Jet A-1 fuel is a kerosene-based aviation turbine fuel used in commercial and military aircraft. It has a minimum flash point of 38C and a maximum freezing point of -47C, ensuring safety and performance at high altitudes. It meets international standards like ASTM D1655 and DEF STAN 91-091, with additives to enhance stability, conductivity, and corrosion resistance.
EN590 diesel fuel is a low-sulfur automotive diesel that meets European standards for use in diesel engines. It has a cetane number of at least 51, a sulfur content below 10 ppm, and a flash point above 55C, ensuring efficient combustion and reduced emissions. EN590 complies with Euro 5 and Euro 6 regulations, optimizing fuel economy and engine performance while minimizing environmental impact.
D6 fuel oil, also known as Residual Fuel Oil or Bunker Fuel, is a heavy, high-viscosity petroleum product used primarily in industrial boilers, power plants, and large marine engines. It has a high sulfur content (up to 3.5%) and requires preheating for proper combustion due to its thick consistency. D6 is less refined than diesel and jet fuels, making it a low-cost, high-energy fuel suited for large-scale applications.
D2 diesel fuel is a mid-distillate petroleum product used in diesel engines, meeting ISO 8217 and ASTM D975 standards. It has a cetane number of at least 51, a sulfur content of up to 500 ppm (Low Sulfur) or 10 ppm (Ultra-Low Sulfur - ULSD), and a flash point above 52�°C, ensuring efficient combustion and reduced emissions. D2 is widely used in transportation, agriculture, and industrial applications due to its reliability and energy efficiency.
We supply high-quality petroleum products from trusted Middle Eastern, European, and Turkish producers, ensuring compliance with international standards. Important Notice: Due to widespread fraud in the oil industry, our procedures are non-negotiable. No upfront payment is required. TTM (Table-Top Meeting) can be arranged before LC for qualified buyers with ICPO + POF. Key Products & Origins: Diesel (D2, D6) Origin: Middle East EN590 Origin: Italy, Europe, Turkiye, Middle East Jet Fuel (Jet A1) Origin: Middle East Our UAE office is a licensed petroleum exporter, ensuring seamless transactions and full regulatory compliance. Sales & Purchase Procedure: Request: Buyer submits Letter of Interest + Proof of Funds (POF) (Bank Statement, BCL, etc.). Introduction: Seller verifies the buyer and conducts an introductory call. Capability Assessment: Seller assesses the buyer's financial capacity. Corporate Offer: Seller issues a Formal Corporate Offer (FCO) with prices, volume, and terms. Sales Agreement: Buyer & Seller finalize a Sales & Purchase Agreement (SPA). The seller also issues an MFPA (Master Fee Protection Agreement) for agents/mandates. Banking & Collateral: Buyer submits SBLC MT760, and Seller provides a 2% Performance Bond. Loading & Documentation: Seller loads the vessel at their own cost and issues delivery documents (B/L, Ullage Report, COO, Q88, etc.). Delivery & Payment: Buyer conducts a Dip Test, completes an MT103 wire transfer, and receives Title of Ownership upon payment. We ensure reliable supply, competitive pricing, and seamless transactions for our global buyers.
We are a direct mandate to reputable refineries in Qatar, Kazakhstan, USA. for the supply of petroleum and gas products. We are a company that has brought ingenious buyers to refineries, transacting with a standard specification and international trading procedures. At this moment we are glad to inform you that on behalf of our highly esteemed refineries, We are here to take away your stress of recent market. Kindly reach out to us for more enquiries; AVILABLE PRODUCTS: LIGHT CYCLE OIL, DIESEL EN590,EURO 6 (10PPM), GAS OIL D2 L0, 2-62, VIRGIN FUEL OIL D6,AVIATION KEROSENE GRADE 54, JET FUEL A1, LPG - LIQUEFIED PETROLEUM GAS, LNG â??LIQUEFIED NATURAL GAS, MAZUT M100, CRUDE OIL REBCO, EAST SIBERIAN PACIFIC BASIN CRUDE OIL (ESPO), PETROLEUM COKE, GRANULAR UREA 46%.
