - 10g±1 g • Size - Diameter 18.5mm / Height 20mm.
P/N: UT89100CB - Short sweep mechanical oil pressure gauge, 0-80 psi/0-5.6 bar - Short sweep mechanical water temp gauge, 100-220 deg F/38-104 deg C - Short sweep ammeter 60-0-60 amperes - Black dial face with white/yellow text - Red pointer - 2-1/16" Dia. - 12V/2W bulb lighting - White panel - 6 ft. nylon tubing & 1/8" & 1/4" NPT fitting - 6 ft. capillary tubing & 1/2" NPT fitting - Mounting bracket, washers & nuts - Packaging: set/blister packed - 1 year warranty 24 sets/ctn
M-831 Component Counter FEATURES Counting in both directions (Left or right). Divider from 1 to 10 (up to 19upon request). Totalize mode counting. Pre-set mode counting (with an audible signal when the desired components number is reached). Calibration test and self diagnostic procedure. Lest counting value and condition memory. External detector input SPECIFICATIONS Output for external motor control. Accumulator model disposable. Min. lead diameter: £p0.35mm Dimension: 350 x 300 x 280mm Weight: 6Kgs Power: 110V / 220V AC www.renthang.com renthang@renthang.com
TPMS, truck tire pressure monitoring system, motorcycle TPMS.
Cycloidal gear reducers, cyclo drive reducer
LR9150 utilized SiRFstarV and features Quad-GNSS for tracking GPS, GLONASS, BDS and Galileo satellites. The product family delivers highly accurate continuous location, advanced power management and high interference immunity. These continue to push the envelope of performance in sensitivity, TTFF and urban canyon availability and accuracy. With a built-in DSP and extremely low power consumption, the family can get fast location fixes for geo-tagging images or videos, asset tracking and wearable applications. Performance * GPS, GLONASS, Galileo, BDS and SBAS reception for high GNSS availability and accuracy * High sensitivity navigation engine (PVT) tracks as low as - GPS : -165 dBm - GLONASS : -161 dBm * 52 track verification chann els * SBAS (WAAS or EGNOS,MSAS) * Active Jammer Remover, removes in-band jammers up to 80 dB-Hz * Tracks up to 8 CW jammers * Multimode A-GPS (Autonomous, MS-Based, and MS-Assisted), need operator support. * Embedded CGEE / SGEE (With back-end server support) speed up TTFF a lot and makes cold start time to be around 20+ seconds. * SiRFGeoRecovTM Reverse EE makes positioning process being done under power saving mode. * Reacquisition Time : 0.1 second * RF Metal Shield for best performance in noisy environments Hardware and Software * Based on the high performance features of the SiRFstarV low power single core logic. * Adaptive micropower controller * Only 50 to 500�¼A maintains hot start capability (core logic) * < 10mW required for TricklePower mode * RoHS compliant (lead-free) * SMT pads allow fully automatic assembly processes equipment and reflow soldering * Advanced navigation features * Smart sensor supported by I�²C interface * External interrupt input for context change detection Advantages * Built-in LNA. * Built-in internal ROM and based on Firmware 5.5.X * It can remove in-band jammer up to 80db-Hz and track up to 8CW jammers, so the module can prevent GPS signal interference when design-in the electrical device with noisy electrical signal interferences such as Laptop, mobile phone, DSC, etc. * Maintain tracking sensitivity as low as GPS @ -165dBm, GLONASS @ -161dBm, even without network assistance. (SiRFstar III has only -159dBm sensitivity) * Support SiRFaware technology * Support adaptive Micro Power Controller power management mode. * < 10mW TricklePower, so user can leave power on all day instead of power off. * Suitable for battery drive devices that need lower power consumption application * Cost saving through elimination of RF and board to board digital connectors * Flexible and cost effective hardware design for different application
EDAM-9017 Ethernet-Based 8-ch Isolated Analog Input Module * Support protocol Modbus / TCP/ IP, UDP, JCMP, ARP * Provides two digital outputs (open collector) * Ethernet 10/100 Based-T communication * Support isolated input channels * Support +- V, +- mV, mA analog input * Fully photo-isolation 3750Vms * Built-in TVS/ESD protection * Wide supply voltage (10-30V)
