Dsgp1-2021-60hz Dsgp1-2023-60hz 2 hp grinder pump 1.Double mechanical seal 2.Silicon carbide (main) !v grit 3.Resistant 4.Carbon ceramic (secondary) 5.Dual sealing chambers with 6.Moisture detection for optimum 7.Motor protection ductile iron 8.Impeller, recessed, clog-free 9.30 year proven design 10.Stainless steel grinder assembly 11.Effectively macerates domestic 12.Into a fine slurry
Dshhgp1-2021-60hz 2 hp grinder pump 1.Ideal for long discharge runs or high static heads 2.2 piece motor housing 3.Separate cord cap assembly 4.Internal capacitors - no control box req'd ductile iron impeller, recessed, clog-free dual silicon carbide seal - grit resistant stainless steel grinder assembly effectively macerates domestic sewage into a fine slurry 5.30 year proven design
Spe3 series 1/3 hp effluent pumps 1.1/2" solids handling 2.Heavy duty lip & mechanical seals in tandem 3.115 & 230 volts available 4.60hz 5.Durable cast iron motor housing 6.115 & 230 volt piggyback power plug and switch Plug w/20' cord as standard
Digp-7023/7043-60hz (patented) 1.Available with 2.7.5 hp grinder pump 3.High head, double stage 4.Doubled output pressure 5.Unmatched performance 6.350 shut-off head 7.Flows to 100 gpm 8.Balanced design 9.Ideal for long discharge runs or high static 10.Heads 11.Potentially replaces higher hp pumps 12.Ductile iron impeller, recessed, clog-free 13.Silicon carbide seals !v grit resistant
Arcing is eliminated. Connect the red battery clamp to the positive battery terminal. Connect the black Clamp to the negative or ground to a rigid metallic surface on the engine. The connection should be 12 to 19 inches from the battery. 4.Hose: Since the pump has a lower discharge pressure it is ., recommended that anoncolapsiable hose be used for maximum pumping capacity. 5.Hoisting & lowering: Use the attached nylon line. Do not use the power cord ., for handling the unit. 6.Operation of unit: Lower the unit into the liquid to be pumped(note: this unit is not to used to pump Flamable liquids).Then turn on the switch. Pump can be run for a few minutes(less than 5) without liquid. Do not run completely dry for any extended period(less than 5 min.).This will prevent. 7.Running time peroids: The unit draws 20-25 amperes and can be operated for approximately 1 hr. On a fully charged 60 amp-hour battery and still be able to start the vehicle under normal conditions. Caution should be used when running times exceeds 25 !v 30 minutes without the engine running to recharge the battery. Also be mindful of cold temperatures which lowers battery
Sewage pump.