Ship repair equipment, diesels, pumps, emergency equipment, ship engines and parts, ship equipment, electrical fittings, asdic hull outfit, outboard fittings, sea connections.Ship agency service, repair and operation of ships and floating constructions
Luminaires are used for lightning of: Outdoor and indoor lightning facilities with emergency (reserve) lightning Housing of luminaires is made of aluminum alloy. ptics borosilicate glass or polycarbonate. Luminaires have anti-vandal protection. Different types of mounting allow to install luminaires without improvement of the existing mounting attachments.
Small-class intercity bus on the basis of Isuzu units. This bus mostly meets the requirements of the route network with existing passenger traffic and the required efficiency to cost of passenger kilometers. The model worked well on city routes in Ukraine, Belarus, Moldova, Azerbaijan, Armenia, Kazakhstan, Georgia, Russian and other countries. TOTAL INFORMATION Function = Suburban and intercity passenger transportation MAIN CHARACTERISTICS Axels = 4Ñ?2 Length / width / height in view of the air conditioner, mm = 8220/2320/2700 Wheelbase, mm = 4395±5 Front/Rear track, mm = 1900±10/1650±10 Ground clearance, mm = 160 The height of the step above road level, mm = 320 Gross weight, kg = 8850 Curb weight, kg = 5840 The volume of baggage compartments in m3 = 2,7 Turning radius, m = 7,7 ENGINE ISUZU, Type Diesel, Location - Front, longitudinally Cooling system = Liquid TRANSMISSION = ISUZU, manual, synchronized CHASSIS = ISUZU, Japan STEERING = ISUZU, Japan SUSPENSION: Front suspension = Dependent, spring Rear suspension = Dependent, pneumatic spring Tires / Wheels 6Ñ?17,5; 215/75R17.5 BRAKE SYSTEM = Hydraulics with vacuum booster, dual disc brakes on the front axle and the rear axle Parking brake system = With block brake acting on the transmission. Mechanical Drive Secondary brake system = Gasdynamic on the exhaust system Emergency brake system = Each of the circuits of the service braking system Number of doors for passengers = Some single-door service and one spare single leaf doors on the right side of the body, the driver's door on the left side of the body INTERIOR The total passenger capacity, pass = 38/28 Seating places = 29+1 or 28+1 Cabin height, mm = 1900 Heating system = Liquid, combined by the auxiliary heater connected to the engine cooling system and the type of convector heaters installed in the passenger compartment Ventilation system = Supply and exhaust through the vents and hatches Type of seats = semi-soft
New City low-floor bus on the basis of ISUZU units which produced based on global rules and requirements of bus: - compliance with environmental standards EURO-5 - with two double doors and accumulation area in the front and back of the bus for enhanced exchange of passengers - with the possibility of transportation of persons with disabilities of movement - full compliance with the UNECE Regulations 107 - the presence of air conditioning for the driver and passengers SPECIFICATIONS OVERALL DIMENSIONS Length, mm = 8220 Width, mm = 2320 Height, mm = 2700 Wheelbase, mm = 4395 Front track, mm/Rear track, mm = 1900/1650 Minimal turning radius, m = 12,5 Fuel tank capacity, l = 118 SEATING CAPACITY Number of seating positions, excluding crew member = 14-17 (optional +4 folding) Full capacity (with driver) = 49-52 WEIGHT Curb weight, kg = 5240 Gross weight, kg = 8755-8780 AIR CONDITIONING AND HEATING SYSTEM Interior heating, Liquid, combined by the auxiliary heater connected to the engine cooling system and radiator-type heaters installed in the passenger compartment, Ventilation system, Supply and exhaust vents through the side windows and roof hatches; tyres: 6Ñ?17,5; 215/75R17.5 AXLES Manufacturer Isuzu SUSPENSION Front - Dependent, spring Rear - Dependent, air springs STEERING with hydraulic booster BRAKE SYSTEM Working Brake- Hydraulics with vacuum booster, dual disc brakes on the front axle and the rear axle Parking-brake - With block brake acting on the transmission. Mechanical gear Secondary brake - Gasdynamic on the exhaust system Emergency contracting brake - Each of the circuits of the service braking system ABS Category I ENGINE = Isuzu, 4HK1-Ð?5NС, Diesel, common rail, four-stroke, with turbocharger and intercooler: EURO-5 Engine displacement, sm3 - 5,193 Power, kW (hp)/rpm - 114 (154) Torque Nm (kgs.m)/rpm - 419 (42,8) Control fuel consumption l/100 km and no more than: at a constant speed of 60 km/h - from 14,5 l/100 km Cooling system - liquid TRANSMISSION - Isuzu, MYY6S mechanical, synchronized in all forward gears ADDITIONAL SYSTEMS Vehicle Stability Control (EVSC), System of onboard diagnostics (OBD), Traction control system (ASR), Maximum speed fith full load, km/h - 90
