Air Pre Heaters For Boilers And Heaters

This is basically A heat transfer equipment to heat air prior to entering in the furnace with a primary object to increase thermal efficiency of hot flue gases are passed through the tubes and air outside the tubes. The heat of the boiler flue gas is recovered in APH to increase the air temperature & the thermal efficiency is increased. Another advantage is that the flue gas is sent to chimney stack at lower temperature allowing simplified design of ducting & flue gas stack. It also allow controls the temperature of flue gas leaving the stack to meet emissions regulation / pollution control. Salient Features: Easy installation Low maintenance cost Robust construction Compact High efficiency

1. Enamel air pre-heater designed for denitration renovation projects 2. Enamel air pre-heater for circulating fluidized bed boiler and pulverized coal boiler 3. Enameled air pre-heater for garbage incinerators and biomass boilers 4. Enameled air preheater for grate furnaces, like chain grate furnaces 5. Enameled air preheater for gas-fueled boilers, such as kerosene boilers, coke ovens, etc.

Product Introduction The rotating-plate design (RAPH) consists of a central rotating-plate element installed within a casing that is divided into two (bi-sector type), three (tri-sector type) or four (quad-sector type) sectors containing seals around the element. The seals allow the element to rotate through all the sectors, but keep gas leakage between sectors to a minimum while providing separate gas air and flue gas paths through each sector. Tri-sector types are the most common in modern power generation facilities. In the tri-sector design, the largest sector (usually spanning about half the cross-section of the casing) is connected to the boiler hot gas outlet. The hot exhaust gas flows over the central element, transferring some of its heat to the element, and is then ducted away for further treatment in dust collectors and other equipment before being expelled from the flue gas stack. The second, smaller sector, is fed with ambient air by a fan, which passes over the heated element as it rotates into the sector, and is heated before being carried to the boiler furnace for combustion. The third sector is the smallest one and it heats air which is routed into the pulverizers and used to carry the coal-air mixture to coal boiler burners. Thus, the total air heated in the RAPH provides: heating air to remove the moisture from the pulverised coal dust, carrier air for transporting the pulverised coal to the boiler burners and the primary air for combustion. Our company and qualification Shandong HengTao Energy Saving and Environment Protection Co., Ltd. is a national comprehensive enterprise which is specialize in the R&D, manufacture, installation, energy saving & renovation of waste heat boiler, power station boiler and in forging, heating power support and automobile service. Our company has Grade A boiler manufacture qualification and Grade 2 pressure vessel manufacture qualification. Our main products are specialized in all kinds of boilers and boiler parts which included power station boiler, waste heat boiler, air preheater, membrane water wall and superheater. We are committed to creating the best solution provider for boiler integrated energy-saving technology transformation, and we will strive for it continually.

Gas train for boilers and heaters