The pan/tilt IP Network Camera is designed with the user-friendly idea deep in mind. The user can install The SD-1015 easily on his/her home network and then access the IP Camera anywhere in the world through the accompanied video management software-CamView without setting some complicated DNS name or changing the routers settings. Its just a plug & play action. With 3GPP/ISMA support, users can see the video of the IP camera on any 3G mobile phone anywhere, anytime. For indoor surveillance and remote monitoring, the SD-1015 provides the best image quality in its class, and excellent performance. The built-in microphone enables remote users to not only view, but also listen for additional monitoring options. The NAS storage function can easily turn any NAS device to a NVR device. The schedule function provides full scheduling of email/ftp sending, motion detection and NAS recording event. With the ActiveX support, users can also see the video display on the Windows IE browser. The SD-1015 IP Camera supports the WEP and WPA (Wi-Fi Protected Access) security modes to provide the best security for wireless networks. The SD-1015 IP Camera provides motion detection function. Specifications Models SD-1015 Power DC 5V, 2A Processors RISC CPU, hardware video processing and compression. Network interface Ethernet 10BaseT/100BaseTX, Auto-MDIX, RJ-45. Wireless interface IEEE 802.11g 6 - 54 Mbps IEEE 802.11b 1 - 11 Mbps Transmit power: 14.5dBm typically @ 802.11g 17.5dBm typically @ 802.11b Receiver sensitivity: 54Mbps: Typical -73dBm @ 10% PER 11Mbps: Typical -86dBm @ 10% PER Antenna gain: 1.8 dBi. Pan/Tilt control Pan range 130íp ( -65íp ~ 65íp ) Tilt range 90íp ( 0íp ~ 90íp ) Auto pan mode Auto patrol mode Image sensor RGB VGA 1/4 inch CMOS Automatic exposure control, automatic white balance, automatic gain control, automatic brightness control. Light sensitivity 0.2 Lux Lens 3.2 mm, F2.0, viewing angle: 60.3íp, fixed iris. focus range: 30 cm to infinity D/I D/O interface 1 D/I for alarm detection 1 D/O for alarm triggering Micro-SD card interface Micro-SD card interface for local video storage The supported Micro SD-Card capacity is up to 16G bytes. Buttons One reset button, to factory default settings Indicators One LED for internet connection status indication One LED for Ethernet connection indication Enable/disable ¿C web configurable Video compression MPEG-4 Part 2 (ISO/IEC 14496-2) with motion detection, profiles: Simple Profile, level 0-3 Frame rate Up to 30 fps in all resolutions Video streaming MPEG-4 Separate frame rate/resolution/bandwidth settings for PC and mobile. Video settings Resolution: VGA(640x480), QVGA(320x240), QQVGA(160x120) Bandwidth : 64k, 128k, 256k, 512k, 768k, 1M, 1.2M, 1.5M bps Frame rate : 1~5, 10, 15, 20, 25, 30 fps Audio Built-in microphone for audio monitoring Audio compression: MP2 audio, AMR-NB for 3GPP/ISMA(RTSP streaming) Security Web management username/password protection Video display ID/password protection WiFi WEP and WPA security mode Installation, management and maintenance Installation tool on CD and Web-based configuration Automatic configuration backup and restore Video management software-CamView for video access and multi-camera management Firmware upgrades via FTP Minimum Web browsing and management software requirements Built-in web server for standard web browser access Pentium 4(or equivalent AMD) CPU 1.0 GHz or higher, 1 GB RAM Supported protocols IPv4, HTTP, TCP, ICMP, RTSP, RTP, UDP, RTCP, SMTP, SNTP, FTP, DHCP, ARP, DNS, PPPoE, etc. Accessories (included) Power adaptor, RJ45 ethernet cable, quick installation guide, CD with installation tool/software and Userí»s Manual, ID/Password card. Video management software Surveillance application for viewing and archiving up to 16 cameras Users Up to 20 simultaneous unicast users (depends on video settings) Alarm and event management Events triggered by video motion detection Notification/upload of JPEG images over FTP and/or email Dimensions (HxWxD) and weight 120 x 91 x 84 mm, 350 g, camera body only. Approvals EMC - CE, FCC Part 15 Subpart B Class B Wireless RF - CE, FCC Part 15 Subpart C Power supply: CE, FCC, UL, EN 60950 Operating conditions 0-50 ípC . Humidity 20 - 80% RH (non-condensing). 1piece/1 gift box.
