Light Cycle Oil (LCO) is a diesel boiling range product from Fluid Catalytic Cracking Units (FCCUs). FCCU is responsible for the production of petrol, LPG and Light Cycle Oil (LCO). There are various ways of economically upgrading LCO, which include hydrotreating, high pressure hydrocracking for full conversion of LCO into Naphtha and a more optimized partial conversion hydrocracking process. It can be used in susch industries as Agrochemical, Crude Oil, Petrochemicals, Petroleum Products.
PETROALLIANCE diesel fuel is the second distillate of crude oil. Ultra-low sulfur grades of D2, such as GOST 305-82, with a reduce sulfur content to a maximum of 0.02 percent and reduce sulfur pollution emissions. Diesel fuel is often used in diesel engines. Diesel engines or compression ignition engines, rely on the temperature increase of compression, rather than on spark plugs, to achieve reliable ignition timing and combustion efficiency. As a result of their inherently higher compression ratio for a given power output, diesel engines are more fuel efficient than spark ignition engines. Compared with spark ignition automotive engines, diesel engines weigh more, generate more vibration and produce greater particulate or soot emissions. Diesel engines can also produce a particularly carcinogenic type of hydrocarbon pollutant known as polycyclic aromatic hydrocarbons (PAHs), which are generated during the diesel combustion process. The cetane index is a measure of the autoignition quality of a diesel fuel, with higher numbers meaning that the engine is easier to start in cold weather. Our products are exported to Asia, Europe, America, and the CIS.
Diesel fuel is generally a liquid fuel used in diesel engines, which ignites the fuel without sparking by compressing the inlet air mixture and then injecting the fuel. (Glow plugs, grid heaters, and block heaters help achieve high combustion temperatures during cold weather starting.) The most common type of diesel fuel is specific fractional distillation of fuel oil, but alternatives that are not derived from oil, such as biodiesel, biomass to liquid (BTL) or gas to liquid (GTL) diesel, are increasingly being developed and adopted. To distinguish these types, in some academic circles, petroleum-derived diesel fuel is increasingly referred to as oil-oil. Ultra Low Sulfur Diesel (ULSD) is the standard for determining substantially reduced sulfur diesel.
Ultra Low Sulfur Diesel EN590,DIESEL D2,DIESEL VIRGIN OIL D6 We have the below available products ready for supply. Contact us for immidate transaction 1) D2- Gas Oil (Diesel) Lo.2-62 Gost 305-82 , Quantity- 50,000mt - 500,000mt For Cif And Fob, Spot And Contract Basis. 2) Jp54 Aviation Kerosine Colonial Grade 54 Russia Origin, Quantity- 1,000,000bbls 8,000,000bbls For Cif And Fob, Spot And Contract Basis. 3) Aviation Turbine Fuel Jet A-1 Quantity- 1,000,000bbls 8,000,000bbls For Cif And Fob, Spot And Contract Basis. 4) Bitumen Quantity - 50,000mt - 500,000mt, Cif And Fob, Spot And Contract Basis. 5) M100 Mazut 100 Gost 10585-99 And 10585-75, Quantity- 50,000mt 500,000mt, Cif And Fob, Spot And Contract Basis. 6) Liquid Petroleum Gas.Gost 20448-90, Quantity 50,000mt- 500,000mt, Cif And Fob, Spot And Contract Basis. 7) Liquified Natural Gas, Quantity 50,000mt 500,000mt, For Cif And Fob, Spot And Contract Basis. 8) Russia Sn 150 Base Oil, Quantity - 5,000mt - 50,000mt, For Cif And Fob, Spot And Contract Basis. 9) Russia Sn 500 Base Oil, Quantity - 5,000mt - 50,000mt, For Cif And Fob, Spot And Contract Basis. 10) En590 Biodiesel, Quantity 50,000mt- 500,000mt, For Cif And Fob, Spot And Contract Basis. 11) Automotive Gas And Oil (Ago), Quantity 50,000mt - 500,000mt, For Cif And Fob, Spot And Contract Basis.
