- Magnet assemblies are made up of steel parts and a ceramic magnet, bonded together with epoxy. - Max pull is tested on a ½� thick and flat machined steel plate. But the actual pull should be much smaller if your steel is thinner, rough, rusty, coated or not very flat. For any critical applications, three-time safety factor is strongly recommended. - Besides standard models listed bellow, we can make assemblies based on custom designs. - Applications include magnetic holding, lifting, antenna mounting, positioning, retrieving and more.
Magnet Assy is located on the Target in deposition processing (PVD process) in pre-processing of the semiconductor wafer chips manufacturing. Place the substrate(wafer)on the surface of the MCA E-chuck. Its role is to create the thin film off the Target in a plasma vaccum with its magnetic force. It has a significant role of the wafer thin film creating
Aluminum Composite Panels.
Electric-motor-scrap Used alternator and starter motors.
Tire-steel-wire-scraps.
Used rail( not cut) & 1.5m .Brokerage
Stainless steel wires like piano wire, colored wire.
Flexible sprinkler hoses.
Oil equipment, cast steel valves.
Used rail scrap.
Tungsten carbide scrap.
Flange.
Stainless steel strip coil, steel strapping tape & seal.
Welded mechanical and structural stainless steel pipes, balcony fences, park fences.
Stainless steel tubes, ni-based alloy tube, titanium clad busbar.
Welded stainless steel pipes.
Composite panel, titanium.
Girth flange, wind power flange, blind flange, welding neck flange, threaded flange, slip-on flange, lap joint flange, socket welding flange, pressure vessel, tube sheet, deposti-weld overlay, clad, ball vlave body, back up roll, forged neck, forged nozzle, intermediate shaft.
Stainless steel wire, rope.
Stainless steel sink factory with drain fittings.Export
