Temperature Assemblies.
Temperature sensors..
Off Grid / Hybrid Solar Inverters.
Led Lighting Products.
Led lamps.
Solar water heater.
Best Delta Vfd Ms300 220v Three 3 Phase Inverter..
Pumps Like Water Pump, Centrifugal Pump And Submersible Pump.
Pumps Like Submersible Pumps, Fire Hydrant Systems And Diaphragm Pumps.
1.coal from indonesia 2.5000 ppm diesel fuel 3.sugar from thailand 4.any chip set made in taiwan 5.any solar products (new or second hand) for all the above products, i can directly contact the manufacturers..
Led bulb, lighting and lamp.
-For home Air-purifier-filter -For car Air filter/ Cabin filter/ Fuel filter/Oil filter/ Ecological oil filter/- Transmission filter.
Membrane filter.
Diesel Filter.
Ct-G353 utilized SiRFstarV and features Quad-GNSS for tracking GPS, GLONASS, BDS and Galileo satellites. The product family delivers highly accurate continuous location, advanced power management and high interference immunity. These continue to push the envelope of performance in sensitivity, TTFF and urban canyon availability and accuracy. With a built-in DSP and extremely low power consumption, the family can get fast location fixes for geo-tagging images or videos, asset tracking and wearable applications. Performance - GPS, GLONASS, Galileo, BDS and SBAS reception for high GNSS availability and accuracy - High sensitivity navigation engine (PVT) tracks as low as - GPS : -165 dBm - GLONASS : -159 dBm52 track verification channels - SBAS (WAAS or EGNOS,MSAS) - Active Jammer Remover, removes in-band jammers up to 80 dB-Hz - Tracks up to 8 CW jammers - Multimode A-GPS (Autonomous, MS-Based, and MS-Assisted), need operator support. - Embedded CGEE / SGEE (With back-end server support) speed up TTFF a lot and makes cold start time to be around 20+ seconds. - SiRFGeoRecovTM Reverse EE makes position power saving mode. - Reacquisition Time : 0.1 second - RF Metal Shield for best performance in noisy environments Hardware and Software - Based on the high performance features of the SiRFstarV low power single core logic. - Adaptive micropower controller - Only 50 to 500A maintains hot start capability (core logic) - < 10mW required for TricklePower mode - RoHS compliant (lead-free) - Advanced navigation features - Smart sensor supported by IC interface - External interrupt input for context change detection - Dimension : 20 x 20 x 7 ± 0.5mm Advantages - Built-in LNA. - Built-in internal ROM and based on Firmware 5.5.X - It can remove in-band jammer up to 80db-Hz and track up to 8CW jammers, so the module can prevent GPS signal interference when design-in the electrical device with noisy electrical signal interferences such as Laptop, mobile phone, DSC, etc. - Maintain tracking sensitivity as low as GPS @ -163dBm, GLONASS @ -161dBm, even without network assistance. (SiRFstar III has only -159dBm sensitivity) - Support SiRFaware technology - Support adaptive Micro Power Controller power management mode. - < 10mW TricklePower, so user can leave power on all day instead of power off. - Suitable for battery drive devices that need lower power consumption application Ideal for high volume mass production(Taping reel package) - Cost saving through elimination of RF and board to board digital connectors - Flexible and cost effective hardware design for different applications - Embed CGEE (Client Generated Extended Ephemeris) that can capture ephemeris data from satellites locally and predicts ephemeris up to 3 days. So if the module was off within 3 days, it could complete the positioning process with limited time just like hot start.
