Venco Duct Type Electrical Heaters are used to heat the fresh air or to reheat the supply air in ventilation systems. Moreover, it is used to increase the supply air temperature with heat recovery units. All electrical Heaters have TSEK and GOST-R certification and CE marked in compliance with applicable directives.
Venco duct type electrical heaters are classified as VRE and VCE models. VRE models are rectangular duct type heaters and produced with the dimensions as required. VCE models are circular duct type electrical heaters and produced at a dimension of standard spiral duct diameter. All duct type electrical heaters can be connected to the duct system without any accessory.
AL Humidifier complete with + HP Electric motor with or without starter, ceiling hanger, good for 400/440 Volts, 50 cycles, 3 phase, AC supply. The unit is capable of handling 2400 cu.ft. air per minute and evaporate up to 40 liters of water per hour.
Wooden box having the size of 25" x 25" x 25" and Weight approx. 80 Kgs Gross.
Venco heat recovery units (vhr) are designed for saving energy and also improving indoor air quality. Vhr units provide the facilities of air-conditioning applications (residential, commercial and industrial areas) by using the plate type heat exchangers that recover the heat. The heat is transferred from warm air to cold air by the exchangers with high conductivity, efficiency and performance. The unit could be equipped with the accessories; duct type electrical heater, hot water coil, silencer, high efficiency filter, by-pass kit, carbon dioxide or air quality sensor.
Our company to research, develop, manufacture and assemble air-conditioning units for central air-conditioning system are typical manufacturer company. The products are such as split air conditioningíópackaged air conditioning íówindow air conditioner íófan coil unit , air handling fan coil unit , air ¿ccooled/water-cooled chiller , heat recovery water chiller , temperature control/humidity control unit , packaged air handling unit , modular air-cooled heat pump unit , modular water source heat pump unit.
Tg-500b are used in the houses, the ventilating pipes and the small buildings.
1. The ball diameter (body diameter) is 620mm (25inch), and the throat diameter (inner diameter) is 500mm (20inch).
2. There are three kinds of materials they are made of: (a) stainless steel, (b) vanes stainless steel+ others galvanized sheet, (c) vanes aluminum + others galvanized sheet.
3. The volume of air discharge is about 950-4000 cbm/h.
4. It is about 8 kg/set and the ubc bearings we use are from the usa.
5. We guarantee the usage for 15 years.
6. We can design and manufacture other sizes according to your demands.
Tg-600 are usually used in the general industries and the storerooms.
1. Part one is the ball part and the diameter (body diameter) is 750mm, and part two is middle part and the throat diameter (inner diameter) is 600mm. The third part is base plate.
2. There are three kinds of materials they are made of: (a) stainless steel, (b) vanes stainless steel+ others galvanized sheet, (c) vanes aluminum + others galvanized sheet.
3. The volume of air discharge is about 1500-5000m3/h.
4. We can design and manufacture other sizes according to your demands.
3416 Heating Air Conditioner Ventilation Suppliers
Short on time? Let Heating Air Conditioner Ventilation sellers contact you.
