Product Introduction 3-phase energy meter calibrator introduction: HZ-3521 handheld meter field calibrator is a measurement of electrical parameters power meter calibration wiring judged as one of the high-precision test instrument. Product Characteristics 3-phase energy meter calibrator introduction: TKSX-3 handheld meter field calibrator is a measurement of electrical parameters power meter calibration wiring judged as one of the high-precision test instrument. 3-phase energy meter calibrator technical parameters: Input feature Voltage measuring range: 0 ~ 400V 57.7V 100V 220V 400V fourth gear automatic switching range. Current measuring range: 0 ~ 5A built-in transformer into 5A (CT) files. Clamp transformer for the 5A (small pliers) 25A (small pliers) 100A (the clamp) 500A (the clamp) 400A (tongs) 2000A (tongs) six stalls. (Including medium and large Clamp Meter is optional) Phase angle measuring range: 0 ~ 359.999 Frequency Measurement Range: 45 ~ 55Hz.
Product Introduction This instrument is developed and designed according to the national power industry standard DL/ t506-2007 "insulation gas humidity measurement method for sulfur hexafluoride electrical equipment" and adopts the imported high-precision dew point sensor and new digital circuit control technology. It is a high-precision intelligent instrument to measure the trace moisture content in SF6 gas. This instrument adopts intelligent self-calibration technology wide measurement range fast response high accuracy good linearity dynamic display of measurement curve. At the same time the instrument also has an automatic dryer which can greatly reduce the measurement time. Product nickname intelligent micro water meter micro water meter micro quality meter.
6GHz intelligent radar level gauge is suitable for non-contact continuous measurement of liquid, slurry, granular and bulk materials. It is suitable for temperature, pressure change, inert gas and volatilization. The measurement method of microwave pulse is adopted, and it can work normally in the range of industrial frequency band. Low beam energy, can be installed in a variety of metal, non-metal containers or pipes, no harm to the human body and the environment. Application:Simple corrosive liquid in the process Skyline:PTFE Measuring range: 20 meters Frequency range: 6.8GHz Accuracy: 0.1%FS Medium temperature: -40 to +130 °C Process pressure: -0.10.3Mpa Power supply: 24vDC (two-wire, four-wire optional) Signal output: 4...20mA/HART (two lines/four lines)/ RS485/Mod bus Process connection:Thread Protection level: IP67 Explosion-proof grade: Exia IIC T6 Ga
High Frequency Radar Level Meter Design features: Small antenna size, easy to install; non-contact radar, no wear, no pollution Hardly affected by corrosion or foam; hardly affected by changes in water vapor, temperature and pressure in the atmosphere. Severe dust environment has little influence on the work of high frequency level gauge. Shorter wavelength, better reflection on inclined solid surfaces The beam angle is small and the energy is concentrated, which enhances the echo ability and helps to avoid the interference. The measurement blind area is smaller, and good results can be obtained for small tank measurement. High signal-to-noise ratio, even in the case of switching, can achieve better performance High frequency is the best choice for measuring solid and low dielectric constant medium Application: various corrosion liquid Antenna material: PTFE Measurement range: 10 m Process connection: thread, Flange Medium temperature: -40C --130 Process pressure:-0.1~0.3MPa Accuracy: ±5mm Power supply: 24VDC (two lines, four lines) Protection grade: IP67 Frequency range: 26GHz Explosion-proof grade: Exia C T6 Ga/ Exd ia IIC T6 Gb Signal output: 4. 20mA/HART (two / four) RS485/Mod bus
Digital Gauss Meter various types - BRAND - VIJAYANTA, INDIA 1. Digital Gauss Meter (Range : 0 - 2 K Gauss , 0 - 20 K Gauss), Model: DGM 100 2. Digital Gauss Meter (Range : 2 KG to 20 KG), Model: DGM 100A 3. Digital Gauss Meter (Range : 2 KG & 20 KG, Interchangeable Hall Probe), Model: DGM 202 4. Digital Gauss Meter (Range : 2 KG, 20 KG & 40 KG, with differential mode facility), Model: DGM 103 5. Digital Gauss Meter (Range : 0.2 KG, 2 KG, 20 KG & 40 KG, Interchangeable Hall Probe), Model: DGM 204
This instrument is developed and designed according to the national power industry standard DL/ t506-2007 "insulation gas humidity measurement method for sulfur hexafluoride electrical equipment" and adopts the imported high-precision dew point sensor and new digital circuit control technology. It is a high-precision intelligent instrument to measure the trace moisture content in SF6 gas. This instrument adopts intelligent self-calibration technology wide measurement range fast response high accuracy good linearity dynamic display of measurement curve. At the same time the instrument also has an automatic dryer which can greatly reduce the measurement time. Product nickname intelligent micro water meter micro water meter micro quality meter.
