E2000 Series Access Controllers fits any type of installations, up to 20,000 users, from single buildings to multiple sites spread over remote locations and linked via RS485, RS232 or TCP/IP.
The user-friendly Access software programs the system within a few minutes, from a non-dedicated PC. Access Software provides numerous access control and alarm monitoring features: expiry date for clubs, automatic activation, interlock between two doors, time zones, supervision, anti-pass back, activity reports...
Each alarm input is programmable: operating mode (NO or NC), time zones, local reflex (activation of outputs according to input status). Specific alarms are triggered according to the number of unsuccessful attempts, the time limit for door closing (door alarm), the duress code...
Whenever required, the data stored in the controllers is transferred to the computer and activity reports are printed. Each controller works independently and keeps its own database.
Installation
The installation is set up within a few minutes.
In case of power off, the back-up battery (up to 12V- 17 A/h) ensures numerous hours of full autonomy.
Visual LEDS indicate the inputs, outputs and communication status.
Features
Board dimension
160*106 mm
160*106 mm
218*106 mm
Door control
one door
tow doors
four doors
Communication
Protocol
RS232 RS485
TCP/IP
RS232 RS485
TCP/IP
RS232 RS485
TCP/IP
Number of readers
2 readers
4 readers
4 readers
Relay
1
2
4
Database Support
ACCESS
Baud Rate
9600 bps for RS232, 10/100M for TCP/IP
Operating Temperature
-40 - 70
Power Supply Input
12 VDC
Number of cards
20,000
Capacity of records
100,000
Operational humidity
0 to 95% RH
Working voltage
9.5 V to 14 VDC
Current consumption
Max. 100 mA
16.8*14.2*5.5
Carton:46.5*56*23cm
Ouzim BioEngine2 Biometric Fingerprint Access Control for security entrance solution Model: BioEngine2 Supports multiple authentication multifunction: fingerprint, passcode and cards. 1. 3,000 fingerprints +3,000 cards +3,000 passcode + 200,000 records 2. Support Mifare card 13.56 MHz +ID card 125KHZ 3. 360-degree rotation identification, high sensitive to identify. No need film cover on the sensor 4.
The Notifier NBG-12 Series Pull Station is a fire alarm initiation device that allows manual activation of the fire alarm system. It typically consists of a red or yellow manual-pull handle or lever, which when activated, sends a signal to the fire alarm control panel to initiate an alarm. The NBG-12 series is designed for use in fire alarm systems and is commonly used in commercial, industrial, and residential buildings. The product is known for its durability and reliability, and it meets industry standards for fire alarm systems.
Features: Durable stainless-steel case High reliablity and high security Quick response time
Features: Suitable for access control. High reliablity and high security. Quick response Wide color selection. Customize serial number per your requirement. Read only, otp, programable. Specifications: Card read distance: 0-10 cm Chip: em4100, t5577 Working temperature: -10 ~ 70? Storge temperature:-20~80? Wide rel. Humdity range : 10 to 90 % Material: abs
It use to open the door. We have mutiple open door methods , like keypad pin code, fingerprint , face indentification models.
Access control systems Abu Dhabi. Biometric sensors, time attendance machine, fingerprint door lock, security access control. abudhabi,alain security
Breakthru Solutions is the leading access control management system dealer in Bangalore. We offer flexible fingerprint door lock, visitor management system, card access control security system for corporate and organization in Bangalore.
QuadXs2c is one of the most successful controller presently available in the market. Client includes large corporates like firstsource, Ranbaxy, Myntra and many more. This is one of the most flexible hard ware with 4 completely configurable outputs and 8 General purpose inputs. Further integration with fire is possible very smoothly. It supports weigand / HID based readers Features: 4 door / 8 reader Controller Supports access control of up to 4 doors in all respect including 4 entry readers, 4 exit readers, 4 locks, 4 exit switches etc Multiple RFID Technologies Supports all latest RFID technologies with inbuilt EM reader and option of having Mifare/HID iClass/ HID Pros. Network interface Leveraging on the merits of IP based systems, it can easily be hooked up on the existing TCR/IP network. Thus the data can be transferred instantaneously in real time mode to a centralized server. Field Upgradable Firmware Facility to onsite upgrade the firmware over Ethernet interlace so that any customisation or new version can be easily upgraded without any need of removing the device or physical presence of the engineer near the device Protected Enclosures Both controller & power supply unit are protected with suitable housing so electronic circuit boards are not exposed to cause any accidental damage. Anti Pass Back Door wise antipassback. Entry to the particular door is allowed only when the employee has exited through the same door. Door Interlocking Facility of door interlocking is available. The system allows creating a group of doors such that access to a door .thin the group is allowed only when all the other doors are in closed condition. Excellent Price Performance Ratio With a lower price to performance ratio ROI is automatically enhanced, the factor contributing to higher ROI is not only very competitive pricing but also higher accuracy rate offered by the product Fully configurable GPI and GPO Optically Isolated inputs for 4 Door Sensor, 4 Exit Switch & 8 General purpose digital inputs along with 4 General purpose relay outputs. These are fully configurable. For more feel free to reach out to us in case any clarification is required. Resilient Technologies M. No. - +91 9810995267 Visit on: www.resilienttec.com Corporate office: 578 | UdyogVihar Phase V | Gurgaon – 122001 Branch office: 465 | Pocket E-16 | Rohini | New Delhi – 110085
Two Door / Four Reader Controller TwinXs 3S is a versatile access control panel and supports 2 doors and 4 access readers. The controller can be configured as standalone / Master or Slave. The controller supports host of other rule based features apart from global anti pass back. High Speed Controller with Large Memory The controller has high speed 32 bit processor and has a large storage of 4GB. It has a capacity to store 200000 card holder database and last 500000 event buffer. The high speed processor facilitates access decisions in milliseconds. Local Programming The controller has LCD display and a 12 key keypad. This interface allows use to even program the controller without attaching it to the host computer. Also it facilitates on field diagnostics. Compact Design The controller size is very compact with respect to the number of interfaces. Also it has field pluggable connectors which helps in ease of wiring and termination. The controller is housed in powder coated MS cabinet along with rugged 5 amp power supply. All the reader ports are current limited there by ensuring that the controller doesn’t go down even when any of the port is sorted or malfunctioning. Data Communication and Protocols The controller supports popular communication interfaces viz 10/100 mbps ethernet, CAN and RS485. Master/Slave configuration can be implemented over any of these interfaces. In addition, it supports multiple protocols such as HTTP, SNMP, SMTP, FTP, SSL & NTP. It also supports MODBUS protocol over ethernet for integration. Fully Programmable I/O’s The controller has 8 optically isolated digital inputs out of which 4 are general purpose fully programmable, 2 dedicated for door sensor inputs, and 2 dedicated for egress switch inputs. Also the controller has 4 general purpose outputs apart from lock control outputs. The general purpose outputs are available as potential free contacts. Configurable Reader Interface The reader interface is configurable. The controller also supports legacy clock/ data interface in addition to more popular weigand interface. The weigand interface is configurable from 24 to 64 bits. Field Upgradable Software Facility to onsite update device software through ethernet interface. The product updates can easily be applied without the need of removing device and sending it back to the service center. For more feel free to reach out to us in case any clarification is required. Resilient Technologies M. No. - +91 9810995267 Visit on: www.resilienttec.com Corporate office: 578 | UdyogVihar Phase V | Gurgaon – 122001 Branch office: 465 | Pocket E-16 | Rohini | New Delhi – 110085