Synthetic technology motor oil specially designed for modern high performance engine with gasoline direct injection (GDI and Turbo-GDI) systems. Developed by latest evolution technology platform EVOTEC fortified with SMART Molecules that improve engine cleanliness and prevent low-sped pre-ignition (LSPI). Outstanding low friction and heat resistance enhance acceleration response, wear prevention and maintaining engine power for better drivability in all situations.
APPLICATION
Designed for high performance gasoline engine both GDI and Turbo-GDI.
Recommended for passenger car, sport car and SUV equipped with start-stop system.
Suitable for all port fuel injection (PFI) gasoline engines running with unleaded gasoline (ULG) and ethanol blended gasoline (E10, E20 and E85).
KEY FEATURES
Enhance excellent engine cleanliness especially in piston and help reduce LSPI occurrence in Turbo-GDI engine by SMART Molecules.
Improve superb engine protection against wear and prevent timing chain elongation for maintaining maximum engine performance.
Outstanding low oil friction with high heat resistance by EVOTEC technology for superior acceleration responsiveness and reduced oil consumption.
Better oil degradation resistance and engine sludge prevention through oil drain intervals.
Product Properties for AdBlue as per the revised ISO22241 standard.
Urea 32,5 % (approximate) solution dissolved within deionised water. As required by SCR equipped vehicles under the provisions of Emissions standards Euro IV (Euro4), Euro V (Euro5) & Euro VI (Euro6).
Urea Content 31.8 33.2 % by weight
Density at 20C 1.0870 1.0930 g/cm
Refracting Index at 20C 1.3814 1.3843
Alkalinity as NH3 0.2 %
Biuret 0.3 %
Aldehyde 5 mg/kg
Insolubles 20 mg/kg
Phosphate (PO4) 0.5 mg/kg
Calcium 0.5 mg/kg
Iron 0.5 mg/kg
Copper 0.2 mg/kg
Zinc 0.2 mg/kg
Chromium 0.2 mg/kg
Nickel 0.2 mg/kg
Aluminium 0.5 mg/kg
Magnesium 0.5 mg/kg
Sodium 0.5 mg/kg
Potassium 0.5 mg/kg
Our Wood Coating is one of the best seller products. Based in Mumbai, Maharashtra we offer a huge variety of 15 natural stains that have been especially specially formulated with the superior quality solvent based fast drying stains that aid in accentuating the natural beauty of the wood grains. Wipe and fill the surface and further smooth sand the surface with a 180 grit paper. Next, apply stain with muslin cloths in addition to the grains. Further let the surface dry for about 30 minutes before the application of the finish coat. You can mix the stains with the NC/ melamine finishes approximately 20% by volume, if required. Never mix the stains woody or PU finishes. We are the leading exporter, supplier and manufacturer of Wood Coatings.
SYNTHETIC RED OXIDE PRIMER
SYNTEHTIC GREY OXIDE PRIMER
SYNTHETIC WOOD PRIMER
SYNTHETIC ZINC PHOSPHATE PRIMER
SYNTHETIC ZINC CHROMATE PRIMER
ETCH PRIMER
TOPCOAT OIL ENAMEL PEINTURE
PREMIUM OIL PAINT FOR METAL
SYNTHETIC UNDERCOAT
HAMMER FINISH
HAMMER FINISH GOLD/SILVER/COPPER PAINT