Designed to measure the winding resistance of transformers, Inductors, generators, motor windings, Tap Changers, Bus bar contacts Etc. Features - Built-in carry case for convenient portability - available in current capacity 10AuP, 25AuP (additional cost) and 50AuP (additional cost) - Simultaneous measurements of voltage & current - Protection against inductive kickback & discharge
4 Terminal measuring device suitable for Resistance measurement of Copper conductors winding wires, Cables etc. Features - 1 micro Ohm to 199.99 Ohm measuring range - 1 micro Ohm (at lowest range) resolution - 3 1/2 digit LED display
The unit is low cost, easy-to-use, individual and multifunctional that enables to measure all the basic parameters required in an electrical installation and monitors electricity over and above basic metering. The entire range is very rugged and cost-effective. All these products are field proven and more than 100,000 units are active in service.
Tank feeding bulk powder Tank Loading Mass Flow Meter realizes quantitative and accurate loading and one-button operation of powdered bulk materials, greatly improves loading efficiency, saving labor costs and improves working environment. At the same time, combining with other intelligent automation devices, the bulk powder process is fully automated, which is a new type of environmentally-friendly quantitative loading equipment. Applicable: cement, fly ash, mineral powder, alumina powder, calcium carbide powder, etc. Accuracy: ±1.0%; Flow rate: 250~800m³/h Product Features 1. Like a gas station, loading as required quantity; 2. One button to start loading automatically; 3. Since the release process is automatic and stable, accurate loading, the equipment can protect the environment and improve the working condition; 4. Height of 700mm is enough for installation, and the modification period is as short as 1-2 days; 5. It can be connected to Fengbo intelligent cloud service platform to realize early diagnosis, early warning, remote guidance and rapid maintenance. There are more than 300 successful applications and a thousand sets are installed in the cement, power, and metallurgy industry.
3 Digit , 7 Segment LED Display Voltage input
4 Digit , 7 Segment LED Display Input 1Ã?? 2 Wire, Voltage and Current input Primary CT Selection up to 50 Amps
Voltage and Current input CT Selectable up to 4000/5 1 Relay for Set KW
Our STS prepaid electricity meter is certificated by STS association that is from South Africa. The meter is built-in prepayment algorithm, will cut off the power automatically if the credit in the meter be used up. And will reconnect automatically if the meter recharge for his meter. This kind of meter is very popular on the Africa and Asia, Nigeria, Tanzania, Ghana, Syria Indonesia, installing millions of STS keypad prepaid electricity meter.
Our STS prepaid electricity meter is certificated by STS association that is from South Africa. The meter is built-in prepayment algorithm, will cut off the power automatically if the credit in the meter be used up. And will reconnect automatically if the meter recharge for his meter. This kind of meter is very popular on the Africa and Asia, Nigeria, Tanzania, Ghana, Syria Indonesia, installing millions of STS keypad prepaid electricity meter.
We are distributors of Phase Scientific covid-19 test kits. 1. Phasify Viral RNA extraction kits - $600/ 100 reactions. 2. INDICAID - RAPID ANTIBODY TEST - $300/25 KITS PER BOX
2 in 1 meters measure average values of DC Voltage or DC Current. Any two different parameters can be measured in one case with this meter. It is housed in UL 94 V-0 approved polycarbonate case and can be mounted in Mosaic mounting (cascading).
2in1 meters measure two different ranges of frequencies in the range of 45 to 450Hz. For maximum accuracy, the essential measuring range is obtained by suppressing unwanted frequency span. The meter is housed in UL94V-0 approved polycarbonate case and can be mounted in Mosaic mounting.
Analog Meters measure AC/DC Voltage or Current and frequency. These meters are installed on 35mm Din rail, the mounting width is 45mm and it is housed in UL 94 V-0 approved polycarbonate case and can be mounted in Mosaic mounting (cascading).
ML14xx is Multiload Monitor with 12 single phase load or 4 three phase load option. It measures important electrical parameters of multiple loads simultaneously in a single unit, eliminating the need and cost of multiple panel meters. It provides quick, easy and error free current connections with plug and play connectors. It measures real time electrical parameters like Active / Reactive / Apparent energy and power, current, THD, demand, max demand for each load. The instrument has 4 configurable relay outputs, which can be used for Limit / Pulse / Residual Current / 3Phase Load Health Monitoring / Tariff / RTC / Timer tripping or alarms. This instrument communicates with either MODBUS or Ethernet connection
