Single Phase Variable Inductive Load - MODEL - VIJAYANTA, INDIA 1. Single Phase Variable Inductive Load, Capacity : 8 Amp, Capacity : 10, Amp
Digital Gauss Meter various types - BRAND - VIJAYANTA, INDIA 1. Digital Gauss Meter (Range : 0 - 2 K Gauss , 0 - 20 K Gauss), Model: DGM 100 2. Digital Gauss Meter (Range : 2 KG to 20 KG), Model: DGM 100A 3. Digital Gauss Meter (Range : 2 KG & 20 KG, Interchangeable Hall Probe), Model: DGM 202 4. Digital Gauss Meter (Range : 2 KG, 20 KG & 40 KG, with differential mode facility), Model: DGM 103 5. Digital Gauss Meter (Range : 0.2 KG, 2 KG, 20 KG & 40 KG, Interchangeable Hall Probe), Model: DGM 204
VARIOUS DC POWER SUPPLIES AS UNDER : Brand Vijayanta , India 1. Solid State Power Supply - 0 - 300 Volt at 1, Amp. Model : S 277 2. Multi-Output Power Supply - 0- 30, Volts at 2, Amps. , 0 to +/-15 Volt at 1,Amp., 4 to 6 Volts at 5, Amps. Model : LV 35 - 3 3. Multi-Output Power Supply - 0 -30, Volts at 2, Amps. , 0 to 15 Volt at 1Amp. 4 Volt to 6 Volts at 2, Amps. Model : LV 35 - 2 4. Dual Power Supply - Dual tracking or 2 independent outputs of 0 to 30 Volts at 0 to 2 Amps. 4 Digital Meters for V & A measurements of both outputs. Model : LV 30 B/2 5. Solid State Power Supply, - 0 30 Volt at 1, Amp. Model ; LV 30/1 6. Solid State Power Supply, - Output : 0- 5, Volt at 0- 10, Amp. Model : LV 05 7. E.H.T. Power Supply - Output : 0- 1500 Volts at 1, mAmp. Model : HV- 20 8. Regulated Power Supply - +/- 12, Volt and +/- 5 Volt at 500, mAmp. Model : D 12 9. 3 Phase S.C. R. Based D.C. Power supply (Rectifier type) - Note : Also available in 30A, 60A ,200A on request Model : TPRU-100 10. 1 Phase S.C. R. Based D.C. Power supply (Rectifier type) - Note : Also available in 15A, 25A ,50A Model : SPRU-100 If you still any enquiry please feel free and contact us.
Designed to measure the winding resistance of transformers, Inductors, generators, motor windings, Tap Changers, Bus bar contacts Etc. Features - Built-in carry case for convenient portability - available in current capacity 10AuP, 25AuP (additional cost) and 50AuP (additional cost) - Simultaneous measurements of voltage & current - Protection against inductive kickback & discharge
4 Terminal measuring device suitable for Resistance measurement of Copper conductors winding wires, Cables etc. Features - 1 micro Ohm to 199.99 Ohm measuring range - 1 micro Ohm (at lowest range) resolution - 3 1/2 digit LED display
The unit is low cost, easy-to-use, individual and multifunctional that enables to measure all the basic parameters required in an electrical installation and monitors electricity over and above basic metering. The entire range is very rugged and cost-effective. All these products are field proven and more than 100,000 units are active in service.
84Watt 12V-7Amp With Battery Backup Power Supply
12Watt 12V-1Amp Power Supply
18Watt 12V-1.5Amp Power Supply
24Watt 12V-2Amp Power Supply
36Watt 12V-3Amp Power Supply
60Watt 12V-5Amp Power Supply
60Watt 12V-5Amp With Battery Backup Power Supply
84Watt 12V-7Amp Power Supply
3 Digit , 7 Segment LED Display Voltage input
4 Digit , 7 Segment LED Display Input 1Ã?? 2 Wire, Voltage and Current input Primary CT Selection up to 50 Amps
Voltage and Current input CT Selectable up to 4000/5 1 Relay for Set KW
2 in 1 meters measure average values of DC Voltage or DC Current. Any two different parameters can be measured in one case with this meter. It is housed in UL 94 V-0 approved polycarbonate case and can be mounted in Mosaic mounting (cascading).
2in1 meters measure two different ranges of frequencies in the range of 45 to 450Hz. For maximum accuracy, the essential measuring range is obtained by suppressing unwanted frequency span. The meter is housed in UL94V-0 approved polycarbonate case and can be mounted in Mosaic mounting.
Analog Meters measure AC/DC Voltage or Current and frequency. These meters are installed on 35mm Din rail, the mounting width is 45mm and it is housed in UL 94 V-0 approved polycarbonate case and can be mounted in Mosaic mounting (cascading).