EDAM-5017 16-ch Analog Input Module with 2-ch Isolated DI and 1-ch DO * Protocol USB2.0 TCP/IP, MODBUS RTU, MODBUS TCP ASCII Command * Support USB2.0, 10/100 Ethernet, RS-485/232C, CAN (optional) * Fully photo-isolation 3750Vrms * Wide supply voltages (10~30V)
EDAM-9053A 12 DI (Dry/Wet contact) and 4 DO channels Digital I/O module * Support Modbus/TCP,TCP/IP,UDP,ICMP,ARP * Ethernet 10/100 Based-T Communication * Support 4 Isolated digital output channels (NPN). * Provide Pulsed/delay Output Mode * Support 12 Isolated digital Input Channels * Provide Counter/ Frequency Inputs Mode * Support Dry/ Wet Contact Inputs * Fully Photo-Isolation 3750Vrms * Status LED indicator
EDAM-9015 Ethernet-Based 7-ch RTD Input Module * Support PT100,PT1000, Balco 500,NI604, NI1000 RTD Types * Support Protocol Modbus/TCP, TCP/IP, UDP, ICMP, ARP * Ethernet 10/100 Based-T Communication * Support Isolated Input Channels * Fully Photo-Isolation 3750Vrms * Wide Supply Voltages (10-30V) * Bulit-in TVS/ESD Protection * Bulit-out Auto Detection
EDAM-5019 16-ch Thermocouple Input Module with 2 iso. DI and 1 DO * Protocol USB2.0 TCP/IP, MODBUS RTU, MODBUS TCP ASCII Command * Support USB2.0, 10/100 Ethernet, RS485/232C, CAN (optional) * Support Thermocouple J, K, T, R, S, E, B, N, C Type * Support isolated input channels * Fully photo-isolation 3750Vrms � Wide supply voltages (10_30V) * Built-in TVS/ESD protection * Burn-out auto detection
16 Channels Isolated Digital Output * 16-ch. Isolated Single-Ended output * Open drain Output (P-MOSFET) * Max. Output load current 3A/per channel * Programmable Host Watchdog Timer For Host Failure Protection. * Support MODBUS RTU And ASCII Format Protocol
8 Isolated differential digital input * Support 8 isolated differential digital input * Input channel support max. 50Hz counter * Programable Host Watchdog Timer For Host Failure Protection. * Support MODBUS And ASCII Format Protocol
16 Non-Isolated digital input channels * Support 16 non-isolated digital input channels * Input channel support max. 50Hz counter * Programable Host Watchdog Timer For Host Failure Protection. * Support MODBUS And ASCII Format Protocol.
8 Isolated digital input and 8 Isolated digital output * Support 8 Isolated digital output * 650mA current Sink per DO channel * Support 8 isolated digital input channels * Input channel support max. 50Hz counter * Programmable Host Watchdog Timer For Host Failure Protection. * Support MODBUS RTU And ASCII Format
8-ch ISO DI and 3-ch AC-SSR Output with LED display * Support 8 isolated digital input channels * Input channel support max. 50Hz counter * Support 3 relay output channels (Form A) * Programmable Host Watchdog Timer For Host Failure Protection. * Support MODBUS And ASCII Format Protocol
5-ch ISO DI and 5-ch relay Output with LED display * Support 5 isolated digital input channels * Input channel support max. 50Hz counter * Support 5 Relay output channels (Form A) * Programmable Host Watchdog Timer For Host Failure Protection. * Support MODBUS And ASCII Format Protocol
EDAM-9051 12 DI, 2 DO and 2 Counter channels Digital I/O Module * Support Modbus/TCP,TCP/IP,UDP,ICMP,ARP * Ethernet 10/100 Based-T Communication * Support 2 Isolated digital output channels (NPN). * Provide Pulsed/delay Output Mode * Support 12 Isolated digital Input Channels * 2 counter (4.5 KHz) input channels * Support Dry Contact Inputs * Fully Photo-Isolation 3750Vrms * Status LED indicatorr
EDAM-9063A 7-channel Digital Input and 3 RELAY Output module * Support Modbus/TCP,TCP/IP,UDP,ICMP,ARP * Ethernet 10/100 Based-T Communication * Support 3 relay output channels (Form A) * Provide Pulsed/delay Output Mode * Support 7 Isolated digital Input Channels * Provide Counter/ Frequency Inputs Mode * Support Dry/ Wet Contact Inputs * Fully Photo-Isolation 3750Vrms * Status LED indicator
8 Isolated Digital output and 4 Isolated digital input * Support 8 Isolated digital output channels * Open Collector Output (NPN) * Support 4 isolated digital input channels * Input channel support max. 50Hz counter * Programmable Host Watchdog Timer For Host Failure Protection. * Support MODBUS RTU And ASCII Format
