Find Verified Builders Hardware Construction Material Equipment Suppliers, Manufacturers and Wholesalers

PVC coated tarpaulin fabric, is produced by 100% polyester fabric, double side coated with high quality PVC raw material, to make the vinyl coated fabrics have good waterproofing and all level blockout characters, at the same time, for the application of polyester fabric, it gives good tearing and breaking strength to the PVC coated fabric. It can be produced in different weight and thicknesses, to meet customer requirement.

What is� PVC coated fabric?

PVC coated tarpaulin fabric, is produced by 100% polyester fabric, double side coated with high quality PVC raw material, to make the� vinyl coated fabrics� have good waterproofing and all level blockout characters, at the same time, for the application of polyester fabric, it gives good tearing and breaking strength to the� PVC coated fabric. It can be produced in different weight and thicknesses, to meet customer requirement.


Production process of� PVC tarpaulin fabric:

There are several types of production of� PVC coated fabric material:


Knife coated PVC fabric:

It is liquid PVC spread on high density woven polyester fabric, with a knife above the fabric, keep the top of fabric with same thickness PVC coated, then going to heater and cooler process to solidate the PVC onto polyester fabric.
Main advantages and disadvantages: Higher peeling strength because the liquid PVC has more falling into polyester fabric; at the same time, as the high temperature of the PVC during heating process, the fabric would be a little fragile and it is a little less tearing strength compared to other production process.


Hot melt coated PVC fabric:

It is polyester fabric and PVC film laminated together, during the process, PVC film and the polyester fabric are brushed with strong glue to adhere together, and before laminating, PVC film is heated to semi-melted status, in this case, the peeling strength is strengthened while it has more air tightness compared to knife coating PVC fabric, it is ideal products for inflatables.


Hot laminated PVC fabric:

Hot lamination is a knitted polyester fabric laminated with PVC film under temperature 100-120â??. It is used for temporary tents and awnings.

MAG7000 Flow Meter
https://www.leestransmitter.com/products/7000electromagnetic-flowmeter/

An electromagnetic flow meter (mag meter) measures the flow rate of conductive liquids using Faradayâ??s law of electromagnetic induction. When a conductive fluid flows through a magnetic field, it generates a voltage proportional to the flow velocity, which the meter converts into a flow measurement.

Key Features of MAG7000 Flow Meter
Non-intrusive measurement â?? No moving parts, reducing maintenance.
High accuracy â?? Typically �±0.5% of flow rate.
Suitable for various liquids â?? Works with water, slurries, acids, bases, and beverages.
Bidirectional measurement â?? Can measure flow in both directions.
Wide pipe sizes â?? Available from small to very large pipelines.
Selection of installation site
The measuring tube must be fully filled with medium at all times â?? electromagnetic flowmeters cannot operate normally when the tube is not full or empty.
1) Select a straight pipe section filled with liquid, such as a vertical section of the pipeline (the flow direction is preferably from bottom to top) or a horizontal pipe filled with liquid (the lowest point of the entire pipeline is the Xuan). During the installation and measurement process, non-full pipe conditions must not occur.
2) The measurement position should be selected at a location greater than 5D upstream of the flowmeter and a straight pipe section of 3D downstream.
3) The measurement points should be selected as far away as possible from pumps, valves and other equipment to avoid their interference with the measurement.

4)The measurement points should be selected as far away as possible from large radio frequency, strong magnetic fields, strong vibration interference sources, etc.

Feature of TONSON Spray gun series:
ScW99 Low pollution spray gun working efficient +5times save energy 70%, better hoarfrost effect, Width +1. 5%, Smooth surface
ScTS-7P Streak spray gun
ScTS-7P Spot spray gun Spray protrude, flat spot, smooth surface
ScMulti-color spray gun two color above/once
ScW99 Super-particulate optimized gun
ScW99-P High-adhesive spray gun Working efficiency +5 times, Save energy 70%, Save solvent 50%
ScW99-G Gravity optimized gun Optional 400cc transparent cup, Light weight (390kg)
ScW-1-S Suction spray gun attach mixer (enable color to mix well)
ScW-1-G Gravity spray gun attach mixer
ScW-2 Two liquid spray gun (mixes two liquid such as, composite paint material, hardener, then instant harden suitable for FRP. PU)

Used excavator
CAT excavator 330, 320...
komatsu PC series
Hitachi 220, 210
Doosan, Kobleco, Sanyi
Used Komatsu Hitachi CAT used excavator

Product : Blank Door
Materials : Raw Wood Material
Wood material Pine Wood
Type : Hand-swift
Process mould pressing
Quality : Grade A
Customise : OK
Colour : Customise
Size : Customise

Yingfan Polypropylene (PP) biaxial geogrid is a high-performance soil reinforcement product to resist elongation when subjected to heavy loads for long periods of time. By reducing the cost of construction, the biaxial geogrid can meet project requirements and offer full technical support. (Please note that the price is not stable due to raw material (influenced by oil price) and exchange rate.)

Product Features
- Stabilization
- Reinforcement
- Durability and high resistance

Usage Areas
- Municipal roads, Railway ballast, highways, and airports
- Industrial shipping yards
- Parking lots, steep slopes
- Retaining walls, bridge abutments... and more

Standard Size
- 3/4/6 m width
- 50-100 m length
- Upon request

Ip 55 enclosures
Mutiple feet locations
Aluminium frame, end shields and base
High strength cable gland
Shaft key and protector suppplied
Superior paint finish
S1 duty
Utilise vacuum impregnated
Class f insulaton

Packed in a carton