Hebei Yida BGZL-40B3 steel bar straight screw thread processing rib peeling machine is the exclusive use rib peeling knurling machine for the straight screw thread connecting. It is mainly used in the processing/fabrication of the end of the structural steel bar. Positive And Negative Screw Thread Model Used in the occasion when the steel bar in the two sides both can not be turned but the lengths can be adjusted.
This Automatic Upset Forging Machine is the preparative machine for rebar connection in construction work. Its main function is to forging the end part of rebar to raise the rebar area and therefore enlarge the strength of rebar end.
BGZL-40B3 steel bar straight screw thread processing rib peeling machine is the exclusive use rib peeling knurling machine for the straight screw thread connecting. It is mainly used in the processing of the top of the structural steel bar.
Rebar cutting tools, rib peeling & threading machine, rebar cold extrusion machine, rebar thread rolling machine, taper thread cutting machine, hydraulic grip rebar coupling, upset forging machine & threading machine, rebar automatic material organizer & feeder machine..
1, Wide working range: adaptable for 12mm- 50mm same diameter, different diameter, bending, new and old, advance covered up rebar of GB 1499, BS 4449, ASTM A615 or ASTM A706 standard. 2, High strength: stronger than the reinforcement bar and guarantees bar break under tensile stress(tensile strength of bar joint =1.1 times of bars specified tensile strength). It can satisfy the requirements stipulated in the Chinese standard JGJ107-2003, JG171-2005. 3, High efficiency: upset forging and threading one joint only needs no more than one minute, and handy operation and quick link. 4, Environmental protection and economy profit: no environment pollution, can work all day, not affected by weather, economize energy source and bar material
Rebar fabrication equipment, bsts rebar thread cutting machine used for LINXION PI mechanical connection, best selled in India market. The advantages: 1.High efficency by manual operation of thread cutting; 2.Easy operate, no need to change other parts at same thread pitch, applied for 16-40mm all diameter deformed bars. 3.Easy and simple for working man
1.Place it well at the working point. 2.Directly use it to press connection point with screwless couplers to link the two rebar.
YDZTS-40C Rebar Taper Thread Cutting Machine is designed and manufactured by Hebei Yida Reinforcing Bar Connecting Technology Co., Ltd. 1. It is mainly used as a special equipment to make taper thread on the end of the rebar in the processing of rebar connection. 2. The applicable diameter is from �¯�¿� 16 to �¯�¿� 40. It applies to Grade �¢?�¡ and �¢?�¢ level rebar. 3. It has reasonable structure, light and flexible, simple operation, high production efficiency. It is widely used in steel bar end processing of taper thread joints in concrete works. 4. It adapts to a variety of complex construction site environment.
Casing with a separate power supply unit power supply of hydraulic tools to squeeze on steel. The final connection ensures a tensile strength of at least 125% of the nominal yield strength of the reinforcement grade 500 MPa.
Rebar Cold Extrusion Technology The Cold Extrusion Machine is made up by a hydraulic Clampy with Cold Pressing Dies and Hydraulic Oil Pump.� Only 1 â?? 3 kw power of oil pump, which is not limited by power capacity, has flexible structure and suitable for operation on several machines. Advantages: No professional and experienced worker needed, able to connect changed steel bar of different diameters. Save 80% of connector steel consumption. Only needs 1 3m to stamp each connector, which is about ten times faster than ordinary welding. No flammable gases, not affected by rainy or cold weather. Relieve congestion of the connecting point, facilitated concrete pouring.
