3+1 Cctv Cable

CCTV Cables are offered in two types namely 4+1 CCTV Cable and 3+1 CCTV Cable. Coaxial cables form the carrier for video signal and the other 4 cores or 3 cores form the carriers for power. Coaxial cables are designed to transmit the complete video frequency range with minimum distortion or attenuation, making them an excellent choice for CCTV.

CCTV cables are designed to optimize the quality of video signals, which are transmitted through the Coaxial cable in the CCTV cable. The Coaxial cable consists of solid annealed bare copper conductor of electrolytic grade which is insulated with foamed dielectric, aluminium foil taped, jelly flooded, braided with AI. Alloy and then jacketed with UV PVC. Topmost quality of construction of coaxial cable in CCTV cables ensures distortion free video signals and thus a clear picture over complete low frequency bandwidth of transmission in such applications. The impedance of coaxial cable is 75, which matches the CCTV equipment.

This matching ensures adequate signal strength, no reflection and best picture quality. In CCTV the coaxial cable is of type RG-59 which has highest attenuation compared to RG-6 and RG-11. Hence, it is recommended for use only for distances up to 300ft. Foamed dielectric delivers excellent electrical properties such as low capacitance and high velocity of propagation. This results in low-loss characteristics and reduced attenuation of the video signal. Aluminium foil and AI. Alloy branding of 60% coverage ensures complete elimination of MEI/RFI from the video signals and also provides a reduces DC resistance ground path. Jacketing with UV PVC is ideal for all indoor and outdoor applications.

They are used in short-distance video, audio and signal transmission in closed circuit tv and camera systems.
These types of cables are produced in different cross sections according to their intended use.

All Types Of LV and MV Power Cables , LSFH, SOLAR, Instrument and Special Cables
COOPER Rod 8 mm and Copper Wire
PVC COMPOUNDS

3+1 Cables

SFEX CT Manteau, also called the Cable Tray Manteau, is very efficient in extinguishing the initial fire suppression with immediate responses in case of fire because when a micro capsule for fire extinguishing reacts to a certain temperature and flame, it automatically disperses extinguishing agents.
It\'s based on a cooling fire extinguishing method, shows an excellent characteristic of being able to extinguish a fire completely with an immediate response at the time of initial fire if you cover it over the electric power line.


SFEX Solution : SFEX CT Manteau / SFEX AP Tape
1. Horizontal Section Fire : Access Floor, Cable Pit, and Cable Tray
Installation and How It Works
1. Cover the SFEX CT Manteau.


2. Prevent the spread of fire with extinguishing/flame retardance properties


2. Vertical Section Fire
Installation and How It Works
1. Wind the SFEX AP Tape on the cable.


2. Prevent the spread of fire with extinguishing/flame spread prevention properties
Test Result : AP Tape


Test Item
Test Standard
Unit
Test Result


Flame test of vertically placed cables
The carbonization length should not exceed 2.5mm from the bottom edge of the burner
-
Do not exceed (carbonization length: 0.6m)


During installation, photograph after installation
*Test Information

Test Facility Standard : KS C IEC 60332-3-10 : 2003(Compliant)
Volume of nonmetallic material(L) per meter of test specimen : 1.5 (volume of nonmetallic material for finished cable, not including AP Tape)
Number of test pieces : 5
Number of tiers : 1
Number of burners : 1
Position of test piece : Spatial type
Flame application time (minutes) : 20
AP Tape installation method : AP Tape in 0.6/1 kV TFR-CV 4C 35 from the height of burner to the top 10cm gap between AP Tape and 20cm length of AP Tape

PE coil pipes and tubes for water and wire cable conduit PL231


The PE coil pipes and tubes can be used:

water pipe 4 â?? 6 â?? 1-inch black coil with pressure 1.6mpa, OD 20-75mm, WT 2.3-6.8mm
pe conduit cable embedded wire cable and optical cable, OD 20-200mm, WT 1.8-3.5mm
weak current protection tube and communication tube, OD 20-200mm, WT 1.8-3.5mm


We use new 100% pure raw PE material


WHY NEW MATERIAL HDPE PIPES?

1. Health performance

PE pipe processing without adding heavy metal salt stabilizer, no scaling layer, and no bacteria.

2. Corrosion resistance

It can resist various chemical media erosion, with no electrochemical corrosion.

3. Service life

Under rated temperature and pressure conditions, PE pipes can be used for more than 50 years.

4. Impact resistance

PE pipe toughness, high impact strength, heavy objects directly pressed through the pipeline will not break.

5. Connection performance

The strength of the hot melt or electric melt interface of the polyethylene HDPE pipe is higher than that of the pipe body, and the joint will not be broken due to soil movement or live load.

6. Construction performance

It has a lightweight pipe weight, a simple welding process, convenient construction, and a low overall project cost.

High Quality & Reliable
Transmission of Voice, Video & Data.
Highly Shock Proof & Durable.
Product Range : CCTV3+1, CCTV4+1
Conductor : Flexible Bare Copper