Reinforcement sleeve, also known as reinforced joints: used to connect the steel and corresponding to the thread head thread connections. On rebar stripping rib rolling straight thread connecting a new type of rebar connection sleeve technology and its structure principle is will be end parts of the connected steel bars of longitudinal ribs and transverse rib cutting method of pulling off a part of, and direct rolling into ordinary straight thread after that special straight thread steel bar connecting sleeve connected with, the formation of reinforced connection.
The taper thread coupler is a threaded coupler with an internal taper thread that can be connected to the taper thread of rebar. It offers
advantages such as easy joint connection, easy alignment, good self-locking properties, and fast connection speed. The joint can be
tightened with a wrench by 4-5 turns to meet the torque requirements.
Its installation efficiency is 2-3 times higher than that of parallel-thread coupler.
The company brings the fines quality MS (mild steel), Alloy Steel and Stainless steel bright bars. Manufactured from the best raw steel alloys our steel bright bars They are available in various shapes and sizes like round, square, flat and hexagonal.
ROUNDS: 5mm to 110mm
SQUARES: 6mm to 40mm
HEXAGONALS: 6mm to 40mm
SECTIONALS: As per Required by Customer
We offer superior quality bright bars in a variety of grades, sizes and tolerances.
Applications
They are extensively used in the Automobile industry and products like nuts, rivets, studs, bolts, connecting rods, piston rods, drills, pouches, injector, connecting rods, axles, propeller shafts and many more.
Supply Conditions
Length - 3 to 6.5 Meters
Cold Drawn, Centerless Ground, Peeled & Polished, Rough
Peeled or Smooth Turned bars
Tolerances - h9, h10, h11, k12, k13
Grit Polish as per Customer's Request
Heat Treatment- Annealed, Solution Annealed or Water Quenched
Bars End Finish - Chamfered ends, Plain ends without Burrs or Sharp Edges
Specifications - As per EN, DIN, JIS, ASTM, BS, ASME, AISI, etc.
We are supplier and exporter of TMT Rebars. TMT Bars / Rebar which find usage in the core infrastructure development like construction of Multi Storied buildings, bridges, dams, railways, power plants as reinforcement material. These bars are rolled from Tested billets as per IS 2830 which ensures uniform physical and mechanical properties. The range varies from 8mm to 32mm, conforming to BIS 1786 - Fe 415 and Fe 500. Properties Units IS : 1786 Fe 415 OUR BARS IS: 1786 Fe 500 OUR BARS
1. Angles, Shapes And Sections Of Iron Or Non-alloy Steel.
2. Flat-rolled Products Of Iron Or Non-alloy Steel, Of A Width Of 600 Mm Or More, Hot Rolled, Not Clad, Plated Or Coated.
3. Bars And Rods, Hot-rolled, In Irregularly Wound Coils, Of Iron Or Non-alloy Steel
4. WIRE OF IRON OR NON-ALLOY STEEL
5. INGOTS
6. OTher Bars And Rods Of Iron Or Non-alloy Steel, Not Further Worked Than Forged, Hotrolled, Hot-drawn Or Hot-extruded, But Including Those Twisted After RollinG