GPS/GNSS/GALILEO/SBAS Module The Ct-G354 utilized SiRFstarV and features Quad-GNSS for tracking GPS, GLONASS, BDS and Galileo satellites. The product family delivers highly accurate continuous location, advanced power management and high interference immunity. These continue to push the envelope of performance in sensitivity, TTFF and urban canyon availability and accuracy. With a built-in DSP and extremely low power consumption, the family can get fast location fixes for geo-tagging images or videos, asset tracking and wearable applications. Performance GPS, GLONASS, Galileo and SBAS reception for high GNSS availability and accuracy High sensitivity navigation engine (PVT) tracks as low as GPS:-165dBm,GLONASS:- 161dBm 52 track verification channels SBAS (WAAS or EGNOS,MSAS) Active Jammer Remover, removes in-band jammers up to 80 dB-Hz Tracks up to 8 CW jammers Multimode A-GPS (Autonomous, MS-Based, and MS-Assisted) �?�¢?? Need operator support Embedded CGEE / SGEE (With back-end server support) speed up TTFF a lot and makes cold start time to be around 20+ seconds. SiRFGeoRecovTM Reverse EE makes positioning process being done under power saving mode. Reacquisition Time: 0.1 second RF Metal Shield for best performance in noisy environments Hardware and Software Based on the high performance features of SiRFstarV low power single core logic. Adaptive micropower controller Only 50 to 500�¯�¿�½?�?�¼A maintains hot start capability (core logic) < 10mW required for TricklePower mode RoHS compliant (lead-free) Advanced navigation features Smart sensor supported by interface External interrupt input for context change detection MMCX RF Connector Dimension : 3
Ct-G340 S5 of products utilizes SiRFstarV and features Quad-GNSS for tracking GPS, GLONASS, BDS and Galileo satellites. The product family deliver highly accurate continuous location, advanced power management and high interference immunity. These continue to push the envelope of performance in sensitivity, TTFF and urban canyon availability and accuracy. With a built-in DSP and extremely low power consumption, the family can get fast location fixes for geo-tagging images or videos, asset tracking and wearable applications. Advanced low power technology means there is no need to maintain full power to achieve maximum performance nor turning the GNSS receiver completely off to save power. It breaks then old GNSS performance vs. power trade-off through the fusion of a new high-performance GNSS engine, advanced power management and a smart sensor interface to achieve high sensitivity hot-start conditions for fast location fixes. Performance - GPS, GLONASS, Galileo, BDS and SBAS reception for high GNSS availability and accuracy - High sensitivity navigation engine (PVT) tracks as low as - GPS : -165 dBm - GLONASS : -161 dBm - 52 track verification channels - SBAS (WAAS or EGNOS,MSAS) - Active Jammer Remover, removes in-band jammers up to 80 dB-Hz - Tracks up to 8 CW jammers - Multimode A-GPS (Autonomous, MS-Based, and MS-Assisted), need operator support. - Embedded CGEE / SGEE (With back-end server support) speed up TTFF a lot and makes cold start time to be around 20+ seconds. - SiRFGeoRecovTM Reverse EE makes positioning process being done under power saving mode. - Reacquisition Time : 0.1 second - RF Metal Shield for best performance in noisy environments Hardware and Software - Based on the high performance features of the SiRFstarV low power single core logic. - Adaptive micropower controller - Only 50 to 500A maintains hot start capability (core logic)
GPS/GNSS/GALILEO/BDS Module The Ct-G153 utilized SiRFstarV and features Quad-GNSS for tracking GPS, GLONASS, BDS and Galileo satellites. The product family delivers highly accurate continuous location, advanced power management and high interference immunity. These continue to push the envelope of performance in sensitivity, TTFF and urban canyon availability and accuracy. With a built-in DSP and extremely low power consumption, the family can get fast location fixes for geo-tagging images or videos, asset tracking and wearable applications. Performance - GPS, GLONASS, Galileo and SBAS reception for high GNSS availability and accuracy - High sensitivity navigation engine (PVT) tracks as low as GPS:-165dBm,GLONASS:- 161dBm - 52 track verification channels - SBAS (WAAS, EGNOS, QZSS, MSAS, GAGAN) - Active Jammer