Screen: (overall screen) (indiviudual screen + overall screen) (overall screen + steel wire armour) (individual screen+ overall screen+steel wire armour) Sheath version: pvc/lsf/lsoh
Conductor material: solid plain annealed copper referred to bs6360 Insulation material: cellular high density polyethylene Laying-up: pairs; units Wrapping: polyester tape Filler: petrolatum jelly filled Screen: aluminium foil with overlapping Bedding: polyethylene
Applications: Long distance telephone, catv, data communications. Installations: Installed in duct, self supporting (figure 8 self supporting or adss all dielectric self supporting) and direct Burial (with armouring). Construction: The cable consists of a single tube containing 2 up to 24 fibers, which is filled with water-blocking gel. When the Cable contains more than 12 fibers, they are divided in two groups. A colored thread identifies each group. Physical Protection and tensile strength are provided by aramid yarn or fiberglass wound around the tube. Either pe or lszh Jacket can be used. A ripcord is located under the jacket to facilitate jacket removal. Technical parameters: Maximum transmission distance: 6km (single mode); 0.3km (multimode) Maximum pulling load: 1500n (short term installation); 900n (long term installation) Maximum compressive load: 3000n (3.3mm loose tube diameter); 5000n (4.5mm loose tube diameter) Twist (torsion length): 125 x overall diameter Working temperature: -20íµ ~ +70íµ (pe sheath) Storage temperature: -40íµ ~ +70íµ (pe sheath) Product highlights: Small diameter and light weight. Through the control of the fiber exceed length which is the key technology in optical fiber manufacture, the fiber Cable can achieve better pulling load and operating temperature. Tube materials are water resistant and can sustain high tension. Being filled with special water-blocking gel, the Tube can provide water protection for the fibers inside the tube. Compact construction of the fiber cores can prevent the fiber to shrink back. This can sustain higher tensile stress And achieve better flexibility. íewide operating temperature range. Roll, box, drum
í= Applications: Short and medium distance, indoor and protected environments. Offered as a riser, plenum, or general purpose cable, it is used for interconnection of distribution boxes, or the distribution boxes and customer equipments, and between floors. í= Installations: Installed along the wall, the roof, interlayer, canal and indoor. í= Construction: The cable contains 4 to 72 fibers individually buffered to 0.9 mm in a tight or semi tight construction and coded. The cable structure depends on the number of fibers: The 4 to 12 fiber cables contain individual fibers without sub-units,In the 16 to 72 fiber cables the fibers are grouped in the sub-units. In the 4 to 12 fiber cables, the individual fibers are stranded and protected by aramid yarn and a PVC or LSZH jacket. In the 16 to 72 fiber cables, the fibers are grouped into sub-units which are laid helically along the cable axis. Each sub-unit contains 4 to 6 fibers, aramid yarn and a PVC or LSZH jacket. The 72 fiber cable consists of twelve sub-units, nine of them are stranded around a central element made of 3 sub-units. í=Technical Parameters: íe Maximum Transmission Distance: 6km (Single Mode); 0.3km (Multimode) íe Maximum Pulling Load: 100N(Short Term Installation);60N(Long Term Installation) íe Minimum Bending Radius: Short Term Installation: 20 x Overall Diameter Long Term Installation: 10 x Overall Diameter (Non-Armoured); 20 x Overall Diameter (Armoured) íe Twist (Torsion Length): 125 x Overall Diameter. íe Working Temperature: -10íµ ~ +70íµ (PE sheath) íe Storage Temperature: -20íµ ~ +70íµ (PE sheath) í= Product Highlights: íe Small diameter and light weight. íe The high tension characteristics of the aramid yarn serving as strength member can offer good stability in the transmission performance. íe Compact and flexible construction are especially suitable for indoor installations. íe Tight Buffer fibers are made from fiber rods with good linearity and low extruding output. By careful calibration of the vacuum pumping equipment, the uniformity of the outer diameter of the tight buffer fibers can be easily achieved with excellent strip ability. íe LSZH jackets can be offered for indoor application for which flame retardancy is required. íe Cutting edge production equipment, good quality materials and optimized process ensure low induced attenuation within the operating temperature range. íe Fiber geometry are strictly monitored to ensure superior transmission performance. roll,box,drum
Applications: Long distance outside telephone, catv, data, communications. Installations: Installed in duct, self supporting (figure 8 self supporting or adss all dielectric self supporting) and direct burial (with armoring). Construction: The cable consists of 5 to 36 elements stranded in up to 3 layers around a central strength member and bound in a Jacket. The elements are usually fiber containing tubes. However, fillers are also used, when needed to preserve cable Geometry. Two to twelve color coded fibers are loosely laid in each tubes filled with water-blocking gel. Technical parameters: Maximum transmission distance: 6km (single mode); 0.3km (multimode) Maximum pulling load: 1500-2700 n (short term installation); 900-1500n (long term installation) Minimum bending radius: Short term installation: 20 x overall diameter Long term installation: 10 x overall diameter (non armored); 20 x overall diameter (armored) Twist (torsion length): 125 x overall diameter Working temperature: -40íµ ~ +70íµ (pe sheath) Storage temperature: -50íµ ~ +70íµ (pe sheath) Product highlights: All the fiber containing tubes are placed in concentric layers around the central member; through the control of The twist length, the fiber cable can achieve better pulling load and operating temperature. Tube materials are water resistant and can sustain high tension. Being filled with special water-blocking gel, the Tube can provide water protection for the fibers inside the tube. Central member, which is usually either made of dielectric frp, or solid/ stranded steel coated with polyethylene, Are placed at the centre of the cables. Roll, box, drum