TTT procedure: EN590 10pm price $460/MT, Jet fuel A1 price $76/BBL (1) FREE ON-BOARD TRANSACTION PROCEDURE - (TANK TO TANK). Rotterdam, Houston, Fujairah, Jurong, Ningbo-Zhoushan 1. Buyer issues an official ICPO with the seller's procedure, passport copy, banking details along with their Tank Storage Agreement "TSA". 2. Seller issues their Commercial Invoice "CI" to the buyer, Buyer signs and returns the commercial invoice to the seller along with an Acceptance Letter of the sales and purchase procedure. 3. Seller verifies the buyer's storage facility and their Tank Storage Agreement (TSA) with the port authority. (NB: Seller will issue a Tank-to-Tank Injection Agreement (TTIA) to be signed by all parties only if buyer's TSA is engaged, not active or cannot be verified with the local port authority). 4. Seller issues all POP documents below to the buyer upon a successful verification and approval of the buyer TSA or after receiving the TTIA fully signed by all parties: a. Injection Report. b. Product Passport. c. 24 Hours SGS Report. d. Product Certificate of Origin. e. Tank Storage Receipt (TSR). f. Authorization to sell and collect. g. Unconditional Dip-Test Authorization. h. Product Title Holder Transfer Agreement. i. NCNDA/IMFPA. 5. If required buyer may inspect by SGS (Dip Test In Tanks) at buyer's expense. 6. Upon successful verification of POP or Dip Test in the seller's tank, buyer provides Tank Storage Receipt (TSR) to seller in order to issue the scheduled Injection Programming (IP) to be signed by buyer storage facility and then injects the product into buyer's tanks. 7. Buyer makes the payment for the product via MT103, seller transfers the Title Holder & Ownership of the product to the Buyer. 8. After successful Trial Lift (First Lift), Seller issues SPA/Contract for 12 months with R&E to Buyer for processing. 9. Seller pays commissions to all intermediaries involved, for the initial lift and all subsequent lifts according to the signed NCNDA/IMFPA.
Supplier: Crude oil/petroleum products, crude oil/petroleum products e.g a1 jet fuel, en590 d2, d6 , crayfish, charcoal, sugar , heavy equipment for agriculture, minning, drilling, waste management, telecommunications new or used tractors.t.c
Services: Facilitate business between buyers and sellers, mostly crude oil/petroleum products e.g a1 jet fuel, en590 d2, d6, heavy equipment for agriculture, minning, drilling, waste management, telecommunications new or used tractors.t.c
We have direct contacts with several refineries and can therefore offer any type of fuel..( Jet Fuel , D6 ,EN590 ..etc..) at good market prices. If you have any questions, please contact me via Whatsapp or by mail. NON-Russia..
Available stock in Rotterdam tank farm for jet fuel A1: CI DIP AND PAY FOB PROCEDURE 1. Buyer sends ICPO, Company Profile along with current and valid TSA company registration certificate+ buyer passport number + company profile to seller on receipt of seller's soft corporate offer. 2. Seller issues commercial invoice of the product in tanks at the port of Rotterdam and returns commercial invoice. 3.seller will provide the Proof of Product (PPOP) documents for product verification Which include Tank Storage Receipt (TSR) Certificate of origin Statement of Product Availability, Authorization to Verify (ATV), and Dip Test Authorization (DTA) Letter. 4.After successful verification of the PPOP, the buyer will contact the seller's Tank Storage Company to request a 1-day payment invoice to enable Buyer obtain all the necessary authorization and clearance for a Dip Test schedule. *Or* Buyer must have a minimum of 10 days TSR to avoid one day tank extension. 5.Upon a successful Dip Test conducted in the seller's tanks, the buyer will make the payment for the total product cost based on the SGS Report via MT103. The seller will transfer title ownership to the buyer and send all exportation documents. The buyer can then either transfer the product into a vessel or take over the seller's tanks for further storage. 6. Upon a successful Dip Test conducted in the seller's tanks, the buyer will make the payment for the total product cost based on the SGS Report via MT103. The seller will transfer title ownership to the buyer and send all exportation documents. The buyer can then either transfer the product into a vessel or take over the seller's tanks for further storage. 7. All intermediaries involved in the transaction will sign a Non- Circumvention, Non-Disclosure Agreement (NCNDA) and International Master Fee Protection Agreement (IMFPA). These documents will be forwarded to the seller for endorsement, and the seller will provide the Endorsed NCNDA/IMFPA and Authorization to Sell and Collect (ATSC).
We're a UK based company.. We presenting a Genuine SELLER / TITLE HOLDER who can supply Jet A1 Fuel, ULSD Diesel EN590, Unleaded Gasoline and Fuel Oil (CST 180/380) ..... ORIGIN: EUROPEAN .... Price: Platts minus 7% ... The Seller can supply as CIF, STS and Vessel Take Over. The Seller is The OWNER and the TITLE HOLDER ... SBLC MT760 is accepted as a guarantee only as NON-TRANSFERABLE, NON-OPERATIVE and is issued to the SELLER .. We're looking for RWA buyers... MOQ is 50,000 MT for EN590, FUEL OIL, and Gasoline, and 2M bbl for Jet A1 Fuel .... Contact: Usama
RUSSIAN & NON RUSSIAN ORIGINS ARE AVAILABLE AT THE BEST PRICES SUPPLY TRANSACTION: FOB & CIF & TTO PAYMENT TERM: SBCL/DLC/TT/ESCROW CONTACT JAY MOH
We can connect you with our friend end sellers/title holders to offer express work with petroleum products of Russian or non-Russian origin, where they can provide reliable and serious offers. Please contact us only if you are the real end buyer or his direct mandate. The products list: - Diesel EN590 - JET FUEL A1, JP 54 - VIRGIN D6 FUEL OIL - LPG, LNG - AGO Automotive Gas Oil - Gasoline Octane 72, 76, 91, 93, 95
