Find Verified Light Medium Machinery Suppliers, Manufacturers and Wholesalers

Atten ST-2090D 80W Thermostatic Digital Rapid Heating Welding Rework Station Soldering Iron Kit with Soldering Wire Holder, ATTEN ST-2090D Multi-function Digital Thermostatic 80W Lead-free Original Soldering Station for Cellphone BGA SMD PCB IC Repair.

Features:
Max Power of 80 W, soldering iron 28 V AC
Temperature read out in MCU controlled temperature calibration.
Soldering station with solder wire stand.
Auto-standby, Auto-shutdown function are available.
Heating wire and sensor use PTC materials.
Soldering tip designed separate from heater and using common T900 series to save use-cost.
Very fast heating: from room temperature to 350 C only approx. 15 s
Soldering iron with flexible connection cable
Adjustable temperature range 80 - 480 C

Specification:
Model: ST-2090D
Power consumption: 80W
Input voltage: AC 220V
Output voltage: AC 24V
Display method: LED
Temperature range: 80~480 (176 896)
Temperature offset range: 50 (90)
Temperature stability: 2 at idle temperature
Tip to ground resistance:

LAG-S400 Infrared Converter Slag Detection System



Overview

The infrared converter slag detection system uses a far-infrared thermal imager to monitor the situation of converter tapping in real time, and is connected to the main control computer in the electrical room through the conversion and transmission of video signals. The radiation intensity in the infrared wavelength range of 7-14um is different to distinguish molten steel and slag. In the later stage of the converter tapping, the molten steel gradually decreases, and the steelmaking slag is involved in the molten steel and flows out of the tapping hole. After the thermal imager recognizes the steelmaking slag in the imaging temperature measurement, it will give an alarm according to the slag content ratio threshold set by the software. The thermal imager will start the slide plate to close the tapping hole, so as to realize the control of the slag in the converter tapping, and ensure the maximum yield of molten steel and the minimum control of the steelmaking slag content.

The effect of slag detection in converter tapping is of great significance to the control effect of the slag amount. The converter slag detection and control system developed by our company conducts non-contact monitoring of the tapping steel flow through the far-infrared detector thermal imager. It can detect the slag condition in real time and output an alarm signal and control system, which can replace manual visual inspection and provide accurate, efficient and stable slag detection effect. When the system finds the slag, the intelligent control unit quickly makes a judgment of lifting the furnace and blocking the slag and outputs an alarm signal.

As shown in Figure 1, the system includes thermal imager, front purge protection box, front electrical box, power distribution cabinet, main control monitor, monitor of rocking furnace chamber, sound and light alarm, infrared converter slag monitoring software system, etc.


The technical parameters

1. Temperature measurement range: 200-1800

2. Temperature measurement accuracy: 2%

3. Detection accuracy and alarm accuracy: 98%

4. Resolution: 0.5

5. Pixels: 640x240

6. Band: 7~14um

8. Frame rate: 25 frames/sec

9. Equipment service life: 5 years

10. The normal operation rate of the automatic control system 99%