SL- 450 Front and Side View Sealinkers Clamps Each clamps has a product Identification Code for Material traceability, the name Sealinkers or SL, and a size forged into it. Entire Clamps are galvanized / Powder Coated to resist corrosive and rusting action. Only Genuine SL Clamps have a Yellow colour for instant recognition. All Clamps have rolled threads and extra heavy nuts. Rope Size Dimensions (mm) Min No. of Clamps Amt. of Rope to Turn Back in (cm)P (in.) (mm) A B C D E F G H 3/8 9-10 11.2 38.1 19.1 25.4 23.1 19.2 41.4 49.3 2 16.5 1/2 13 12.7 47.8 25.4 30.2 28.7 22.4 48.5 58.0 3 29.2 5/8 16 14.2 60.5 31.8 33.3 34.0 23.9 52.5 63.5 3 30.5 5/4 18-20 15.8 70.0 36.6 38.1 35.8 26.9 57.0 72.0 4 46 7/8 22 19.1 79.5 41.2 44.5 40.4 31.8 62.0 80.5 4 48 1 24-26 19.1 89.0 46.0 47.8 45.2 31.8 67.0 88.0 5 66 1 1/8 28-30 19.1 98.5 51.0 51.0 48.5 31.8 71.5 91.0 6 86 1 1/4 32-34 22.4 108 45.0 58.5 55.5 36.6 79.5 105 7 112 1 3/8 36 22.4 118 58.5 60.5 58.5 36.6 79.5 106 7 112 1 1/2 38-40 22.4 125 60.5 65.5 62.0 36.6 86.5 113 8 137 1 3/4 44-46 28.7 146 70.0 77.5 74.5 46.0 97.0 134 8 155 2 48-52 31.8 164 76.0 86.0 83.5 51.0 113 149 8 180 Note Refer to table I in following these instructions. Turn back specified amount of rope from thimble or loop. Apply first clip one base width from dead end of rope. Apply U-Bolt over dead end of wire rope - live end rests in saddle (Never Saddle a dead horse!).Tighten nuts evenly, alternate from one nut to the other until reaching the recommended torque.