Petroalliance diesel fuel is the second distillate of crude oil. Ultra-low sulfur grades of D2, such as GOST 305-82, with a reduce sulfur content to a maximum of 0.02 percent and reduce sulfur pollution emissions. Diesel fuel is often used in diesel engines. Diesel engines or compression ignition engines, rely on the temperature increase of compression, rather than on spark plugs, to achieve reliable ignition timing and combustion efficiency. As a result of their inherently higher compression ratio for a given power output, diesel engines are more fuel efficient than spark ignition engines. Compared with spark ignition automotive engines, diesel engines weigh more, generate more vibration and produce greater particulate or soot emissions. Diesel engines can also produce a particularly carcinogenic type of hydrocarbon pollutant known as polycyclic aromatic hydrocarbons (PAHs), which are generated during the diesel combustion process. The cetane index is a measure of the autoignition quality of a diesel fuel, with higher numbers meaning that the engine is easier to start in cold weather. Our products are exported to Asia, Europe, America, and the CIS
For latest pricing Enquiry., Please contact US with phone number and contact details
Mazut-100 is a fuel oil that is manufactured to GOST specifications, for example GOST 10585-75/99. GOST is the Russian system of standards. Mazut is almost exclusively manufactured in the Russian Federation, This product is typically used for larger boilers in producing steam since the BTU content is high. The most important consideration when grading this fuel is the sulfur content, which can mostly be affected by the source feedstock. For shipment purposes, this product has a high viscosity which drastically affect whether it is able to be pumped, shipping has unique requirements. Mazut is much like Number 6 Oil, and is part of the products left over after gasoline and lighter components are evaporated from the crude oil. The main difference between the different types of Mazut-100 is the content of sulphur. The grades are represented by these sulfuric levels: - "Very Low Sulphur" is mazut with a sulphur content of 0.5% - "Low Sulphur" is a mazut with a sulphur content of 0.5-1.0% - "Normal Sulphur" is a mazut with a sulphur content of 1.0-2.0% - "High Sulphur" is a mazut with a sulphur content of 2.0-3.5% - Very Low Sulfur mazut is generally made from the lowest sulfur crude feedstocks.
D2 is a refinery abbreviation for Gasoil. It is the second distillate from the crude oil, and can be used without reformers and additives. So, the first engines used D2 as fuel before petrol cars as we know them today was invented. That is because the engine invented by a German called Diesel, requires no spark plugs. The diesel engine will ignite and combust when the pressure increases so that the heated plug makes it explode. Here we get the name Diesel since the same principles are used in diesel engines today. However, automotive diesel that you fill has additives that the refinery will add to make the engine more efficient and also easier to start in the winter. Diesel changes flash point in the winter. It also has additives to absorb water that condense. If you use summer diesel in the winter, you will get better mileage, but your fuel pipes may freeze and can also burst, and the wax makes the diesel flow thicker.