Remover, removes in-band jammers up to 80 dB-Hz - Tracks up to 8 CW jammers - Multimode A-GPS (Autonomous, MS-Based, and MS-Assisted) - Need operator support - Embedded CGEE / SGEE (With back-end server support) speed up TTFF a lot and makes cold start time to be around 20+ seconds - SiRFGeoRecovTM Reverse EE makes positioning process being done under power-saving mode. - Reacquisition Time: 0.1 second Hardware and Software - Based on the high-performance features of SiRFstarV low power single core logic. - Adaptive micropower controller - Only 50 to 500 A maintains hot start capability (core logic) - < 10mW required for TricklePower mode - RoHS compliant (lead-free) - SMT pads allow fully automatic assembly processes equipment and reflow soldering - Advanced navigation features - Smart sensor supported by I2C interface - External interrupt input for context change detection - Dimension : 11.2 x 10 x 2.3 mm
The SIM7000E is Tri-Band LTE-FDD and Dual-Band GPRS/EDGE module solution in a SMT type which supports LTE CAT-M1(eMTC) and NB-IoT up to 375kbps data transfer. It has strong extension capability with rich interfaces including UART, USB2.0, GPIO etc. The module provides much flexibility and ease of integration for customer's application. The package of SIM7000E is compatible with SIM900 and SIM800F. AT commands of SIM7000E are mostly compatible with SIM800F. This also maximizes the investments of customers, and enables a short time-to-market. It is designed for applications that need low latency, medium throughput data communication in a variety of radio propagation conditions. Due to the unique combination of performance, security and flexibility, this module is ideally suited for M2M applications, such as metering, telematics, asset tracking, remote monitoring ,E-health , mobile pos terminals and sharing bike. General features - Tri-Band FDD-LTE B3/B8/B20 - GPRS/EDGE 900/1800Mhz - Output power - GSM900: 2W - DCS1800: 1W - Control Via AT Commands - Supply voltage range: 3.0V~ 4.3V, Typ: 3.8V - Operation temperature: -40 to +85 - Dimensions: 24 X 24 X 2.6mm - Weight: 3.0g - GNSS (GPS,GLONASS and BeiDou/Compass, Galileo, QZSS) Specifications for Data transfer - LTE CAT-M1(eMTC) - Uplink up to 375kbps, Downlink up to 300kbps - NB-IoT - Uplink up to 66kbps, Downlink up to 34kbps - EDGE Class - Uplink up to 236.8Kbps, Downlink up to 236.8Kbps - GPRS - Uplink up to 85.6Kbps, Downlink up to 85.6Kbps Other features - USB Driver for Microsoft Windows XP/Vista/7/8 - USB Driver for Windows CE/Mobile - USB Driver for Linux/Android - Firmware update via USB - TCP/IP - PPP - SMS - EMAIL - FTP/HTTP/SSL - VoLTE* - FOTA* Interfaces - USB2.0 x1 (high-speed) - UART x2 (7-wire UART and 2-wire UART interface multiplex from GPIO) - SIM card x1 (1.8V and 3V) - I2C x1 - GPIO x5 - ADC x1 Consumption - Power off: 7uA - PSM: 9uA - Sleep: 1mA - Idle: 11mA
Ct-GM551 of products utilizes SiRFstarV and feature Quad-GNSS for tracking GPS, GLONASS, BDS and Galileo satellites. The product family delivers highly accurate continuous location, advanced power management and high interference immunity. These continue to push the envelope of performance in sensitivity, TTFF and urban canyon availability and accuracy. With a built-in DSP and extremely low power consumption, the family can get fast location fixes for geo-tagging images or videos, asset tracking and wearable applications. Features/Performance - GPS, GLONASS, Galileo, BDS and SBAS reception for high GNSS availability and accuracy - High sensitivity navigation engine (PVT) tracks as low as - GPS : -165 dBm - GLONASS : -161 dBm - 52 track verification channels - SBAS (WAAS, EGNOS, QZSS, MSAS, GAGAN) - Active Jammer Remover, removes in-band jammers up to 80 dB-Hz - Tracks up to 8 CW jammers - Multimode A-GPS (Autonomous, MS-Based, and MS-Assisted), need operator support. - Embedded CGEE / SGEE (With back-end server support) speed up TTFF a lot and makes cold start time to be around 20+ seconds. - SiRFGeoRecovTM Reverse EE makes positioning process being done under power saving mode. - Reacquisition Time : 0.1 second - RF Metal Shield for best performance in noisy environments Features/Hardware and Software - Based on the high performance features of SiRFstarV low power single core logic. - Adaptive micropower controller - Only 50 to 500 A maintains hot start capability (core logic) -