SPECIFICATION Product «RECTIFIED TO THE HIGHEST PURIFICATION», min 96,0 % Quality Rectified ethyl alcohol according to DSTU U 4221:2003 Type SURFIN grade A Parameter Target Method of control Appearance Clear and colourless liquid According DSTU 4181 Odour and taste Neutral According DSTU 4181 Chemical parameters: Parameter â??Rectified to the highest purificationâ?? Method of control The volume fraction of ethyl alcohol at a temperature 20Ë? C, %, no less than 96,0 According DSTU 4181 Test of purity with sulphuric acid Withstands According DSTU 4181 Test of oxidizability in min. at 20 ï?° C, no less than 15,0 According DSTU 4181 Mass concentration of aldehydes in recomputation for acetaldehyde in absolute alcohol, mg/dm3, no more than 4,0 According DSTU 4181 and DSTU 4222 Mass concentration of fusel oil: propyl, isopropyl, butyl, isobutyl and isoamyl alcohols, in recomputation for the mixture of propyl, isobutyl, and isoamyl alcohol (3: 1: 1) in absolute alcohol, mg/dm3, no more than 10,0 According DSTU 4181 and DSTU 4222 Mass concentration of fusel oil in recomputation for mixture of isoamyl and isobutyl alcohols (1:1), in absolute alcohol in mg/dm3, no more than 4,0 According DSTU 4181 and DSTU 4222 Mass concentration of esters in recomputation for acetic ester in absolute alcohol in mg/dm3, no more than 5,0 According DSTU 4181 and DSTU 4222 The volume fraction of methyl alcohol in recomputation for absolute alcohol, %, no less than 0,03 According DSTU 4181 and DSTU 4222 Mass concentration of free acids (without CO2) in recomputation of acetic acid in absolute alcohol, mg/dm3, no more than 15,0 According DSTU 4181 Mass concentration of organic substances that are under saponification in recomputation to acetic ester in absolute alcohol, mg/dm3 30,0 According DSTU 4181 Mass concentration of dry residue, mg/dm3 10,0 According DSTU 4181 Test for furfural Withstands According DSTU 4181 For organoleptic and physicochemical parameters ethyl alcohol complies with ISO (GOST, DSTU) Without GMO protocol â?? 932 from 04.11.2013 Material Safety Data Sheet Ethyl Alcohol Rectified to the Highest Purification min 96,0 % Emergency Card â?? 308 Product «RECTIFIED ETHYL ALCOHOL TO THE HIGHEST PURIFICATION», min 96,0 % Quality Rectified ethyl alcohol according to DSTU U 4221:2003 Number OON Name of the goods Toxicity Classification Code 1170 Ethyl alcohol Rectified to highest purification and its water solutions, that contain more than 70% ethanol 4 3212
SPECIFICATION Product «RECTIFIED ETHYL ALCOHOL Pshenichna Sleza», min 96,3 % Quality Rectified ethyl alcohol according to DSTU U 4221:2003 Type SURFIN grade A Parameter Target Method of control Appearance Clear and colourless liquid According DSTU 4181 Odour and taste Neutral According DSTU 4181 Chemical parameters Parameter â??Rectified to the highest purificationâ?? Method of control The volume fraction of ethyl alcohol at a temperature 20Ë? C, %, no less than 96,3 According DSTU 4181 Test of purity with sulphuric acid Withstands According DSTU 4181 Test of oxidizability in min. at 20 ° C, no less than 23 According DSTU 4181 Mass concentration of aldehydes in recomputation for acetaldehyde in absolute alcohol, mg/dm3, no more than 2 According DSTU 4181 and DSTU 4222 Mass concentration of fusel oil: propyl, isopropyl, butyl, isobutyl and isoamyl alcohols, in recomputation for the mixture of propyl, isobutyl, and isoamyl alcohol (3: 1: 1) in absolute alcohol, mg/dm3, no more than 3 According DSTU 4181 and DSTU 4222 Mass concentration of fusel oil in recomputation for mixture of isoamyl and isobutyl alcohols (1:1), in absolute alcohol in mg/dm3, no more than 2 According DSTU 4181 and DSTU 4222 Mass concentration of esters in recomputation for acetic ester in absolute alcohol in mg/dm3, no more than 1.5 According DSTU 4181 and DSTU 4222 The volume fraction of methyl alcohol in recomputation for absolute alcohol, %, no less than 0,005 According DSTU 4181 and DSTU 4222 Mass concentration of free acids (without CO2) in recomputation of acetic acid in absolute alcohol, mg/dm3, no more than 8 According DSTU 4181 Mass concentration of organic substances that are under saponification in recomputation to acetic ester in absolute alcohol, mg/dm3 12 According DSTU 4181 Mass concentration of dry residue, mg/dm3 5 According DSTU 4181 Test for furfural Withstands According DSTU 4181 For organoleptic and physicochemical parameters ethyl alcohol complies with ISO (GOST, DSTU) Without GMO protocol â?? 932 from 04.11.2013 Material Safety Data Sheet Ethyl Alcohol Pshenichna Sleza min 96,3 % Emergency Card â?? 308 Product «RECTIFIED ETHYL ALCOHOL Pshenichna Sleza», min 96,3 % Quality Rectified ethyl alcohol according to DSTU U 4221:2003 Number OON Name of the goods Toxicity Classification Code 1170 Ethyl alcohol Rectified to highest purification and its water solutions, that contain more than 70% ethanol 4 3212