We can supply Diesel en590 10ppm with very good price. Not necessary to follow seller process, seller will follow buyer own procedure. If you want we can immediately arrange a meeting with End seller Only for serious buyer
A) C.I.F. - COST, INSURANCE, FREIGHT PROCEDURE: 1. Buyer issues an official Irrevocable Corporate Purchase Order (ICPO), with Sellers procedures. 2. Seller issues Sales and Purchase Agreement (SPA) open for amendment via mandate to Potential Buyer. 3. Potential Buyer countersigns, duly initial by Co- Buyer and sends back to Seller the aforesaid SPA in Acceptance. 4. Seller issues, SGS report, Certificate of origin and product attestation letter to buyer. 5. Seller requests the nominated shipping company to issue the Charter Party Agreement (CPA) for Seller to sign with the shipping company as the Consignee to be shown on the Bill of Lading to whom the shipment is consigned. 6. Seller submits the Contract to the Ministry of Energy for Legalization and final approval and notarization (if required), Buyer and Seller make 50% payment of Shipment value via MT103 TT 7. Seller Legalizes the Draft contract, and send the final approved contract to Buyer via Secured Email service along with PPOP which include: Product Passport (Quantity & Quality Dip Test Analysis Report). Certificate of Origin. Copy of TSR (Tank Storage Receipt) at Loading Port. Legalized Contract (SPA). Export License. Fresh Data marine analysis Report Note: Freight Payment (50/50 between Seller & Potential Buyer). Such payment shall be deducted from the final cargo payment. 8. All parties involved in this transaction sign the NCNDA/IMFPA to product for all intermediary's commission(s) as payable by each side oneself separately. 9. Once Receipt of Payment as aforesaid Seller commences loading of the product into the chartered oil tanker vessel and provides the following shipping documents via CoBuyer to the Potential Buyer after loading: Ocean Bill of Lading Cargo Manifest Certificate of Insurance Certificate of Ownership Ullage Report SDS (Safety Data Sheet) The Quota Allocation Certificate issued by the Ministry of Energy 10.Upon vessel on arrival to the Discharge Port, Seller issues ATB/DTA via mandate to Potential Buyer and meantime directs the Captain to dock with the shipping agent along with inspection team to conduct Dip Test in the Vessel Tanker to confirm Q&Q. 11.Upon successful RESULT of Dip Test, Potential Buyer causes his bank to pay via Swift MT103 by T/T wire.
Engineering products, agriculture equipment, textile items.
Mazut m100 gost 10585 99 crude oil rebco gost 51858 2002 russian east siberian pacific basin crude oil (espo) petroleum coke granular urea 46% light cycle oil (lco) gost 56871 2016 russian diesel en590, euro 6, (10ppm), gost r 52368 2005 gas oil d2 l0,2 62 gost 305 82 virgin fuel oil d6 aviation kerosene grade 54 jet fuel a1 gost 10227 86 lpg liquefied petroleum gas gost 20448 90 lng liquefied natural gas gost 5542 87.
All petroleum products like jet a1, virgin oil d6, d2 diesel, mazut, lng, en59 diesel 10ppm, base oil, pet coke, lng & lpg etc, used cars, building materials, and food products.Trade, import and export
Product Description D6 is also be known as Residual Fuel Oil and is of high-viscosity. This particular fuel oil requires preheating to 220 - 260 Degrees Fahrenheit. D6 is mostly used for generators. D6 is a type of residual fuel, mainly used in power plants and larger ships. The fuel requires to be preheated before it can be used. It is not possible to use it in smaller engines or vessels/vehicles where it is not possible to pre-heat it. D6 is its name in the USA. In other parts of the world it has other names Price of product ( USD price or FOB price) : USD 0.65 - 0.70 per Gallons Product origin : Russian Key Specifications/Special Features : International Standard Minimum Order Size and Packaging details : 10000000 Gallons
Product Description EN 590:1993 . The first EU diesel fuel specification. It established a sulfur limit of 0.2% and a cetane number of 49 in onroad and nonroad diesel fuels. Sometimes referred to as Euro 1 diesel fuel. EN 590:1996 This standard reflected a new sulfur limit of 500 ppm. Price of product ( USD price or FOB price) : USD 250 - 260 per MT Product origin : Russian Key Specifications/Special Features : International Standard Minimum Order Size and Packaging details : 25000 MT
Product Name : Fuel Oil / Light Diesel Oil (LDO) Flash Point : 62 Density @ 15c : 0.907 Viscosity @ 50c : 17.72 Viscosity @ 100c : 5.05 Water Content : less than 1. Sediment by Extraction : 0.57 Ash Content : 0.931 Caloric Value : 10151 Available at Mumbai
Density @15C : 0.8833 kg/L Kinematic Viscosity @50C : 6.010 cSt Flash Point (Proc.B):
D2, Diesel and AGO now available direct from our allocation.
Type Diesel 10ppm Quantity 6000000 MTS per month Delivery Terms CIF CNF FOB Payment Terms DLC SBLC
Sajal International has a huge market value in Oil Industry and the reason for it is a quality and quantity of the material provided to their valuable clients.