Applications: 10base-t, 100base-t4, 100base-tx, 100base-vg-anylan, 155mbps atm, 622mbps atm Working frequency: 1-100mhz Technical parameters: Characteristic impedance: 100ía15ª+ Nominal velocity of propagation(nvp): 69% Maximum dc resistance: 9.38ª+/100m Maximum mutual capacitance: 5.6 nf/100m Maximum capacitance unbalance: 330 pf/100m Maximum resistance unbalance: 5% Maximum propagation delay skew: 30 ns/100m Maximum propagation delay: 536 ns/100m 100 mhz Minimum bending radius: 10 x overall diameter Voltage rating: 60v rms Maximum pulling load: 80n Working temperature: -20 íµ ~ +60íµ Storage temperature: -5íµ ~ + 50íµ Flame retardancy: ul 1581 (cm jacket); ul 1666 (cmr jacket); ul 910 (cmp jacket); iec 60332-1 (frpvc & lszh jacket); iec 60332-1 & iec 60332-3c (lsfroh jacket) Product highlights: Provide excellent bandwidth beyond 100 mhz. Designed for use in data and voice backbone application. Meet the strict flame retardancy and environmental requirements in europe and us. Easily identifiable color code for ease of installation. Transmission properties: Freq: 100 (mhz) Roll, box, drum
we also dealing with pipe and fitting, cable wirless.
BunderTech International Ltd is an official electronic component distributor specifically engaged in passive components such as capacitors, inductors, resistors for many years. we have served thousands of customers worldwide. Our Advantages: 1. Direct support from Original Manufacturer 2. Pretty competitive prices with high quality, much cheaper than Avnet,Digikey,Mouser,Arrow..... 3.Quick response,Any problem you can contact us at anytime,we will do our best to satisfy and support you. 4. Prompt delivery system,on time delivery is always our promise to our customers. 5. Never old/Junk stock,all part to be new and continue supply. 6. Six Month warranty for all parts offering. 7. Customization for special specification and requirement is available. Inner box export carton.
Cooling and heating controller.
Fan controllers Light control / baybus Front i/o adapters Temperature sensors Configurable lcd displays Fan speed controller Manual rpm control Multi fan controller, Fan rpm monitoring and control . Cartons.
The controller is designed for aquarium controlling.It process is directly and efficiently perceived through the senses.The autocontrol including temperature, pump an lights.The customer setting can be remembered when the power shut down.For the physical desigh, we seperate the high voltage circuit from the controlling circuit.This is safe for the operating personnel.The power board print every output name , such as light, uv, .Etc.The controller is necessary for aquarium. CARTONS
Film capacitors Mylar polyester film capacitor---jfa series Metallized polyester film capacitor---jfb series Metallized polyester film capacitor (vac) ---jfc series Box type met polyester film capacito---jfd series r Mini met polyester film capacitor---jfe series Mini laser met polyester film capacitor---jff series Axial met polyester film capacitor---jfg series Polypropylene film capacitor---jfk series Met polypropylene film capacitor---jfl series Box type met polypropylene film capacitor---tbd X2 metallized polypropylene film capacitor---jfn series Series polypropylene fim capacitor---jfp series Box type double sided met polypropylene fim capacitor---jfq series Radial & axial polystyrene film capacitor---jfr series Motor starting capacitor---jfs series
Coaxial cabling is the primary type of cabling used by the cable television industry and is also widely used for computer networks. Common types:RG CoaxURM CoaxCT Coax
Mobile phones, TV cell phones, batteires chargers, fashion electronics, cutting-edge electronics, fashion stereo, digital frames, laptops computer accessories, SPO2 sensors, car dvd player, Car accessories, moulds.
Cables, cable, fiber cable fire resistant & flame retardant, instrument cable, control cable, patch cord, fiber patch cord, telephone cables, electric wire & cable, communication cable, electric wire & cable , coaxial cable..
non-inductive,plastic case sealed with epoxy resin provides interference suppression with,VDE,ENEC and UL approvals opertating temperature:-40c~+110c voltage rating:250/275/305/310VAC capacitance range:0.001~202uF capacitance tolerance:+/-10%
Non-inductive, dip coated, high moisture resistance. Good reputation in use with filtering, dc blocking coupling and general communication equipment. High reliable with its self-healing performance. Coated with epoxy resin for superior heat resistance. Operating temperature:-40c~+85c Rated voltage:100.250.400.630vdc Capacitance range:0.01~6.8uf Capacitance tolerance:+/-5%, +/-10%
Aluminum Alloy dragon cable.It is made of alloy shell,cooper core and dragon woven.It has charge 2 in 1,bold conductor,high strength wire rope,and durable non knot functions. Suitable for
Flat design,not easy to knot,internal use of high purity oxygen free copper wire, strong conductivity,nickel plate connector,resistance to plug and play,two port uniqne non slip setting,more fit finger,and easier to plug speed charging
