ADG779BKSZ-Overview Packed in 6-TSSOP, SC-88, SOT-363, the electronic component is convenient for shipping overseas. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, this analog switch is mounted. 2:1 is the ratio between multiplexers and demultiplexers. An extended operating temperature of degrees Celsius. There are 6 terminations totally. This electronic part offers high-quality output due to its 1 channels. When the electronic component is given a voltage of 3V, it should be turned on and run. It is part of the design of the 6 series that this electronic component is included. The analog switch ics are built using SPDT switching circuits. Look for analog switch ic variants by searching with ADG779. There is 5Ohm internal resistance in this digital multiplexer. You can find the functions of the 6 pins in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. Single supply type digital switch with a low cost. It is recommended to use 1.8V as the lowest voltage for the electrical part. 1nA current would be enough for this multiplexer to operate. This analogue multiplexer requires a voltage of 1.8V~5.5V when it drains from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1 A. The 1 inputs need to be operated in order to work. In 200MHz-bandwidths, data can be transferred. The Drain to Source resistance of this electronic component is 5Ohm. A analog switch ics with 2 outputs is included.
